Life Fitness GPS Receiver TR9100 User Manual

Life Fitness Model TR9700, TR9500, TR9100 Treadmills  
How To...Replace or Install Rear Roller Guards  
Tools Required: Philips Screwdriver  
NOTE: The following steps are applicable to units with Configuration No. 1, Rear Roller Guards.  
1. Remove the Screws securing the Rear Roller Guard Assembly to the Frame.  
Screw  
Cover Guard  
Grommet  
Roller Guard, RT  
Roller Guard, LT  
Grommet  
Screw  
Configuration No. 1  
2. Remove the old Grommets from the Rear Roller Welded Guard Tab and Base Frame (model  
specific).  
3. Install the new Grommets (included in kit) in the Rear Roller Guard Weldment and Base Frame  
locations.  
4. Place new Roller Guard in position as shown with the top surface under walking belt. Align mounting  
holes.  
Roller Guard to be  
Align mounting holes  
located between belt  
with grommet holes  
and deck  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Life Fitness Model 97Ti, 95Ti, 93T Treadmills  
How To...Replace or Install Rear Roller Guards  
Tools Required: Philips Screwdriver, Flat Blade Screwdriver  
NOTE: The following steps are applicable to units with Configuration No. 2, Rear Roller Guards.  
1. Remove existing Roller Guard by unscrewing mounting screws on top and base of frame.  
Mounting  
Screws  
2. With flat blade screwdriver, remove Grommet and Washer, discard old washer and re-install the  
grommet. Use caution to prevent injury or damage to paint.  
NOTE: Do not replace washer. Having a washer and the grommet will raise the guard too high  
and cause rubbing against the belt resulting in premature wear and reducing belt life.  
3. Remove the Base’s Lower Head Grommet for the base bottom hole and move to the upper hole in  
the Base Frame.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Life Fitness Model 97Ti, 95Ti, 93T Treadmills  
How To...Replace or Install Rear Roller Guards (Continued)  
4. Place new Roller Guard in position shown with top surface under walking belt. Align mounting holes.  
Roller Guard to be  
located between belt  
and deck  
Align mounting holes  
with grommet holes  
5. Install Screws and fasten securely. Approx. 22-37 in/lbs.  
6. Repeat steps for opposite side. After completion run treadmill and check for interference or binding. If  
needed loosen Mounting Screws, re-align Guard, and refasten securely.  
Secure Mounting  
Screws  
M051-00K58-A128  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Lennox Hearth Gas Heater L20 BF 2 User Manual
Lightolier Indoor Furnishings 1000LVRE1 User Manual
Magnavox Clock Radio AJ3930 User Manual
Magnavox Flat Panel Television 42MF7000 User Manual
Manitowoc Ice Ice Maker K00385 User Manual
Meridian America Portable Speaker A200Z User Manual
Metra Electronics Automobile 99 7579 User Manual
Metra Electronics Car Stereo System 99 8711 User Manual
Metrologic Instruments Scanner MS700i User Manual
Middleby Marshall Oven SPL092606 PF BD User Manual