Lanier Worldwide, Inc.
2300 Parklake Dr., N. E.
Atlanta, GA 30345-2979
Emergency Telephone: (800)526-4371
MATERIAL SAFETY DATA SHEET
Section 1: Chemical Product and Company Information
Identity:
Product ID: 117-0237
MSDS No.
Issued: 01/05/98
Toner for 9060 POD
CP-312
Supersedes:
none
Synonyms
Date:
01/26/98
& Common Toner, Black Tonerer for Lanier
Names:
9060 POD
Prepared by:
Lanier QA/EH&S Department
Uses:
9060 POD
European
Contact:
Lanier Worldwide, WSM Europe,
Walter Fricke,
Im Taubental D-41468 Neuss,
Germany +49-2131-387-177
Chemical
Formula:
Mixture
Section 2: Composition / Information on Ingredients
PERCENT
CAS No.
1333-86-4
75214-60-7
EXPOSURE LIMITS
SOURCE
3.5mg/m3 3.5mg/m3
OSHA PEL ACGIH TLV
Carbon black
Polyester resin
Polyester resin
6 - 8
not listed
Trade Secret No.
80100252-5001-P
not listed
n/a
n/a
<94
TSCA Confidential
Wax
Pigment
9003-07-0
31714-55-3
n/a
n/a
not listed
*PEL as the product: 15mg/m3 (total dust), 5mg/m3 (respirable dust)
*TLV as the product: 10mg/m3 (total dust), 5mg/m3 (respirable dust)
Section 3: Hazards Identification
Hazard Rating:
FIRE = 1
HEALTH = 1
REACTIVITY = 0
SPECIAL = none
Health Hazards (Acute, Chronic, Immediate and Potential): Minimum irritation to respiratory tract may occur as with exposure to any
non-toxic dust. May cause gasping if inhaled. Inhalation should be avoided. May cause temporary eye discomfort.
Health Hazards of Long Term exposure (Chronic): A manufacturer sponsored chronic inhalation study in rats using a special test
toner revealed there were no lung changes at all in the lowest exposure level (1mg/m3), the most relevant level to potential human
exposures. A very slight degree of fibrosis was noted in 25% of the animals at the middle exposure level (4mg/m3), while a slight
degree of fibrosis was observed at the highest exposure level (16mg/m3) in all animals. These findings are attributed to “Lung
Overloading”, a generic response to excessive amount of any dust retained in the lungs for a prolonged interval. The special test
toner was ten times more respirable than commercially available toner to comply with EPA testing protocol and would not function
properly in Xerographic equipment.
Section 4: First Aid Measures
Remove to fresh air if effects occur. Consult
local medical personnel
Inhalation:
Eye Contact: In case of contact, immediately flush eyes with
water for 5 minutes.
Ingestion: Dilute stomach contents with water. Call a
physician
Skin Contact:
Wash with soap and water.
Section 5: Fire Fighting Measures
Suitable extinguishing media: CO2, dry chemical, foam or water.
Extinguishing media which may not be used for safety reasons: none
1
Download from Www.Somanuals.com. All Manuals Search And Download.
|