| USER’S GUIDE   V:1036-0209-10   ICP200B   Clock Radio for iPhone/iPod   Download from Www.Somanuals.com. All Manuals Search And Download.   fcc Warnings   NOTE: This equipment has been tested and found to comply with   the limits for a Class B digital device, pursuant to Part 15 of the FCC   Rules. These limits are designed to provide reasonable protection   against harmful interference in a residential installation. This equip-   ment generates, uses, and can radiate radio frequency energy and, if   not installed and used in accordance with the instructions, may cause   harmful interference to radio communications. However, there is no   guarantee that interference will not occur in a particular installation.   If this equipment does cause harmful interference to radio or televi-   sion reception, which can be determined by turning the equipment   off and on, the user is encouraged to try to correct the interference   by one or more of the following measures:   • • • Reorient or relocate the receiving antenna.   Increase the separation between the equipment and receiver.   Connect the equipment into an outlet on a circuit different from   that to which the receiver is connected.   • Consult the dealer or an experienced radio/TV technician for   help.   additional Warnings   • The apparatus shall not be exposed to dripping or splashing and   that no objects filled with liquids, such as vases, shall be placed   on apparatus.   L’appareil ne doit pas être exposé aux écoulements ou aux écla-   boussures et aucun objet ne contenant de liquide, tel qu’un vase,   ne doit être placé sur l’objet.   • Main plug is used as disconnect device and it should remain   readily operable during intended use. In order to disconnect the   apparatus from the mains completely, the mains plug should be   disconnected form the mains socket outlet completely.   La prise du secteur ne doit pas être obstruée ou doit être facile-   ment accessible pendant son utilisation. Pour être complètement   déconnecté de l’alimentation d’entrée, la prise doit être débran-   chée du secteur.   • • Battery shall not be exposed to excessive heat such as sunshine,   fire or the like.   Les piles ne doivent pas être exposées à de forte chaleur, tel qu’à   la lumière du soleil, au feu ou autres choses de semblable.   The marking information is located on the bottom of apparatus.   Les précautions d’emploi sont inscrites en bas de l’appareil.   CUstOmeR HeLPLINe | 1-314-621-2881   iLive | ICP200B   3 Download from Www.Somanuals.com. All Manuals Search And Download.   clock radio With dock for iPod and iPhone   features   • Works with iPhone   • Made for iPod   • FM radio   • Station memory presets (20 FM)   • Dual alarms   • Digital clock   • Snooze   • Sleep timer   • Wake to iPhone/iPod, radio, or buzzer   • Gradual wake   • Line input (3.5mm)   • Video output   • Basic iPhone/iPod controls   • Built-in speakers   • White dot-matrix display   • Supports Universal docking brackets   • DC power input: requires an AC/DC power adapter (included)   • Battery backup   included   • ICP200B   • Docking brackets for iPhone/iPod (5)   • AC/DC power adapter   4 iLive | ICP200B   Download from Www.Somanuals.com. All Manuals Search And Download.   taBle of contents   introduction   6 setuP   8 iPod/iPhone and radio   9 clock and alarms   other   10   11   12   comPany information   CUstOmeR HeLPLINe | 1-314-621-2881   iLive | ICP200B   5 Download from Www.Somanuals.com. All Manuals Search And Download.   introduction   Play/Pause   Press to play or pause a   docked iPhone or iPod.   clock/alarm set   In off mode, press to set   the clock. In on mode,   press to set the alarm.   sleeP   Press repeatedly to set   the sleep timer.   mem   Press and hold to save   the current radio station   as a preset. Press to   cycle through current   radio presets.   PoWer/source   Press to power the clock   radio on. Press and hold   to power the clock radio   off. While on, press to   switch between Radio,   iPod, and AUX modes.   dock for iPod/iPhone   Plays and charges a   docked iPhone or iPod.   alarm   Press to activate alarm 1   or alarm 2.   POWER/   SOURCE   CLOCK/ALARM   SET   SLEEP   PLAY/PAUSE   MEM   ALARM   – TUNE/HR +   VOLUME/MIN   SNOOZE/DIM   skiP/search/   tuning/hr   snooZe/dim   After the alarm sounds,   press to delay the alarm   for an additional 10   minutes.   Volume/min (+/-)   Press to adjust the   volume. Press to adjust   the minute when   setting the time or   alarm time.   Press to skip between   tracks on a docked   iPhone or iPod. Press   and hold to search   through an individual   track on a docked   iPhone or iPod.   Press to tune the FM   radio. Press to adjust   the hour when setting   the time or alarm time.   6 iLive | ICP200B   Download from Www.Somanuals.com. All Manuals Search And Download.   reset   Video outPut   Use to output video   form a docked iPhone   or iPod to a connected   television.   fm antenna   Press to reset the clock   radio to it’s original   settings.   dc PoWer inPut   auXiliary inPut   Use to connect an MP3   player to the clock   radio.   CUstOmeR HeLPLINe | 1-314-621-2881   iLive | ICP200B   7 Download from Www.Somanuals.com. All Manuals Search And Download.   setuP   PoWer   Plug the included AC/DC power   adapter into the DC POWER   INPUT on the clock radio and an   AC power outlet to power the   clock radio   BackuP Battery   Requires 2 AAA batteries (not   included)   The backup battery is meant for   short-term power outages.   The clock radio cannot run off of   the backup alone.   8 iLive | ICP200B   Download from Www.Somanuals.com. All Manuals Search And Download.   iPod/iPhone and radio   tuning the fm radio   docking an iPhone or iPod   1 2 3 Press the PoWer/source button   to power on the clock radio.   1 Locate the numbered bracket   that fits the iPod/iPhone   model that will be docked.   Each included bracket has a   number on it, indicating which   iPod/iPhone model that bracket   is compatible with. See the   Press the PoWer/source button   to switch to RADIO mode.   Press the skiP/search/tuning/   hr buttons to tune the FM radio.   saVing a Preset   separate bracket chart page to   identify which bracket is needed.   1 Follow the instructions for TUNING   THE FM RADIO.   2 Snap the bracket into   place over the iPod/iPhone   connector in the dock for iPod/   iPhone.   3 Connect the iPhone or iPod to   the connector inside the Dock   for iPod.   When the speaker is plugged   in, using AC power, the docked   iPod/iPhone will charge.   2 Tune to the desired station, and   press and hold the mem button.   The preset channel number will begin   to blink.   3 4 Press the mem button to select a   preset channel to save the current   radio station to.   Press and hold the mem button to   save the current radio station to the   selected preset channel.   listening to a Preset   Playing an iPhone or iPod   1 Follow the instructions for SAVING   A PRESET.   1 Follow the instructions for   DOCKING AN iPod.   2 Press the mem button to cycle   through FM radio presets.   2 Press the PoWer/source   button to switch to iPod mode.   3 Press the Play/Pause button   to begin playing music from   the docked iPhone or iPod.   CUstOmeR HeLPLINe | 1-314-621-2881   iLive | ICP200B   9 Download from Www.Somanuals.com. All Manuals Search And Download.   clock and alarms   setting the clock   setting the alarms   1 Press and hold the   PoWer/source   button to power the   clock radio off.   1 Press the PoWer/source button to power the   clock radio on.   2 Press the clock/alarm set button.   The time on the display will begin to blink and AL1   will appear to indicate you are setting alarm 1.   2 3 Press the clock/   alarm set button.   3 4 Press the PoWer/source button to switch   between waking to iPod, Radio, or Buzzer.   Press the skiP/   search/tuning/   hr buttons to adjust   the hour. Press   the Volume/min   buttons to adjust the   minute.   Press the skiP/search/tuning/hr buttons to   adjust the hour. Press the Volume/min buttons   to adjust the minute.   5 Press the clock/alarm set button.   The time on the display will begin to blink and AL2   will appear to indicate you are setting alarm 2.   4 Press the clock/   alarm set button   to finish setting the   clock and alarms.   6 7 Press the PoWer/source button to switch   between waking to iPod, Radio, or Buzzer.   Press the skiP/search/tuning/hr buttons to   adjust the hour. Press the Volume/min buttons   to adjust the minute.   8 9 Press the clock/alarm set button to set the   volume.   The volume indicator on the display will begin   flashing.   Press the clock/alarm set button to finish   setting the alarms.   actiVating the alarms   1 2 3 Follow the instructions for SETTING THE CLOCK   AND ALARMS.   Press the PoWer/source button to turn the   clock radio off.   Press the alarm button repeatedly to activate   alarm 1, alarm 2, or both alarms.   When the AL1 or AL2 indicator appears on the   display, that alarm is active and will sound at the set   alarm time.   10 iLive | ICP200B   Download from Www.Somanuals.com. All Manuals Search And Download.   other   using the auX inPut   sleeP timer   1 With the clock radio powered   on and playing, press the sleeP   button repeatedly to set the sleep   timer.   1 Connect an MP3 player or other   audio source to the auXiliary   inPut using a 3.5mm line input   cable (not included).   2 After the set amount of time   has expired, the clock radio will   automatically power off.   2 3 Press the PoWer/source button   to switch to AUX mode.   Use the connected MP3 player   or other audio source’s native   controls to play music through the   boombox.   setting the dimmer   1 Press the snooZe/dim button   repeatedly to adjust the brightness   of the display.   using the Video outPut   1 Connect a television to the Video   outPut using a RCA video cable   (not included).   2 Adjust the connected television   to the input setting used when   connecting the television to the   clock radio.   3 4 Adjust the settings on your iPod or   iPhone to allow TV OUT.   Video played from a docked iPhone   or iPod will now play through the   connected television.   CUstOmeR HeLPLINe | 1-314-621-2881   iLive | ICP200B 11   Download from Www.Somanuals.com. All Manuals Search And Download.   comPany information   green initiatiVe   environmental Commitment to ‘Protect for   today and sustain for tomorrow’   2009 marked the official launch of DPI, Inc.’s   corporate campaign for a greener and cleaner   world. DPI is building upon environmental   initiatives introduced at all of their facilities to help   formulate and sustain significant and important   conservation efforts within its manufacturing and   marketing communities. In addition to targeting   and selecting energy efficient product features, and   structuring ‘green office’ procedures, other initial   program efforts include:   • • Reduction of all packaging sizes   Recyclable plastics for clamshell packages,   with a plan to eventually replace plastic with   recyclable paper   • • Recycled fiber board in place of the polyfoam in   packing boxes   Recycled plastics in place of the virgin material   in product construction   international suPPort   To download this User’s Guide in English,   Spanish, or French, visit the support section at   Para transferir esta guía de usuario en inglés,   español, o francés, visite la sección de la ayuda en   Pour télécharger ce guide de l’utilisateur en   anglais, espagnol, ou français, visitez la section de   contact information   Address: 2116 Carr Street, St. Louis MO, 63106   Phone: 1-314-621-2881   Fax: 1-314-588-1805   Email: [email protected]   Parts Email: [email protected]   © 2009 Digital Products International (DPI, Inc.) | All other trademarks appearing herein are the property of their respective owners.   Specifications are subject to change without notice   Download from Www.Somanuals.com. All Manuals Search And Download.   |