Lenovo Projector L1210E User Manual

Replacing the Lamp  
Slide lamp grill off  
!
Pull tab out  
Turn off the projector and unplug the power cord.  
Allow the projector to cool for at least 60 minutes.  
Place the projector rightside up on a flat  
surface. Pull the yellow tab on the lamp outward.  
This disengages the lamp connector.  
Slide and hold latch  
Place the projector on its rear. Insert a small screw-driver  
into the slot near the front. Slide the latch downward. Hold  
the latch open while you slide the lamp grill off.  
The projector  
must be  
as shown.  
Loosen the captive screw on the lamp.  
Place the projector on its side. Grasp the pull tab to  
pull the lamp out. Dispose of the lamp module in  
an environmentally proper manner.  
Place the projector on its side. Slide the lamp into  
the projector. Make sure that the bottom of the lamp  
fits into the rails inside the projector (circled above).  
9
Slide lamp grill on  
Slide the front grill toward the lens until it snaps into  
place. To reset the lamp timer, press and hold the  
reset button, then press the menu/select button  
(while still pressing the reset button) for 10 seconds.  
Gently press the lamp into place. Then tighten  
the screw.  
Gently press the yellow tab inward until it stops.  
You can feel the lamp connector engage.  
Download from Www.Somanuals.com. All Manuals Search And Download.  

LA Audio Electronic Microphone MS1224 User Manual
Lasko Musical Toy Instrument 2654 User Manual
Lennox Hearth Thermostat 50692101 User Manual
LG Electronics Microwave Oven LRM1260SB User Manual
Lindy Computer Hardware 51246 User Manual
Linksys Switch SRW2024P User Manual
Makita Trimmer JS1600 User Manual
Maytag Dishwasher W10300218A User Manual
Memorex CRT Television MT2024 User Manual
Meridian Audio MP3 Player P86017 User Manual