Kambrook - Australia
Kambrook - New Zealand
Building 2, Port Air Industrial Estate
1A Hale Street
Private Bag 94411
Botany, Manukau
Botany NSW 2019
Auckland 2163
New Zealand
Customer Service Line/
Spare Parts 0800 273 845
Customer Service Fax 0800 288 513
Australia
Customer Service Line 1300 139 798
Customer Service Fax 1800 621 337
Due to continual improvement in design or otherwise, the product you
purchase may differ slightly from the illustration in this book. Issue A13
Download from Www.Somanuals.com. All Manuals Search And Download.
Important
Please retain your instruction
book for future use.
In the event that you need some assistance with your
Kambrook appliance, please contact our Customer Service
Department on 1300 139 798 (Australia) or 0800 273 845
(New Zealand). Alternatively, visit us on our website at
Download from Www.Somanuals.com. All Manuals Search And Download.
Contents
Kambrook Recommends
Safety First
p4
p6
Your Kambrook Arctic
Tower Fan
Quick Start Guide
p7
p8
Using Your Kambrook
Tower Fan
Care, Cleaning and Storage
p12
Download from Www.Somanuals.com. All Manuals Search And Download.
Kambrook Recommends Safety First
IMPORTANT: Please retain your
instruction book for future use.
At Kambrook, we believe that safe performance is the first priority in any
consumer product, so that you, our valued customer can confidently
use and trust our products. We ask that any electrical appliance that
you use be operated in a sensible fashion with due care and attention
placed on the following important operating instructions.
Important Safeguards For Your Kambrook
Arctic Tower Fan
• Carefully read all instructions before
operating the tower fan for the first time
and save for future reference.
• The tower fan must not be used if the base
is not fastened correctly, according to
the instructions.
• Remove and safely discard any packaging
material and promotional labels before
using the tower fan for the first time.
• Do not operate in the presence of explosives
and/or flammable fumes or liquids.
• Do not unplug the tower fan by pulling on
• To eliminate a choking hazard for young
children remove and safely discard the
protective cover fitted to the power plug
of this tower fan.
the cord.
• Never carry the tower fan by the cord or yank
to disconnect from an outlet; instead, grasp
the plug and pull to disconnect.
• This tower fan is intended for household use
only and not for commercial or industrial use.
• Do not pull the cord around sharp edges
or corners.
• Switch off the tower fan and unplug at the
power outlet, prior to assembling, cleaning
and storing the tower fan.
• When unpacking the tower fan, check to see
you have received all the items listed in the
parts list, before discarding the packaging.
• Avoid touching mobile parts of the tower fan.
• Keep the tower fan clean. Follow the
• Do not place the tower fan on a bench or
table. Ensure that the surface is level, clean
and free of water and other substances.
cleaning instructions provided in this book.
• Do not operate without the base stand fitted.
• Always ensure the tower fan is properly
assembled before use. Follow the
instructions provided in this book.
• Do not leave the tower fan unattended
when in use.
• Do not place anything, on top of the tower
fan when assembled, when in use and
when stored.
• Never insert fingers, pencils or any other
objects through the guards whenever the
power plug is connected, in particular while
the tower fan is switched on.
4
Download from Www.Somanuals.com. All Manuals Search And Download.
Important Safeguards For All Electrical
Appliances
• Fully unwind the power cord before use.
• Do not place this appliance on or near
a heat source, such as hot plate, oven
or heaters.
• Connect only to a 230V or 240V power outlet.
• Do not let the power cord hang over the
edge of a bench or table, touch hot surfaces
or become knotted.
• Position the appliance at a minimum
distance of 20cm away from walls, curtains
and other heat or steam sensitive materials
and provide adequate space above and
on all sides for air circulation.
• To protect against electric shock, do not
immerse the power cord, power plug or
appliance in water or any other liquid or
allow moisture to come in contact with
the part, unless it is recommended in the
cleaning instructions.
• The appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities,
or lack of experience and knowledge,
unless they have been given supervision or
instruction concerning use of the appliance
by a person responsible for their safety.
• Children should be supervised to ensure that
they do not play with the appliance.
• It is recommended to regularly inspect the
appliance. To avoid a hazard, do not use
the appliance if power cord, power plug or
appliance becomes damaged in any way.
Return the entire appliance to the nearest
authorized Kambrook service centre for
examination and / or repair.
• Any maintenance other than cleaning
should be performed at an authorised
Kambrook Service Centre.
• This appliance is for household use only.
Do not use this appliance for anything other
than its intended use. Do not use in moving
vehicles or boats. Do not use outdoors.
Misuse may cause injury.
• The installation of a residual current device
(safety switch) is recommended to provide
additional safety protection when using
electrical appliances. It is advisable
that a safety switch with a rated residual
operating current not exceeding 30mA be
installed in the electrical circuit supplying
the appliance. See your electrician for
professional advice.
• Always turn the appliance to the OFF
position, switch off at the power outlet
and unplug at the power outlet when
the appliance is not in use.
• Before cleaning, always turn the appliance
to the OFF position, switch off at the
power outlet, unplug at the power outlet and
remove the power cord, if detachable, from
the appliance and allow all parts to cool.
5
Download from Www.Somanuals.com. All Manuals Search And Download.
Your Kambrook Arctic Tower Fan
1. LED screen
Not Shown
•
Remote control storage
2. Control panel featuring:
(top and back)
•
•
POWER On/Off button
Fan SPEED button
(Includes 3 speed settings;
low, medium and high)
•
•
Carry handle (at rear of unit)
4 screws to secure the base to
the unit
•
MODE button (includes 3
cooling modes; normal,
nature and reduction mode)
•
•
TIMER button (up to 12 hours)
SWING button to set oscillation
3. Tower fan body
4. Remote control signal receiver
5. Oscillating platform
6. 2 piece base stand (a) and (b)
7. Remote control with soft
touch buttons
6
Download from Www.Somanuals.com. All Manuals Search And Download.
Quick Start Guide
Turning the tower fan on
Plug the cord into a 230V or
240V power point and
switch on.
Once the power outlet
To start the tower fan, turn the
tower fan on by pressing the
‘POWER’ button once; the unit
will be in NORMAL fan mode.
is switched on, this will
automatically allow the LED
screen to display to current
room temperature.
Setting the fan speed
Pressing the ‘SPEED’ button
once will set the tower fan into
LOW speed setting.
Pressing the ‘SPEED’ button
twice will set the tower fan
into MEDIUM speed setting.
The speed indicator bar on
the control panel will flash
continuously on this cycle.
Pressing the ‘SPEED’ button
three times will set the tower
fan into HIGH speed setting.
The speed indicator bar on
the control panel will flash
continuously on this cycle.
Setting the fan mode
Setting the osciillation
Once the tower fan is switched
on and the the ‘POWER’button
is selected; the unit will be in
NORMAL fan mode.
Pressing the ‘MODE’ button
twice will set the tower fan into will allow the tower fan to
REDUCTION mode. To set the
tower fan back to NORMAL
Pressing the ‘SWING’ button
oscillate side to side. To stop the
oscillation, press the ‘SWING’
Pressing the ‘MODE’ button
once will set the tower fan
into NATURE mode.
mode, press the ‘MODE’ button button again.
again.
7
Download from Www.Somanuals.com. All Manuals Search And Download.
Using Your Kambrook Tower Fan
3. Position base stand piece (b)
Before first use
Remove your tower fan from its carton
and associated protective wrapping.
onto base stand piece (a) by
aligning the four locating posts.
Firmly push down base stand
piece (b) until the base stands are
secured into place (see Fig.2).
Unwind the cord to its full length and
remove any protective cardboard
or foam that may have been used
to minimise transportation damage.
Place the tower fan on a firm, level
surface in a stable upright position.
Visually inspect the air inlet and
outlets to ensure no foreign material is
blocking these areas.
Assembling Your Kambrook
Arctic Tower Fan
Fig. 2
To assemble the base stand;
4. Thread the power cord through
the circle cord opening. Once
power cord is pulled through,
align the holes on the base
1. The tower fan base stand comes
in two separate pieces that must
be fixed together before being
fitted to the fan body.
2. To assemble the base stand,
place the tower fan body on its
side. Holding base stand piece
(a) and (b) align the power cord
with the centre of the round cord
opening of base stand piece (a)
(see Fig.1).
stands with the four screw holes
located at the bottom of the
tower fan body (see Fig.3).
Fig. 3
Fig. 1
8
Download from Www.Somanuals.com. All Manuals Search And Download.
5. Once base stand is aligned with
the tower fan body, secure the
base stand to the tower body
with the four fastening screws
(see Fig.4).
Setting the Fan Speed
The tower fan has three fan speed
settings; LOW , MEDIUM
HIGH
and
.
Pressing the ‘SPEED’ button once
will set the tower fan into LOW
speed setting.
Pressing the ‘SPEED’ button
twice will set the tower fan into
Medium
speed setting.
Pressing the ‘SPEED’ button three
times will set the tower fan into
HIGH
speed setting.
Fig. 4
nOTE: The SPEED indicator bar
on the control panel will flash
continuously during these cycles.
6. Return the tower fan to its upright
position; it is now ready for use.
To turn the tower fan OFF, press the
‘POWER’ button and turn off at the
power outlet and remove the plug
from the power outlet.
WARnInG: Do not operate
the tower fan without the
base stand fitted.
Turning Your Tower Fan On
To turn the tower fan on, plug the
power cord into a 230V or 240V
electrical outlet and switch on. Be
sure the plug fits tightly as a loose fit
will cause overheating and damage
the plug.
Once the power outlet is switched
on, this will automatically allow the
LED screen to display to current
room temperature.
To start the tower fan, turn the tower
fan on by pressing the ‘POWER’
button once; the unit will be in
NORMAL fan mode.
9
Download from Www.Somanuals.com. All Manuals Search And Download.
Using Your Kambrook Tower Fan
continued
Setting the Nature and
Reduction Mode
Reduction mode
The REDUCTION mode automatically
decreases the fan speed over time.
Your tower fan has a NATURE
and REDUCTION
setting.
The REDUCTION mode only applies in
the MED or HIGH speed settings.
Both the NATURE and REDUCTION
modes can be used on any fan
speed. The LED screen will indicate
what mode the fan has been set in.
Once a fan speed setting is selected,
press the MODE button twice will turn
the tower fan into REDUCTION mode.
After 30 minutes, the selected setting
will drop to the next lowest setting.
For example if the fan speed is set
at MEDIUM, after 30 minutes it will
drop down to LOW until the unit is
turned off.
Nature Mode
The NATURE mode stimulates the
natural rise and fall of the wind
over time.
At any fan speed setting, pressing the
MODE button once will turn the tower
fan into NATURE mode.
To turn the REDUCTION mode off,
press the MODE button once, the
fan will now be in NORMAL
operation mode.
To turn the NATURE mode OFF, press
the MODE button twice, the fan will
now be in NORMAL operation mode.
When REDUCTION mode is selected
the display panel will automatically
switch off after 30 seconds. Press any
button on the control panel to turn
the display on again. This will NOT
turn the tower fan off.
Diagram of speed cycle settings:
NATURE:
REDUCTION:
Random speed cycles
Speed steps down every 30 minutes for MED and HIGH
settings.
Pre-select speed
(MED)
Speed
(LOW,MED,HIGH)
speed
variation
speed
variation
speed
Pre-select speed
(HIGH)
variation
speed
variation
speed
variation speed
10
Download from Www.Somanuals.com. All Manuals Search And Download.
• Press the ‘TIMER’ button to
activate the timer settings.
nOTE: When the NATURE mode
setting is selected, the tower fan
is programmed to self regulate
through the various fan speeds.
The NATURE mode is independent
from the fan speed settings while
the LED screen will still display the
last selected fan speed setting.
• Press the ‘TIMER’ button to cycle
through the one hour increments,
up to 12 hours.
• The tower fan will then switch itself
to standby mode after the selected
number of hours has passed.
• The TIMER can be set on any of
the settings.
Using the Remote Control
nOTE: The tower fan is fitted with
a power save mode. When the
REDUCTION mode is selected
or the TIMER function is set, the
display panel will automatically
switch off after 30 seconds.
Press any key to turn the display
on again.
Before using the remote control,
remove the battery isolating slip
by pulling the slip away from the
remote control. The remote control
buttons operate in the same way
as those on the tower fan control
panel. Your remote control includes
1 x CR2025 3V Lithium battery, and
can be conveniently stored in the
compartment on the top of the
tower fan or at the rear housing
of the unit.
Setting the Oscillation
This function will work in any mode.
Pressing the ‘SWING’ button will allow
the tower fan to oscillate back and
forth. To stop the unit oscillating, press
the ‘SWING’ button once more.
Setting the Auto-Off Timer
The timer function works in all
operating modes, and switches
the unit off after a pre-set number
of hours.
11
Download from Www.Somanuals.com. All Manuals Search And Download.
Care, Cleaning and Storage
1. Ensure that the tower fan is
switched OFF and disconnected
from the power outlet
before cleaning.
2. Use a clean, dry cloth to clean
the external surfaces of the tower
fan. If the tower fan has collected
dirt inside the unit, have the unit
cleaned by a qualified service
agent. Do not operate the tower
fan in this condition.
3. Do not attempt to open the
case of the tower fan at any
time as there are no customer
serviceable parts inside.
4. When not in use, store the tower
fan (preferably in its original box)
in a cool, clean and dry location.
12
Download from Www.Somanuals.com. All Manuals Search And Download.
Notes
13
Download from Www.Somanuals.com. All Manuals Search And Download.
Notes
14
Download from Www.Somanuals.com. All Manuals Search And Download.
Notes
15
Download from Www.Somanuals.com. All Manuals Search And Download.
|