Download from Www.Somanuals.com. All Manuals Search And Download.
IMPORtaNt PRECaUtIONs
WHEN UsINg ElECtRICal
aPPlIaNCEs, basIC
PRECaUtIONs sHOUlD alWaYs
bE fOllOWED tO REDUCE tHE
RIsK Of fIRE, ElECtRIC sHOCK
aND INjURY tO PERsONs,
INClUDINg tHE fOllOWINg:
beendroppedordamagedinanymanner.
Return heater to your nearest service
centre for examination, electrical or
mechanical adjustment or repair.
9. Do not use outdoors. This heater is
not intended for commercial use, such
as construction sites.
REaD aND KEEP tHEsE
INstRUCtIONs fOR fUtURE
REfERENCE bEfORE UsINg tHIs
HEatER
10. Do not locate the heater immediately
below a socket outlet when in use.
11. Do not use this heater with
a
programmer, timer or any other
1. Avoid touching heater body while it is
on, some parts of the heater are hot.
When moving the unit switch off and
hold the heater by the handles where
provided.
device that switches the heater on
automatically. Since a fire risk may exist
if the heater is covered or positioned
incorrectly.
12. This heater is not intended for use in
wet or moist locations. Do not use this
heater in the immediate surroundings of
a bath, a shower or a swimming pool.
Do not immerse or allow liquids to be
spilt on heater.
2. Keep combustible materials such as
drapes and other furnishings at least 1.7
metres from the front, sides and rear
of the heater. Do not use heater to dry
your laundry.
WaRNINg: In order to avoid
overheating do not cover the
heater.
13. This heater has hot and arcing or
sparking parts inside. Do not use in
areas where petrol, paints, aerosols, or
other inflammable substances are used
or stored.
3. Extreme caution and supervision is
necessary when this heater is used by or
near children, invalids or animals.
14. Do not operate the heater with the
power cord damaged, frayed or split,
wound around any part of the heater,
or in contact with heated surfaces of
the heater.
4. Young children should be supervised to
ensure they do not play with the heater.
5. Important – this heater is intended for
floor use only. Do not mount on ceiling
or walls.
15. Do not allow materials that have been
in contact with oil, petroleum based
products or drying fluids to come in
contact with the heater.
6. Do not leave heater unattended. Always
switch off the heater at the controls and
at the power outlet then unplug heater
from the power outlet when not in use.
16. Do not run the cord under carpeting
or cover the cord with rugs, runners or
the like. Arrange cord away from traffic
areas and where it will not be tripped
over.
7. Do not operate heater whilst asleep.
8. Do not operate any heater with a
damaged cord or plug, or if heater has
ꢀ
Download from Www.Somanuals.com. All Manuals Search And Download.
electrical circuit. See your electrician for
professional advice.
17. To disconnect heater turn the control to
OFF, then switch off at the power outlet
then remove plug from its outlet.
HOW TO OPERATE:
18. Do not insert or allow foreign objects
to pass through the inlet or outlet
openings. This may cause an electric
shock, fire or damage the heater.
1. Remove your heater from its carton
and associated protective wrapping,
and unwind the cord to its full length
and remove any protective cardboard
or foam that may have been used to
minimize transportation damage. Place
the heater on a firm, level surface in a
stable upright position. Visually inspect
the air inlet and outlets to ensure no
foreign material is blocking these areas.
The heater must always be operated
with the rear air filter in position.
19. To prevent a possible fire or heat damage,
allow ample space around the heater (at
1.7m at front and 0.5m at the rear, top
and sides) and do not totally or partially
block the air inlet or outlets in any
manner. Check the openings from time
to time for accumulated dust. Ensure
long shag carpet does not obstruct
airflow under the unit.
2. Plug the cord into a 230-240V electrical
outlet. Be sure the plug fits tightly as
a loose fit will cause overheating and
damage the plug. To avoid an electrical
circuit overload, it is recommended that
no other appliances are plugged into the
same circuit with your heater when you
switch the unit on.
20. Do not touch hot metal surfaces.
21. Switch off at the control switch and
power outlet, then unplug and allow
heater to cool down before cleaning or
storing.
22. Use this heater only as described in this
instruction manual. Any other use not
recommended by the manufacture may
cause fire electric shock or injury and
voids all warranties.
3. This heater has four settings OFF, FAN,
HEAT 1 AND HEAT 2, located at the
top of the unit, along with an adjustable
thermostatic dial for selecting the
desired temperature. HEAT 1 (1000W)
is the lowest heat, HEAT 2 (1800W)
is the highest while selecting the FAN
icon will act to circulate air. When any
of these modes are selected the power
indicator light located at the base of the
heater will illuminate to indicate that
power is on.
23. Regularly inspect the supply cord, plug,
control settings, air inlets and outlets
and main housing for any damage. If
found damaged in any way, immediately
cease use of the heater and return to
Kambrook or an authorised service
agent for inspection or repair.
24. The installation of a residual current
device (safety switch) is recommended
to provide additional safety protection
when using electrical appliances. It is
advisable that a safety switch with a
rated residual operating current not
exceeding 30mA be installed in the
4. Rotating the thermostatic dial will
increase the temperature output of the
unitthehigherthedialisturnedclockwise
towards the ‘MAX’ symbol.Alternatively,
the temperature output will decrease
when the dial is turned anti-clockwise
towardsthe ‘MIN‘ symbol.
4
Download from Www.Somanuals.com. All Manuals Search And Download.
heater at any time there are no customer
serviceable parts inside.
5. To turn the heater off, the ‘O’ setting
needs to be selected.This will turn the
heater off, and the power indicator light
will go out.
• When not in use, pack the heater,
preferably in its original box for best
protection and store in a cool, clean and
dry location.
NOtE: there is a tip over switch
fitted to this heater. When
the heater tips over it will
automatically turn off. the heater
will need to be placed back into
the upright position and the start
sequence and desired temperature
settings selected again.
• The air filter at the rear of the heater
can be easily cleaned by removing the
filter casing panel and removing the
mesh filter. A basic clean in warm water
to remove any build up is adequate and
allow time to completely dry before
replacing the filter and the filter casing
panel.
tHERmO gUaRD
OvERHEatINg SafEtY
DEvICE
Your heater is fitted with a safety device
that switches off the heater in the event
of overheating. Should this heater stop
working, turn off the heater and inspect
for blockages in air inlet or outlets. Wait
at least five minutes for the protection
system to reset before attempting to
restart the heater.
If the heater fails to operate or the
safety device switches off again, return
the heater to your nearest service
centre for examination or repair.
CaRE aND maINtENaNCE
• Always turn off and then unplug the
heater before cleaning.
• Use only a clean, dry cloth to clean the
external surfaces of the heater only.
• If the heater has collected dust or dirt
inside the unit or around the elements,
have the unit cleaned by a qualified
service agent. Do not operate the heater
in this condition.
• Do not attempt to open the case of the
ꢀ
Download from Www.Somanuals.com. All Manuals Search And Download.
NOTES
ꢀ
Download from Www.Somanuals.com. All Manuals Search And Download.
NOTES
ꢁ
Download from Www.Somanuals.com. All Manuals Search And Download.
Due to continual improvement in design or otherwise, the product you purchase may differ slightly from the illustration in this book. Issue 1/09
Download from Www.Somanuals.com. All Manuals Search And Download.
|