Kodak 10/100 NIC Faceplate
Kodak 10/100 NIC Quick ConÞguration
Reference Guide
Kodak
10/100 NIC
D1 D2
NET
LNK
Applicable printers: Kodak XLS 8400PS, Kodak XLS 8600/8600PS, Kodak
Professional 8657, Kodak Digital ScienceTM 8650/8650 PS color printers,
Kodak Digital ScienceTM desktop color proofer 9000, and Kodak Digital
ScienceTM DCP 9300 proofer
Normal
Mode Switches: D1 and D2 are operation mode switches; they are shown in
Normal Operation Mode for printing (D1 & D2 Up).
LEDs: The GREEN LNK connectivity LED should come ON
when connected. The YELLOW NET Traffic LED should blink
intermittently as it detects traffic on the network. Both LEDs
should remain OFF if disconnected from the network.
Ethernet Address: A unique NIC Ethernet address is assigned to each NIC
(i.e. 0040C8 1234AB). The first six digits are always 00:40:C8. The last six
digits are unique to each NIC.
Network Broadcasts: The NIC uses its Ethernet address to advertise itself
on Macintosh via Appletalk and on Windows via NetBeui as “KDxxxxxx”
where “xxxxxx” are the last six digits of the address.
Kodak 10/100 User Guide References:
Ch1: Introduction/Config Overview Ch7: Windows NT 3.51
NIC Operating Mode Switches
Ch2: NIC Hardware Installation
Ch3: Windows - FastManage
Ch4: Novell Netware
Ch8: Windows NT 4.0
Ch9: Apple/Macintosh
Ch10: Unix
D1
Up
D2
Up
Mode
Description
Normal
Default. Does not allow a telnet connection.
Users can print to the unit.
Ch5: Windows for Workgroups
Ch6: Windows 95
Ch11: Printing
Up
Down Telnet
Allows a telnet connection to change its
Ch12: Troubleshooting
Diagnostic parameters. Users can also print.
Down Down Reset to
Defaults
This setting is used to reset the NIC to use
factory default configuration parameters.
Refer to Appendix C in the User Guide for
details.
Appendices:
A: Telnet Configuration Utilities
B: 3rd Party Network Applications and Utilities
C: Upgrading NIC Flash Firmware
D: 10/100 NIC Specifications
Down Up
Test Page A parameter test page is generated when
you power cycle the printer. Print jobs are
not accepted. NOTE:The printer must be in
PostScript mode. For raster-only printers,
obtain the parameters via a Telnet session.
E: Technical Assistance
Kodak p rinter and NIC documentation and software are available on the
Kodak Web site (www.kodak.com).
Power cycle the printer whenever you change switch settings. When finished
with configuration, return the switches to Normal mode, then power cycle the
printer again for normal printing operation.
Important: This 10/100 NIC is configured using remote, platform specific,
configuration utilities ONLY. Configuration parameters entered via the printer
front control panel and the corresponding printer front panel test print are not
applicable to this 10/100 NIC.
-4-
Part Number 1C9753
Download from Www.Somanuals.com. All Manuals Search And Download.
|