M3 STROLLERS
Keep this manual for future reference. If you sell this stroller or
give it away, make sure you give this manual to the new owner.
Ask them to read instructions completely.
Operating Instructions
Important:Read and follow these Safety Rules and Assembly Instructions before operating stroller. If
you have any questions concerning the safe use of this product, contact Pacific Cycle LLC at
Safety Rules:
WARNING: Failure to follow these warnings and assembly instructions could result in
serious injury or death.
Immediately discard any plastic wrapping.
Never allow children to fold, assemble, or disassemble the stroller.
Maximum weight capacity for the Single stroller is 50 lbs. or 22.7 kg. Excessive weight may cause a
hazardous, unstable condition if this load is exceeded. Maximum height of the child shall not exceed 38"
or 96 cm.
Never place child in stroller with their head forward and feet rearward.
Avoid serious injury from falling or sliding out. Always use seat belt.
Never leave child unattended.
Never use this stroller with roller or in-line skates.
Never allow stroller to be used as a toy or allow children to give rides to others.
Never use stroller if it becomes damaged.
Always be aware of traffic around you when walking.
Always engage brakes when you stop or when you let go of handle.
Accessories or parcels placed in or on the stroller may cause it to become unstable.
Maximum weight for objects in bottom basket is 5 lbs. or 2.2 kg. Excessive weight may cause a
hazardous, unstable condition.
Maximum weight for objects in rear zippered pouch is 1 lb. or .45 kg. Excessive weight may cause a
hazardous, unstable condition
To avoid burns, never put hot liquids in the parent or child tray. To prevent tipping over do not place
more than 2 lbs. or 1 kg on either the parent or child tray.
Child may slip into leg openings and strangle. Never use in a reclined carriage position unless T-shield/
waist strap placement has been readjusted.
Care must be taken when folding and unfolding the product to prevent finger entrapment.
IMPORTANT
We appreciate your purchase of one of our many fine products. We are sure that you will be satisfied
with your selection. We regret that although great care and effort have been taken, occasionally
problems may occur. PLEASE DO NOT RETURN PRODUCT TO THE STORE. To ensure prompt and
correct handling of problems, or to answer questions, please contact us at either our Toll-Free Customer
Service number or E-mail us at our address listed below. Service will be quicker if you have your model
number (found on the product and box) along with this instruction sheet ready when calling. If you have
any questions concerning the safe use of this product, please
contact us at 1-800-242-6110, and follow the prompts to our customer service representative, or E-mail
Tires are shipped deflated, DO NOT OVERINFLATE. Please inflate slowly, with short bursts, to 30-35
PSI maximum. 30 PSI will provide a comfortable ride for your child
Download from Www.Somanuals.com. All Manuals Search And Download.
Step 4. Front Wheel Assembly
While stroller is still tipped back, attach the front wheel by loosening the wheel’s quick release
(Q/R) lever on the front wheel far enough to allow the axle to slide into the front fork (Figure D1). The
front caliper brake Q/R lever should be in the open position so the front wheel can be inserted easily Into
the front fork . With wheel’s Q/R lever in open position, hand tighten the cone nut until
almost tight, then close the wheel’s Q/R lever to lock wheel in place. Note this step may require minor
adjustment until the Q/R lever flips back with firm pressure ( Figure D2 and D3). Pull outward
on wheel to ensure it is locked in place. Close the Q/R lever on the front caliper brake and spin the front
wheel to check if the brake pads are properly aligned and not rubbing on the rim. If brake pad alignment
is off, loosen the brake pad nut with an adjustable wrench, reposition pad and re-tighten the brake pad
nut (See Figure D1).
NOTE: The alignment of the front wheel determines if the stroller will roll straight or veer to the right or
left. In the event the stroller is veering to one direction, unloosen the front wheel’s Q/R lever, point the
wheel in the opposite direction it is veering and retighten wheel’s Q/R lever. This may require a very
slight adjustment to get your stroller rolling straight .
NOTE: The black hex nuts should be on the inside of the wheel next to the hub. These are factory set
and should not require adjusting (See Figure D3).
Adjusting the front side pull caliper brake
Properly adjusted brakes require attention to this detail. It is normal for the brake cable to stretch over a
period of time and you will find it necessary to periodically adjust the front brake. This can be done 2
ways: Micro adjustment- unloosen the locknut located next to the Micro adjustment screw, turn the micro
adjustment screw out to move brake pads closer to the rim then re-tighten locknut (See Figure D1).
Macro adjustment - unloosen the brake cable nut that holds the cable onto the caliper. With one hand
hold the brake pads next to the rim of the wheel with the other hand pull firmly on the brake cable below
the caliper brake While still holding the brake pads next to the rim re-tighten the nut with adjustable
wrench. Use the micro adjustment to fine tune the position of the pads to the rim which should be about
¼” from the rim. Check adjustment by squeezing the front brake lever (See Figure D4)
Brake
Pads
Brake Pad
Nut
Brake Pad
Nut
Closed
Open
Lock Nut
Micro Adjustment
Screw
Fig D1
Fig. D2
Brake Cable
Brake Cable
Nut
Wheel Q/R
Lever
Cone Nut
Black Hex Nut
(Do Not Adjust)
Brake Pad
Brake Cable
Fig. D3
Fig. D4
Download from Www.Somanuals.com. All Manuals Search And Download.
Step 5. Installing Parent’s
Convenience Tray
Parent Tray
Hole
Snap the parent tray onto the handle bar aligning the tray’s
holes with the handlebar’s knobs (Figure E).
Step 6. Installing optional Child Tray
(sold separately)
Handle Knob
Align the child tray onto the frame just below side latches,
Fig. E
Step 7. Installing optional Child booty cover (sold separately)
Undo the shoulder and waist straps from the stroller seat center buckle. Place the booty into the seat and insert
the shoulder, waist and crotch straps through the slits in the booty, snap the sides onto the bottom of the frame.
Place child into booty and adjust the restraint straps to a snug fit. Zipper close (Figure F1,F2).
Fig. F1
Fig. F2
Step 8. Adjusting the angle of the canopy and using the zipout weather-
shield.
Unsnap the canopy sides from the frame loosen the hook loop tab from center of console, rotate canopy to the
desired angle to help block the sun. Note the zipout weathershield should be zippered in when rotating the
canopy forward (FigureG1)
Unzip the canopy edge to expose the weathershield. Align the hook and loop of the inside flap so it does not
hang down in your child’s face. Loop the 2 hooks together under the front fender. When not in use roll up
weather shield into zippered area to store (Figure G2).
Canopy Tab
Canopy
Snaps
Fig. G1
Fig. G2
Download from Www.Somanuals.com. All Manuals Search And Download.
Use Instructions
WARNING: Always remove child from
stroller before folding.
To fold stroller:
IMPORTANT Pull the seatback forward toward the front fender prior to folding! Pull the one hand fold
handle located between the tray and handle of the stroller. The stroller will automatically begin to fold.
(Figure H). Continue folding/pushing frame together.
To engage rear brakes:
Step lightly on the center brake bar to engage brakes. To disengage, lift up on brake bar (Figure I).
DO NOT STAND ON REAR BRAKE BAR.
One
Hand Fold
Lever
Linked Rear Brakes
Fig. H
Fig. I
PROPER USE OF SEAT BELTS &
SHOULDER STRAPS:
WARNING: Avoid serious injury from falling
or sliding out. Always use seatbelt.
1. Place child in seat. Make sure T-strap is
between the child’s legs.
2. When child is seated, place shoulder straps
over the child’s shoulders and clip onto the
waist buckle.
Sternum
Strap
3. Buckle the waist straps into the center buckle
on the T-strap repeat for other side. Adjust the
T-Strap, waist and shoulder straps for snug fit
(Figure J).
Waist
Strap
Waist
Strap
Center
Buckle
Fig. J
To recline seat:
To fully recline, unhook buckle on back of the seat
(Figure K).
To place seat in upright position, push seat forward
and reconnect buckle located on back of seat.
To adjust the recline position, adjust the slide on
the strap.
WARNING: Child may slip into leg openings
and strangle. Never use in a reclined carriage
position unless T-shield and shoulder
straps have been readjusted to the new
seat position.
Fig. K
Download from Www.Somanuals.com. All Manuals Search And Download.
To adjust handle height:
While pushing the handle buttons in rotate handle
to the desired height (Figure L).
Fig. L
Care and Maintenance
Check fasteners
After one hour of use, check all fasteners to make sure they are secure. Adjust if necessary.
Periodically check the stroller and fasteners to ensure that it is in good operating condition.
To clean seat and canopy:
If light cleaning is required, use a soft cloth with warm water and mild soap, then air dry. Do not put into
washing machine. Do not put in dryer. DO NOT BLEACH.
To clean frame:
Wipe using a soft cloth with warm water and mild soap. Air dry. DO NOT USE polish or abrasives.
If you have any questions concerning the safe use of this product, please contact Pacific Cycle LLC
before using:
and Schwinn are registered trademarks of
Pacific Cycle LLC. Please direct all inquiries to:
TEL 1-800-242-6110
FAX 1-800-858-2800
Download from Www.Somanuals.com. All Manuals Search And Download.
|