Kompernass Indoor Fireplace KH 1117 User Manual

Operating Instructions  
Electric fire KH 1117  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Safety information  
ƽ Risk of injury or burning  
• Never insert objects or body parts such as fingers  
inside the chimney through the iron rods.  
• Never allow children to use the chimney without the  
supervision of an adult. Explain to children the dan-  
gers of the appliance.  
ƽ Danger of electrocution!  
• Connect the appliance only to a 50 Hz grounded  
power socket with mains voltage of 230 V~ and that  
has been installed according to instructions.  
• Do not bend or squeeze the power cord.  
To disconnect, always pull out the plug at the power  
socket, do not pull on the power cord.  
• The chimney heats up when in operation. Therefore,  
never carry it when hot and do so only by the handle  
provided for this purpose  
• Never touch the chimney, power cord and power plug  
with wet hands.  
• Lay the power cord such that no one treads or trips  
over it.  
• Do not use extension cables.  
• Do not wind the power cord around the casing of the  
chimney.  
Intended Use  
• Unplug your chimney immediately after use. The  
power plug is completely free of power supply only  
when you pull it out of the power socket.  
• Do not immerse the chimney in liquids under any  
circumstances and do not allow any liquids to enter  
the device casing of the chimney. Do not expose the  
appliance to humidity and do not use it outdoors.  
There exists the danger of electrocution. However, if  
liquid does enter the device casing, pull out the plug  
of the appliance from the power socket and have it  
repaired by a qualified technician.  
The chimney is used for decorating ad heating living  
rooms.  
This chimney is exclusively meant for household use  
and may be used only for this purpose. Observance of  
all the information in these operating instructions, espe-  
cially the safety instructions is also from this point of  
view.  
This chimney is not intended for commercial or industri-  
al use.  
• Never us the chimney in proximity of water or in  
damp cellar areas. The proximity to water presents a  
danger, even if the chimney is switched off.  
• In case of a breakdown and before cleaning the  
chimney, pull out the power plug from power socket.  
• If the power cord is damaged, have the chimney  
repaired by a qualified technician, before you use it  
again.  
Description of the appliance  
Function switch  
Thermostat  
Flame regulator  
Screws of the glass top  
Glowing embers  
• Do not operate the chimney, if it has fallen down or is  
damaged. Have the appliance checked or repaired by  
qualified technicians.  
Technical Data  
• Do not open or repair the device casing of the chim-  
ney. In such cases, safety shall not be guaranteed  
and the warranty shall expire. Allow only authorised  
technicians to repair the defects in the chimney.  
Rated voltage: ..........................................230 V / ~50 Hz  
Power rating: ..........................................Max. 1850 Watt  
Light bulb : ..................2 candle bulbs, E-14, max. 25 W  
ƽ Fire hazard!  
• Never place the chimney close to inflammable materi-  
als, liquids or gases. Leave at least a one meter  
space on all sides and on the top. Never place the  
chimney directly under a wall socket.  
Before the First Use  
Before starting up the appliance, make certain that ...  
the appliance or the accessories are in perfect condi-  
tion,  
• Do not cover the appliance when in operation. Clean  
it at regular intervals.  
all the packing material has been removed.  
• Never leave the chimney unsupervised when in  
operation.  
• Always place the chimney on an even base.  
Otherwise, the chimney could tip over and lead to a  
fire.  
• Never place the chimney close to heat sources, and  
protect the power cord from damages. Therefore, do  
not keep the power cord lying in front of the chimney.  
• Do not use the chimney with a time switch or a simi-  
lar appliance. In case of auto-start, there exists a fire  
hazard if the chimney is covered or has been set up  
incorrectly.  
5
Download from Www.Somanuals.com. All Manuals Search And Download.  
Operation  
Cleaning  
The chimney is operated by means of three switches:  
ƽ Danger of life-threatening electric shock:  
• Before you clean the chimney, pull out the plug  
from the power socket,  
Function switch:  
You can set the basic functions with the Function  
switch.  
Turn the Function switch step by step for  
the following settings:  
• and let it cool down completely.  
• Never immerse the chimney in water or other  
liquids for cleaning  
Clean the casing with a damp cloth.  
Clean the glass plates with a glass cleaner.  
Position  
0
Setting  
OFF  
Do not use cleansers or solvents. They can damage  
the plastic surfaces.  
only flames  
Ventilator without heating  
low heat emission (900 W)  
maximum heat emission (1850 W)  
Disposal  
Never dispose off the appliance with normal household  
waste.  
Thermostat:  
If you have selected a setting with heat emission  
through the Function switch you can control the  
room temperature with the thermostat .  
Enquire with your local town council or regional  
authority about the appropriate method of environment-  
friendly disposal.  
Turn the Thermostat to the "max“ position.  
As soon as the desire room temperature is reached...  
Turn the Thermostat back till you hear an audible  
click.  
The in-built thermostat now ensures a constant room  
temperature.  
Warranty & customer service  
The warranty conditions and service centre address  
can be found in the enclosed warranty slip.  
Flame regulator  
With the Flame regulator you can regulate the  
flame to any size.  
Turn the Flame regulator in the clock-wise  
direction until the desired flame size is obtained.  
Replacing the bulbs  
ƽ Danger of life-threatening electric shock:  
• Before you replace the bulbs, pull out the plug  
from the power socket,  
• and let it cool down completely.  
• Only use candle bulbs with an E-14 thread and  
max. 25 Watt  
Loosen both the screws with a slotted screwdriver.  
Carefully lift the glass top forward and put it down  
safely.  
Take out the glowing embers by pressing with both  
the hands and taking it forward.  
Now replace the bulbs.  
Reassemble the chimney in reverse order and fix the  
glass plate with the screws.  
6
Download from Www.Somanuals.com. All Manuals Search And Download.  
Kompernaß Handelsgesellschaft mbH · Burgstraße 21 · D-44867 Bochum  
ID-Nr.: KH1117-06/04 - V2  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Invacare Mobility Aid Power TigerTM User Manual
IOGear Computer Drive Q1338 User Manual
JL Audio Car Amplifier XD700 5 User Manual
JVC DVD Player LET0239 001A User Manual
JVC Projection Television SL42B C User Manual
JVC Satellite Radio TN User Manual
JVC Security Camera VN V686U User Manual
JVC Stereo System CA MXGT90 CA MXGT80 CA MXG70 User Manual
Kenwood Stereo Amplifier KA S10 User Manual
Kodak Photo Printer 400 III User Manual