JX-CD915
PORTABLE CD/MP3 DISC PLAYER
WITH FM STEREO RADIO
INSTRUCTION MANUAL
Download from Www.Somanuals.com. All Manuals Search And Download.
•
If FM signal is too weak, may cause big noise for stereo stations, please set the function
switch to FM MO. position.
PROGRAM PLAY (FOR MP3 DISC)
1. In stop mode, press the MODE/PROG button to make program memory.
2. “ PGM 0P-01 0 ” will be displayed. “ 0 ” means DIRECTORY number, “ 0 ” means file
number, “P-01” means program number.
* “ 0 ” flashing appears on the display.
3. Press the ASP/DIR button to select the desired directory.
TROUBLE SHOOTING GUIDE
Cleaning the Disc
When a disc becomes dirty, clean it with a cleaning cloth. Wipe the disc from the center out.
BBS (BASS BOOST SYSTEM) FUNCTION
Set the BBS button to ON position to enhance the bass effect.
Note -
Do not use solvents such as benzine, thinner, commercially available cleaners
or anti-static spray intended for analogue discs.
PRESET EQUALIZER FUNCTION
Press the EQ button activates 4 Kinds of sound effect as follows:
CLASSIC
4. Press
or
button to select the desired file.
** Should you experience difficulties in the use of this player please refer to the
following chart before contacting your dealer or the place of purchase.
5. Press the MODE/PROG button to enter the DIRECTORY and file into memory.
The program number which will be increment one step.
* The program no.“P-01” has become “P-02” on display.
ROCK
JAZZ
POP
* The EQ indicator will appear on the display.
6. Repeat step 3 to 5 until memory is full (UP TO 60 FILES).
7. Press
button to start the program play.
MAINTENANCE
Troubleshooting Guide
8. To stop the program play, press the STOP button.
Cleaning the Lens
9. For program play in step “ 8 “, press the MODE/PROG button &
10. To erase the program memory, turn off the power or open the door.
* If you do not neet to select directory, only select files, the above step 3 can pass.
button.
Problem
Points to check
If the lens becomes dusty, clean it with camera lens blower. Be careful not to scratch the
surface of the lens.
Player fails to function
-
-
-
-
-
-
The disc may be inserted upside down.
The disc not mounted correctly on the chuck.
Dirty or a defective disc.
Dirty pick up lens.
Player lid not closed.
Moisture condensation, allow the player to warm up to
room temperature for 60 minutes.
AC Power to an adaptor switched off.
Auto power off has occurred, press PLAY button to
restore power.
Cleaning the Cabinet
From time to time, clean the cabinet with a soft dry cloth. For more stubborn stains, slightly
moisten the cloth with water or a mild detergent solution. Never use benzene, alcohol or
other solvents as they may damage the finish of the cabinet.
DIGITAL ANTI-SHOCK OPERATION
The DIGITAL ANTI-SHOCK PROTECTION function uses semiconductor memory to pre-
vent the second from skipping when the unit is subjected to shocks and vibration during play.
When the PLAY/PAUSE button is pressed and the power turns on, the “ASP” appear and the
digital Anti-Shock Protection function turns on automatically.
SPECIFICATIONS
-
-
CD:
It will give approximately 40 seconds(MP3 120 seconds) of protection against interruption
of sound output, if the player is subjected to shocks of more than 40 seconds duration, some
interruption of sound output will occur, this is normal and to be expected, the sound will
resume once the player has stabilized from the shock.
Output Power
Freq. Response
:
:
20MW (32
100 ~ 20000 Hz
)
)
-
-
Weak batteries.
Hold switches at ON position, switch to OFF position.
RADIO:
Frequency range
Output Power
•
•
To turn this function off, press ASP/DIR button once, the ASP indicator will disappear.
(FOR CD DISC ONLY)
In MP3 disc always has the ASP function and the ASP time is 120 seconds at 128 Kbps
bit rate.
:
:
FM 88 - 108MHz
20MW (32
No sound from Earphones
Intermittent Sound
-
-
Earphones' plug is not firmly inserted into the Phones
socket.
VOLUME set on min. position.
Power Source
:
2 x UM-3 or AA size batteries
4.5V (600mA) AC - DC adaptor
142mm(W) x 142mm(D) x 32mm(H)
-
-
-
-
-
Dirty or defective disc.
Dirty pick up lens.
The player is subject to excessive vibration or shock.
Low battery power.
Poor Earphone connection.
Dimensions
:
RADIO OPERATION
Perform the following in sequence:
1. Insert the headphone/earphone plug to PHONE JACK.
2. Set the FUNCTION SWITCH to the FM ST. position.
3. Turn the TUNING KNOB in the desired radio station.
4. Adjust the VOLUME CONTROL.
** For improvement purposes, specification and design are subject to change without
notice. **
5. To turn the radio off, set the FUNCTION SWITCH to CD position.
Notes :
•
When listening to FM program, the phone cord works as an antenna. To insure maximum
tuner sensitivity, keep the phone cord (antenna) always straight. Do not fold it.
Reception sensitivity depends on the placement of the phone cord. Try to determine the
cord position which provides the best sensitivity.
•
—
5
—
—
6
—
—
7
—
Download from Www.Somanuals.com. All Manuals Search And Download.
|