IS76PRO
TM
MediaWire
PRO
Owner’s Manual
A/V CABLE WITH REMOTE
wireless remote
FOR YOUR iPod, iPhone, OR iPad
MAKE THE CONNECTION
to your
iPod
remote holder
to your
iPhone
to your
iPad
audio / video output
iSimple®
connection for iPod, iPhone, or iPad
Video not intended to be in view of driver
2010
REG. 09-07-10
Download from Www.Somanuals.com. All Manuals Search And Download.
Removing wireless Remote from the Mounting Cradle: To remove
the wireless remote from the mounting cradle, push upwards gently on the remote
by placing your finger inside the recess on the side of the mounting cradle.
4. Remote Control
Battery installation
Before using your remote control with your device, Please
first install the CR2025 Battery (included) into the remote as
shown.
+
Operation
The wireless remote control is designed to give you access to your iPod, iPhone, or iPad music library
without handling your device. The remote will provide such controls as: track forward, and track back,
as well as navigation through the iPod menus.
1) MENU same function as Menu on clickwheel
MENU
1
2) moves the cursor up in iPod, iPhone,
or iPad Menu
2
3) moves the cursor down in iPod,
iPhone, or iPad Menu
4)
5)
next track (press)
fast forward (hold)
5
6
4
3
previous track (press)
rewind (hold)
7
6)
7)
Enter / select option
Toggles Play / pause
The RF receiver is built into the iSimple cable. So it is installed automatically when you connect power
and ground from the vehicle, to this iSimple cable.
5. Troubleshooting
Symptom
Cause
Remedy
Check the fuse on the MediaWire™PRO. If the fuse is blown,
replace with a fuse of the same amperage. If fuse blows again,
please call tech support.
iPod, iPhone, or
Fuse is blown
iPad is not charging
iPod, iPhone, or
Check the Power (RED) and Ground (BLACK) wires to ensure that
they are correctly connected to 12V+ and Ground.
Weak wiring connection
iPad is not charging
and fuse isn’t blown
iPod, iPhone, or iPad is
not set for video out
No video
No audio
In settings menu select Video Output ON.
Verify connection of RCA’s to Receiver.
RCA is not connected
Battery Issue
Check that battery is installed correctly,
and does not need to be replaced
Remote does not
control iPod, iPhone,
or iPad
Re-route cable so that RF receiver is closer to front of dash (less
Transmission Interference obstructions)
3
Download from Www.Somanuals.com. All Manuals Search And Download.
6. Warranty
One Year Limited Warranty
The quality controls used in the manufacture of this product will ensure your satisfaction. This warranty applies only
to the original purchaser of this product from an authorized iSimple® dealer. This warranty covers any supplied or
manufactured parts of this product that, upon inspection by iSimple® authorized personnel, is found to have failed in
normaluseduetodefectsinmaterialorworkmanship.Thiswarrantydoesnotapplytoinstallationexpenses.Attempting
to service or modify this unit, operating this unit under conditions other than the recommended voltage will render this
WARRANTY VOID.
Unless otherwise prescribed by law, iSimple® shall not be liable for any personal injury, property damage and
or any incidental or consequential damages of any kind (including water damage) resulting from malfunctions,
defects, misuse, improper installation or alteration of this product. All parts of this iSimple® product are guaranteed
for a period of 1 year as follows:
Within the first 12 months from date of purchase, subject to the conditions above, iSimple® will repair or replace
the product at our discretion, if it is defective in material or workmanship providing it is returned to an Authorized
iSimpleTM dealer, with PROOF OF PURCHASE from an authorized iSimple® dealer.
Warning:
This equipment may be reset by unintentional electrostatic discharge during operation. Exposure to direct sunlight or
extreme heat may cause damage or malfunction.
FCC Class B Radio Frequency Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of FCC rules. These limits are designed to provide reasonable protection against harmful interfer-
ence in a residential installation. This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
1. Re-orientate or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from
that of which the receiver is connected.
4. Consult the dealer or an experienced radio / television technical for help.
Notice : The changes or modifications not expressly approved by the party responsible for compliance could void the
user authority to operate the equipment.
A division of AAMP of America™
13190 56th Court Clearwater
Florida 33760
For Best Performance Have It
Ph. 866-788-4237
Professionally Installed.
©2010 AAMP of Florida, Inc.
“Made for iPod,” “Made for iPhone,” and “Made for iPad” mean that an electronic accessory has been designed to connect
specifically to iPod, iPhone, or iPad, respectively, and has been certified by the developer to meet Apple performance
standards. Apple is not responsible for the operation of this device or its compliance with safety and regulatory standards.
Please note that the use of this accessory with iPod, iPhone, or iPad may affect wireless performance.
iPhone, iPod, iPod classic, iPod nano, and iPod touch are trademarks of Apple Inc., registered in the U.S. and other
countries. iPad is a trademark of Apple Inc.
Download from Www.Somanuals.com. All Manuals Search And Download.
|