®
Stealthbox
I N S T A L L A T I O N G U I D E
START
HERE
B
3.5”
for the
2.5”
X
➔
➔
➔
SB-T-4RNR2/10W3v2
(‘02-Up Toyota 4-Runner SR-5, Sport
Edition & Limited)
A
STEP 1: Clean out all contents. Remove the
STEP 2: Remove the rear sill plate(A) and side
STEP 3: Place the supplied wax square into
cargo cover and carpet mat.
storage door(B).
position.
With the sill plate removed, pull and fold over the car-
pet out of the corner(circled).
The middle of wax square (X marks the
spot) needs to be 3.5” back from the wheel
well and 2.5” from the side panel.
On Limited Edition interiors, remove the plastic tray.
The flooring carpet will not fit flush aginst the
Stealthbox, once isntalled.
Remove the adhesive protective paper from
the under side of the wax square and stick to
the floor.
This Stealthbox is a product which
requires professional installation skills and
tools.
Please read this installation guide thor-
oughly before beginning the project. It
will guide you step by step through the
installation. Several of the steps in this
process may require two people to
accomplish.
➔
➔
➔
It is absolutely vital that the enclosure
be properly mounted to the vehicle
according to these instructions. Failure
to mount the enclosure properly pres-
ents two problems: 1)The sub-bass
performance will suffer due to the
movement of the enclosure caused by
the force exerted by the woofer(s) and
2) A loose enclosure presents a serious
safety hazard in the event of a collision
or sudden deceleration.
STEP 4: Thread in the supplied tsocket cup set
screw, leaving about a 1/2” out of the Stealthbox.
Make sure that the socket cup end is exposed.
STEP 5: With the Stealthbox removed and wax
square still in position, use a 1/2” drill bit to drill out
the marked location.
STEP 6: Place and line up the hole, of one of the
supplied black metal plates to the 1/2” drilled hole
from STEP 5.
Place the Stealthbox into position and press down
firmly.
After hole is drilled, remove the wax square.
Use tape to temporary secure the metal plate into
position.
Please enjoy your JL Audio Stealthbox
responsibly.
Continued on Next Page ➔
STEP
Sheet SKU#011181 Revision 01/13/2004
SB-T-4RNR2/10Wv2, JL AUDIO, Inc 2003
Page 1
Download from Www.Somanuals.com. All Manuals Search And Download.
Cont.
From
Previous
Page
CONGRATULATIONS!
INSTALL COMPLETE.
➔
➔
➔
➔
STEP 11: Take the other supplied black metal
plate, lock washer, flat washer and nut to the under
side of vehicle.
STEP 12: Place the other black metal support
plate, flat washer, lock washer and thread the nut
onto the threaded rod. Use a 9/16” socket and long
extension to fully secure the mounting assembly.
STEP 13: Replace the carpet and any other con-
tents back into cargo area.
For cosmetics, we folded the corner of the carpet
back under it self.We do not recommend that you
cut this carpet.
If the socket cup set screw is not protruding far
enough, loosen.
Supplied Hardware:
2) 3/8” Split Lock Washers
2) 3/8” Flat Washers
2) 3/8” x 1-1/4” Fender
2) 3/8”-16 x 2-1/4” hex
1) 1/4”-20 Install Bolt
1) 3/8”-16 x 2-1/4” Socket Cup Set Screw
1) 3” x 3”Wax Square
2) 3/8”-16 Hex Nut
Mid/High Frequency Driver Information:
Specifications:
Enclosure Type: Acoustical Suspension (Sealed)
Driver Type: 10W3v2-D2
Nominal Impedance: 4Ω
Cont. Power Handling: 300Watts
Front Location Driver Size:
6”x9” with separated tweeter
Applicable JL Audio Products:
TR690-TXi &VR690-CXi, does require
spacer/mounting rings.
TR690-TXI
JLAudio recommends using a high quality amplifier such as the JLAudio 250/1. The diagram below shows the recommended
crossover, infrasonic filter and equalizer settings for the 250/1 when being used to power your Stealthbox®.
Amp LP Filter
Mode/Slope
+12VDC
Ground Remote
Preamp Output Section
Output Mode
Bass Control
Infrasonic Filter
Amplifier Input Section
Input Voltage
Input Sens. Signal Sensing
Off/On
Rear Location Driver Size:
Full-Range/Low-Pass/High-Pass
Off/30Hz
+7
Off/12dB/24dB
Low/High
6 3/4”
+3
+1
+10
+13
JL AUDIO 250/1
Applicable JL Audio Products:
monoblock subwoofer amplifier
TR650-CXi,VR650-CXi & XR650-CXi,
Left Ch.
Right Ch.
LF Boost (dB) Filter Freq. (Hz)
Left Ch.
Right Ch.
does require spacer/mounting rings.
The JL Audio 250/1 is a very versatile audio component. Please consult the owner’s manual for detailed information
about installing and tuning this amplifier.
VR650-CXI
10369 N. Commerce Pkwy, Miramar, Florida 33025-392
Phone: 954.443.1100
Fax: 954.443.1111
SB-T-4RNR2/10Wv2, JL AUDIO, Inc 2003
Page 3
Sheet SKU#011181 Revision 01/13/2004
Download from Www.Somanuals.com. All Manuals Search And Download.
|