owner’s manual
MX650-CCX / MX770-CCX
Cockpit Coaxial Speaker Systems
Thank you for purchasing a JL Audio Marine Coaxial Speaker System.
With proper installation, your new speakers will deliver
years of listening pleasure.
We strongly recommend that you have your new marine speakers
installed by your authorized JL Audio dealer.
The installation professionals employed by your dealer have
the necessary tools and experience to properly install your new speakers.
If you prefer to perform your own installation,
please read this instruction manual completely before
beginning the process.
Download from Www.Somanuals.com. All Manuals Search And Download.
CCX anD tCX moDels...
wHat Is tHe DIFFerenCe?
CCX models have woofers specifically designed
for infinite-baffle applications. In plain english,
this means that they are designed to operate
without an enclosure behind them. The bass
response of the speaker will suffer significantly if
placed in a small enclosure.
TCX models are specifically engineered for
enclosed operation. This makes them ideal
for wakeboard tower systems or other small
enclosure applications.
Do not attempt to remove the tweeter from
the grille or the grille from the speaker!
The tweeter is permanently fixed to the grille
and its wiring is permanently attached to the
speaker frame. Attempting to remove the grille
or the tweeter will damage the speaker and this
damage will not be covered under warranty.
3
Download from Www.Somanuals.com. All Manuals Search And Download.
BeFore You BeGIn InstallInG
•ꢀꢀTurnꢀoffꢀtheꢀaudioꢀsystem.ꢀItꢀisꢀalsoꢀadvisableꢀ
to disconnect your battery system whenever
performing installation work.
tweeter ProteCtIon
The crossover networks are equipped with
an advanced electronic tweeter protection circuit
designed to minimize the possibility of tweeter
failure. This electronic device monitors current
going to the tweeter and will disconnect the
tweeter from the signal when it senses overload.
Should this occur while listening to the audio
system, simply reduce the volume for a few
seconds and the protection circuit will reset
itself automatically.
•ꢀꢀBeforeꢀcutting,ꢀdrillingꢀorꢀinsertingꢀanyꢀscrew,ꢀ
check clearances on both sides of the planned
mounting surface. Also check for any potential
obstacles, such as wiring harnesses, fuel lines,
hydraulic lines, etc. Check both sides of the
vessel before cutting any holes.
•ꢀꢀWearꢀprotectiveꢀeyewearꢀatꢀallꢀtimesꢀandꢀaꢀdustꢀ
mask and gloves when drilling or cutting.
It is absolutely vital that your coaxial speaker
system is connected as shown in this manual.
Failure to connect the system as shown will
result in damage to your speakers which
is NOT covered under warranty. Do not
substitute different crossover networks!
While these speakers are designed to be water
and spray resistant, they are not designed to be
submerged or to withstand high-pressure water
spray. Please exercise care when washing your
boat to avoid damaging your speakers. Do not
install on submersibles, personal watercraft or any
other vessel likely to be under water at any time.
Prolonged exposure to sound pressure levels in
excess of 100dB can cause permanent hearing
loss. This high-performance speaker can
exceed this level. Please exercise restraint in its
operation in order to preserve your ability to
enjoy its fidelity.
When installing speakers in your vessel, it is
extremely important to secure them firmly. This
applies not only to the speakers themselves,
but also any structure they are mounted to. If
not firmly attached, the speakers can become
dangerous projectiles in a collision. Please
review the mounting information carefully and
use the supplied marine-grade hardware to
mount this product.
4 | JL Audio - MX650-CCX / MX770-CCX Owner’s Manual
Download from Www.Somanuals.com. All Manuals Search And Download.
to amplifier output
wIrInG DIaGram:
to
from
from
to
tweeter
negative
input
amplifier
negative
output
amplifier
positive
output
tweeter
positive
input
5
Download from Www.Somanuals.com. All Manuals Search And Download.
InstallInG tHe sPeaKers
Once the mounting locations have been
CoaXIal InstallatIon ProCeDure
Diagram A (page 7) shows the typical
established, run speaker cables from the amplifier
outputs to the mounting locations. If you are
running cables through bulkheads, drill holes for
the cable and use a urethane or plastic grommet
to protect the wire from chafing in the hole. Make
sure that the cables will clear any mechanical
devices in the boat and secure them with wire ties.
installation procedure into a fiberglass panel,
using the supplied hardware. Always follow proper
safety procedures. Use eye-protection at all times
and a dust mask and gloves when cutting.
1) Choose a flat mounting surface that has
sufficient depth and air space behind it to
accept the speaker.
2) Using a hole saw or jigsaw, cut a mounting
hole for your respective speaker model (see
“Mounting Hole Diameter (E)” specifications,
page 2). If using a jigsaw, tracing the supplied
mounting template will provide you with an
accurate line on which to cut.
3) Run the speaker cable from the amplifier
output to the mounting location.
4) Place the speaker in the hole (or use the
mounting template) and mark the screw
hole locations using a sharp, pointed tool.
5) Remove the speaker and drill a pilot hole (see
Pilot Hole Recommendation chart,
If you have any questions about the installation
or setup of your coaxial speaker system not
covered in this manual, please contact your
dealer or technical support.
page 7) in each of the screw locations.
It is also advisable to use a hand-driven
countersink tool on each hole to further
inhibit gel-coat cracking of fiberglass panels.
6) Connect the speaker wires from the
amplifier to the woofer connections.
SeeꢀWiringꢀDiagramꢀonꢀpageꢀ5.ꢀ
Jl audio technical support:
(954) 443-1100
9:00 AM – 5:30 PM (Eastern Time Zone)
Monday - Friday
7) Place the speaker into the opening.
8)ꢀꢀWhileꢀholdingꢀtheꢀspeakerꢀfirmlyꢀinꢀitsꢀ
mounting location, place the #8 x 1 3/8-inch
Phillips pan-head mounting screws (with
washers) and snug in a criss-cross pattern,
then tighten with a hand screwdriver in a
criss-cross pattern.
Non-standard installations may require different
hardware. Always use marine-grade, stainless-steel
fasteners to ensure a secure, reliable installation.
6 | JL Audio - MX650-CCX / MX770-CCX Owner’s Manual
Download from Www.Somanuals.com. All Manuals Search And Download.
DIaGram a
#8 sCrew: PIlot Hole reCommenDatIons
Fiberglass thickness
recommended Pilot Hole Drill size
7/64 in. (2.78 mm) pilot hole
7/64 in. (2.78 mm) pilot hole
1/8 in. (3.18 mm) pilot hole
0.125 in. (3.18 mm) or less
foam core / fiberglass sandwich
larger than 0.125 in. (3.18 mm)
Do not attempt to remove the tweeter from the grille or the grille from the speaker!
The tweeter is permanently fixed to the grille and its wiring is permanently attached to the speaker
frame. Attempting to remove the grille or the tweeter will damage the speaker and this damage will
not be covered under warranty.
7
Download from Www.Somanuals.com. All Manuals Search And Download.
lImIteD warrantY - marIne sPeaKer sYstems (usa)
JL AUDIO warrants this product to be free of defects in materials and workmanship for a period of two
(2) years from the original date of purchase.
This warranty is not transferable and applies only to the original purchaser from an authorized
JL AUDIO dealer. Should service be necessary under this warranty for any reason due to manufacturing
defect or malfunction, JL AUDIO will (at its discretion), repair or replace the defective product with new
or remanufactured product at no charge.
Damage caused by the following is not covered under warranty: accident, misuse, abuse, product
modification or neglect, failure to follow installation instructions, unauthorized repair attempts,
misrepresentations by the seller. This warranty does not cover incidental or consequential damages and
does not cover the cost of removing or reinstalling the unit(s). Cosmetic damage due to accident or normal
wear and tear is not covered under warranty.
warranty is void if the product’s serial number has been removed or defaced.
Any applicable implied warranties are limited in duration to the period of the express warranty as
provided herein beginning with the date of the original purchase at retail, and no warranties, whether
express or implied, shall apply to this product thereafter. Some states do not allow limitations on implied
warranties, therefore these exclusions may not apply to you. This warranty gives you specific legal rights,
and you may also have other rights which vary from state to state.
If you need service on your Jl auDIo product:
All warranty returns should be sent to JL AUDIO freight prepaid through an authorized
JL AUDIO dealer and must be accompanied by proof of purchase (a copy of the original sales receipt.)
Direct returns from consumers or non-authorized dealers will be refused unless specifically authorized
byꢀJLꢀAUDIOꢀwithꢀaꢀvalidꢀreturnꢀauthorizationꢀnumber.ꢀWarrantyꢀexpirationꢀonꢀproductsꢀreturnedꢀ
without proof of purchase will be determined from the manufacturing date code. Coverage may be
invalidated as this date is previous to purchase date. Return only defective components. If one speaker
fails in a system, return only that speaker component, not the entire system. Non-defective items received
will be returned freight-collect. Customer is responsible for shipping charges and insurance in sending the
product to JL AUDIO. Freight damage on returns is not covered under warranty.
For service Information in the u.s.a. please call
Jl audio Customer service: (954) 443-1100
9:00 AM – 5:30 PM (Eastern Time Zone)
Jl audio, Inc
10369 North Commerce Pkwy.
Miramar, FL 33025
International warranties:
Products purchased outside the United States of America are covered only
by that country’s distributor and not by JL Audio, Inc.
Printed in USA
JLMX650/770-CCX_0608_SKU#011305
Download from Www.Somanuals.com. All Manuals Search And Download.
|