Life Fitness LCD Entertainment System
How To Program TV Consoles
Special service tools required: none
Programmer
Description: Procedures for programming a.)
EZ consoles (on this page) and b.) TV consoles
with remote control units (on page 2).
Battery Compartment Cover
9-volt Battery
Connector
Kit Contents: Programming device and cable
(see illustration). A 9-volt battery (not
supplied) is required to reprogram the TV
console.
9-volt Battery
Procedure: In both procedures, the TV
console stays mounted and the power and
coax cables stay plugged in (see illustration).
C-SAFE Cord
C-SAFE Connector
Tto console
To program the TV on EZ console products:
1. Remove the EZ console cable from the
black 8-pin connector on the back of
the console.
2. Plug the C-SAFE cord into that 8-pin
connector.
3. Place the 9-volt battery in the
programmer.
Tto programmer
4. Plug the other end of the C-SAFE cord
into the programmer.
5. The programmer will give this
feedback that the updating procedure
is taking place:
a. The green LED will glow
steadily.
b. The yellow LED will then glow
steadily.
c. The yellow LED will then begin
flashing.
d. The console software has been
updated when the green LED
begins flashing slowly.
Coax
Cable
Power
Cable
6. Unplug the C-SAFE cord from the
programmer.
Ddo not use
7. Unplug the C-SAFE cord from the
console.
Black 8-Pin C-SAFE Connector
(for in-console control)
8. Reconnect the EZ console cable.
9. Verify that the console’s software
version matches the software version on the programmer. If the console version
number is still lower, repeat the procedure.
1
M051-00K32-A086
Download from Www.Somanuals.com. All Manuals Search And Download.
|