651747-X-B
OPERATOR’S MANUAL
RELEASED: 6-28-92
INCLUDING: OPERATION, INSTALLATION & MAINTENANCE
REVISED:
(REV. G)
7-16-01
STAINLESS STEEL FLUID HEATER
READ THIS MANUAL CAREFULLY BEFORE INSTALLING,
OPERATING OR SERVICING THIS EQUIPMENT
.
It is the responsibility of the employer to place this information in the hands of the operator. Keep for future reference.
FLUID HEATER DATA
DIMENSIONAL DATA
Models . . . . . . . . . . . . . . . . . . . . . . . . . 651747ĆXĆB
Wetted Parts Material . . . . . . . . . . . . . . Stainless Steel
651747ĆXĆB FLUID HEATER
Volts AC
651747Ć1ĆB . . . . . . . . . . . . 120
651747Ć2ĆB . . . . . . . . . . . . 230 / 240
651747Ć3ĆB . . . . . . . . . . . . 415 / 440
651747Ć1ĆB . . . . . . . . . . . . 16.6
651747Ć2ĆB . . . . . . . . . . . . 8.3
651747Ć3ĆB . . . . . . . . . . . . 4.5
7Ć1/2"
(190.5 mm)
Amperes
7/8" (22.2 mm)
4Ć3/4"
(120.7 mm)
4Ć3/16"
(105.6 mm)
1/2 Ć 14 N.P.T.F.
Watts . . . . . . . . . . . . . . . . . . . . . . . . . . . 2000
Accuracy . . . . . . . . . . . . . . . . . . . . . . . . ±3Ć1/2_ F (1.9_ C)
Temperature Rise Above Ambient . . . . . 100_ F (38_ C)
Recovery Rate per Hour . . . . . . . . . . . . 15 gallons (56.8 liters)
Maximum Working Pressure . . . . . . . . . 5000 p.s.i. (35 MPa)
Maximum Temperature Range . . . . . . . 60 Ć 2 50_ F (16 Ć 12 1_ C)
Surface Temperature Code . . . . . . . . . . T3 (392_ F / 2 00_ C)
Fluid Passage Diameter . . . . . . . . . . . . 0.370" (9.4 mm)
Fluid Passage Length . . . . . . . . . . . . . . 91.7" (232.9 cm)
Mounting holes (hidden)
Thermometer - Do not overĆ
tighten. For orientation only.
1/2 Ć 14 N.P.T.F. (Outlet)
16Ć1/16"
(408.0 mm)
3
Fluid Passage Volume . . . . . . . . . . . . . . 9.86 in. (0.162lit.)
Inlet / Outlet Port Size (female) . . . . . . . 1/2Ć 14 N.P.T.F. Ć 1
Weight . . . . . . . . . . . . . . . . . . . . . . . . . . 18 lbs (8.2kg)
3Ć3/4"
(95.3 mm)
8Ć13/16"
(223.8 mm)
GENERAL DESCRIPTION
The Aro stainless steel fluid heater models are wired for 120, 230 / 240
and 415 / 440 volt AC applications. The heating element is a 2000 watt
cartridge type and is thermostatically controlled. The wiring, heating
element and thermostat are protected by a preset heat limiter.
The thermostat is adjustable up to 250_ F (121_ C). The heater is off
when the thermostat knob is turned counterclockwise as far as posĆ
sible. The heater will not switch on until the knob is rotated to at least
ambient room temperature.
Fluid heaters have been tested in a water solution. Some of this fluid
may be left within the heater, therefore flush out this fluid with a solvent
compatible with the material to be pumped.
• This unit utilizes an explosionĆproof electrical section and internally
spiraling material section. The material enters the base under line
pressure from the pump and is heated and delivered thru to the maĆ
terial outlet at the top.
1/2 Ć 14 N.P.T.F. (Inlet)
R
FIGURE 1
OPERATING PRECAUTIONS
• Heed all warnings.
WARNING Do not exceed 5000 p.s.i. (35 MPa) maximum.
WARNING HIGH PRESSURE DEVICE. Improper usage of
this equipment could result in serious injury. The possibility of
injection into the flesh is a potential hazard. Never allow any
part of the human body to come in front of, or in direct contact
with, the material outlet. An injection injury can be serious. If
injection should occur, contact a qualified physician for immeĆ
diate treatment.
• This unit is CSA certified for Class I, Division 1, Group D, HazardĆ
ous Locations, Temperature Code (identification number) T3.
• Two or more paint heaters may be coupled together by plumbing
the material outlet of the first heater to the material inlet of the next,
etc. However, the distance of piping run between the units should
be limited to no more than three feet (see figure 4, page 4).
CAUTION Electrical supply power to the heater must be off
during flushing operation.
CAUTION Use only genuine Aro replacement parts to asĆ
sure compatible pressure rating and longest service life.
TYPICAL INSTALLATION
The heater inlet and outlet should be plumbed (up flow) as shown (see
figure 4, page 4), to minimize chances of trapped air inside the heater. If
the inlet and outlet are reversed (down flow), the temperature rise will
be different.
INGERSOLL-RAND COMPANY
P.O. BOX 151 D ONE ARO CENTER D BRYAN, OHIO 43506Ć0151
&
(419) 636-4242
D
FAX (419) 633-1674
E2001 D PRINTED IN U.S.A.
Download from Www.Somanuals.com. All Manuals Search And Download.
PARTS LIST / 651747-X-B
A
B
QTY
15
13 9, 8 D
1
3
2 H
ITEM DESCRIPTION (Size in inches)
PART NO.
: 1 14 Gauge Wire (12" long, black)
(1) 78140ĆXXXĆX
(6) Y99Ć678
(1) 78141ĆXXXĆX
(1) Y76Ć103ĆC
(1) 78143
2
Cap Screw (3/8" Ć 16 x 7/8")
: 3 14 Gauge Wire (12" long, red)
4
Machine Screw (#10 Ć 24 x 1/4")
36
5
Ring Terminal
: 6 14 Gauge Wire (7" long, green)
(1) 78142ĆXXXĆX
(1) Y227Ć5ĆL
(4) Y8Ć468ĆC
(4) Y22Ć6ĆC
(2) 92932
7
8
9
Pipe Plug (1/2 Ć 14 P.T.F.)
Machine Screw (#6 Ć 32 x 5/8")
Nut (#6 Ć 32)
5
6
35
10 Terminal Block
11 Lockwasher (#6)
12 Machine Screw (#6 Ć 32 x 1/4")
13 Mounting Plate
14 Thermometer (0_ Ć 250_ F)
15 Site Ring
7
14
11, 12 10
(4) Y1Ć6
A
B
(4) Y8Ć463ĆC
(1) 93583Ć1
(1) 91696
17
18
20
19 V
(1) 93588Ć1
(1) 29664
16 Retaining Ring
17 Adjusting Knob
18 Screw
16
(1) 93586Ć1
(1) 93585Ć1
(1) 93584Ć1
(1) 93587Ć1
(1) 93590Ć1
(1) 92974
4
21
19 Cap
29
28
20 Cover
1Ć11/16"
(42.9 mm)
21 Housing
22 Fluid Track
23 Cutoff Assembly
24 Heater Cartridge Assembly (+10% / Ć5%)
(1) 66834Ć1
27
Mounting Holes (2)
5/16 Ć 18 UNC Ć2B
1/2" (12.7 mm) deep
H 26
22
651747Ć1ĆB
651747Ć2ĆB
651747Ć3ĆB
(120 volt AC, 6.84 Ohms)
(1) 66751Ć1
(1) 66751Ć2
(1) 66751Ć3
(1) Y17Ć53
(3) Y99Ć63
(1) 93589Ć1
(230 / 240 volt AC, 27.36 Ohms)
(415 / 440 volt AC, 91.96 Ohms)
``B"
23
25 Pipe Plug (1/2 Ć 14 N.P.T.)
26 Cap Screw (3/8" Ć 16 x 1Ć1/4")
27 Retaining Ring
(ref.) 1
5
6
7
8
(ref.) 3
(ref.) 6
28 Indicator Lamp models 651747Ć1ĆB (120 volt AC) (1) 93591Ć1
models 651747Ć2ĆB (220 volt AC) (1) 93591Ć3
models 651747Ć3ĆB (440 volt AC) (1) 93591Ć5
View B Ć B
`
29 Thermostat (60_ Ć 250_ F) (20 amp. / 480 volt AC) (1) 92972
32
31
30
30 Terminal
: 31 14 Gauge Wire (6" long, black)
32 Terminal
(5) 78035
(2) 78140ĆXXXĆX
(2) 78143
33
34
1
2
3
4
33 Terminal
(2) 78034Ć1
(2) 78031
s 24
34 Terminal
35 Label
(1) 91081
``C"
25
View A Ć A
36 Mounting Plate
(1) 95634
: Available in bulk rolls only.
(24) Heater Cartridge
FIGURE 2
(28) Indicator Lamp
``B" Outlet (1/2Ć 14 N.P.T.F. Ć 1)
``C" Inlet (1/2Ć 14 N.P.T.F. Ć 1)
(6) Green
8
(23) Cutoff Assembly
(29) Thermostat
4
7
6
3
H
(2 and 26) Torque to 10 Ć 12 ft lbs (13.6 Ć 16.3 Nm).
(8) Apply Loctite 242 to threads.
(19) Apply Nickel antiĆseize to threads.
(24) Apply Watt Lube.
(3) Red
2
D
Input Line
(1) Black
V
5
1
s
` Apply Dow Corning 340 Silicone Heat Sink Compound.
Wiring Schematic
FIGURE 3
651747ĆXĆB
PAGE 3 OF4
Download from Www.Somanuals.com. All Manuals Search And Download.
TROUBLE SHOOTING
Fluid heater will not produce heat.
• No current to the heater unit.
Check the main power switch.
Check the power supply fuse, etc.
• Damaged thermostat.
Correct the wiring.
• Material buildĆup inside the heater.
Clean the fluid heater and material lines.
Inadequate material flow.
• Material buildĆup inside the heater.
Replace the thermostat.
• The heat limiter is burned out.
Clean the fluid heater and material lines.
Replace the heat limiter.
• The heat element is burned out.
Replace the heater cartridge element.
TYPICAL INSTALLATION
TYPICALSINGLE HEATER
TYPICAL DUAL HEATER
The temperature of the material is too low.
• The voltage to the heater is too low.
Correct the wiring.
``C"
• The thermostat is damaged.
``C"
Replace the thermostat.
• The thermostat setting is wrong.
Adjust the thermostat.
``A"
``A"
• Material buildĆup inside the heater.
Clean the fluid heater and material lines.
• The material flow is too fast.
Reduce the material flow.
``B"
``B"
The temperature of the material is too high.
• The thermostat is damaged.
Replace the thermostat.
``A" = Material Outlet
``B" = Material Inlet
``C" = Power In
• Wrong setting on the thermostat.
Reset the thermostat.
FIGURE 4
The heater takes too long to heat the material.
• The voltage is too low.
ACCESSORIES
66258 Mounting Bracket Assembly
6" (152.4 mm)
11/16" (17.5 mm)
2Ć1/4"
(57.2mm)
1Ć11/16"
(42.9 mm)
3/8" dia. (9.5 mm) 6x
FIGURE 5
PN 97999Ć557
651747ĆXĆB
PAGE 4 OF4
Download from Www.Somanuals.com. All Manuals Search And Download.
|