Changes in mounting the camera
The ceiling mount bracket comes attached to the camera unit. Before
installing, unfasten the ceiling mount bracket from the camera unit.
Ⅵ Precautions during transportation
When mounting ceiling mount bracket to the camera unit during
transportation, let out the tip of fall prevention wire so that it is not caught.
If the fall prevention wire is caught in the gap of ceiling mount bracket, the
ceiling mount bracket might not be able to detached from the camera unit.
A Check to ensure that the camera fixing lock knobs (x2) is not turned on.
● If it is locked, slide the camera fixing lock knobs to unlock in the
direction as shown below.
B Push in the camera fixing lock knobs (x2) from both left and right sides
in the direction as illustrated in the diagram.
●
Unfasten the ceiling mount bracket on a table to prevent it from falling off.
Memo：
● If it is difficult to push in the camera fixing lock knob, push in while
pressing the edge of camera (figure A) against the table where the
process is being carried out.
C Lift the camera unit upward to remove the ceiling mount bracket, and
pull down in the direction as indicated.
A
Let out the tip of fall prevention
wire
A
Camera fixing lock
knob (x2)
B
B
C
Ceiling mount bracket
Camera unit
© 2008 Victor Company of Japan, Limited
LST0723-001A
Download from Www.Somanuals.com. All Manuals Search And Download.
|