NOTE:
Please read all instructions
carefully before using this
product
Table of Contents
Safety Notice
Hardware Pack
Assembly Instruction
Parts List
MARCY WEIGHT BENCH
MWB-214
Warranty
Ordering Parts
Model
MWB 214
Retain This
Manual for
Reference
100503
IMPEX® INC.
2801 S. Towne Ave., Pomona, CA 91766
Tel: (800) 999-8899 Fax: (626) 961-9966
OWNER'S
MANUAL
Download from Www.Somanuals.com. All Manuals Search And Download.
IMPORTANT SAFETY NOTICE
PRECAUTIONS
This exercise machine is built for optimum safety. However, certain precautions apply
whenever you operate a piece of exercise equipment. Be sure to read the entire manual
before you assemble or operate your machine. In particular, note the following safety
precautions:
1. Keep children and pets away from the machine at all times. DO NOT
leave children unattended in the same room with the machine.
2. Only one person at a time should use the machine.
3. If the user experiences dizziness, nausea, chest pain, or any other abnormal
symptoms, STOP the workout at once. CONSULT A PHYSICIAN IMMEDIATELY.
4. Position the machine on a clear, leveled surface. DO NOT use the machine
near water or outdoors.
5. Keep hands away from all moving parts.
6. Always wear appropriate workout clothing when exercising. DO NOT wear
robes or other clothing that could become caught in the machine. Running
or aerobic shoes are also required when using the machine.
7. Use the machine only for its intended use as described in this manual. DO
NOT use attachments not recommended by the manufacturer.
8. Do not place any sharp object around the machine.
9. Disabled person should not use the machine without a qualified person or
physician in attendance.
10. Before using the machine to exercise, always do stretching exercises to
properly warm up.
11. Never operate the machine if the machine is not functioning properly.
12. A spotter is recommended during exercise.
CARE AND MAINTENANCE
1. Inspect and tighten all parts before using the machine.
2. The machine can be cleaned using a damp cloth and mild non-abrasive detergent.
DO NOT use solvents.
3. Maximum weight capacity on the uprights: 300 lbs.
4. Maximum user’s weight: 250 lbs.
5. Maximum weight capacity on the leg developer: 100 lbs.
WARNING: BEFORE BEGINNING ANY EXERCISE PROGRAM, CONSULT YOUR
PHYSICIAN. THIS IS ESPECIALLY IMPORTANT FOR INDIVIDUALS OVER THE
AGE OF 35 OR PERSONS WITH PRE-EXISTING HEALTH PROBLEMS. READ
ALL INSTRUCTIONS BEFORE USING ANY FITNESS EQUIPMENT. IMPEX INC.
ASSUMES NO RESPONSIBILITY FOR PERSONAL INJURY OR PROPERTY
DAMAGE SUSTAINED BY OR THROUGH THE USE OF THIS PRODUCT.
SAVE THESE INSTRUCTIONS.
2
Download from Www.Somanuals.com. All Manuals Search And Download.
WRANING LABEL PLACEMENT
The warning label shown here have been placed on the Cross Brace. If the label is missing or illegible,
please call customer service at 1-800-888-8899 for replacements. Apply the label in the location shown.
3
Download from Www.Somanuals.com. All Manuals Search And Download.
Hardware Pack
NOTE: The following parts are not drawn to scale. Please use your own ruler or scale to measure the size.
4
Download from Www.Somanuals.com. All Manuals Search And Download.
ASSEMBLY INSTRUCTION
Tools Required for Assembling the Machine: Two Adjustable Wrenches.
NOTE: It is strongly recommended that two or more people assemble this machine
to avoid possible injury.
STEP 1 (See Diagram 1)
A.) Connect the two Upright Beams (#1) by a Cross Brace (#2) in the mid-span.
B.) Secure each end of Cross Brace to each Upright Beam with two M8 x 2 ½” Hex Bolts
(#20), one Bracket (#10), two Ø 5/8” Washers (#26), and two M8 Aircraft Nuts (#24).
C.) Insert the Backrest Adjustment Bar (#11) through the selected holes on the Upright
Beams to obtain desired incline position.
DIAGRAM 1
5
Download from Www.Somanuals.com. All Manuals Search And Download.
STEP 2 (See Diagram 2)
A.) Attach the Front Support (#5) to Main Seat Support (#3). Secure it with one M8 x 1 5/8”
Carriage Bolt (#28), one Ø 5/8” Washer (#26), and one M8 Aircraft Nut (#24). Do not
tighten the Nut and Bolt until instructed to do so.
B.) Attach the other end of Main Seat Support to the Cross Brace (#2). Secure it with four
M8 x 2 3/8” Hex Bolts (#18), one Bracket (#10), four Ø 5/8” Washers (#26), and four M8
Aircraft Nuts (#24).
C.)Attach the Diagonal Support (#4) to the Main Seat Support. Secure it with one M8 x 1
¾” Carriage Bolt (#29), one Ø 5/8” Washer (#26), and one M8 Aircraft Nut (#24).
D.)Attach the other end of Diagonal Support to the Front Support. Secure it with one M8 x
3/5” Hex Bolt (#38) and one Ø 5/8” Washer (#26).
E.) Securely tighten all Nuts and Bolts.
DIAGRAM 2
6
Download from Www.Somanuals.com. All Manuals Search And Download.
STEP 3 (See Diagram 3)
A.) Attach the Leg Developer (#6) to the open bracket on the Front Support (#5). Secure it
with one M10 x 2 3/8” Hex Bolt (#21), one Ø ¾” Washer (#31), and one M10 Aircraft
Nut (#27).
B.) Insert two Foam Tubes (#13) half way through the holes on the Leg Developer.
C.)Push four Foam Rolls (#12) onto the Foam Tubes.
D.)Attach the Arm Curl Pad (#16) to the Arm Curl Stand (#17). Secure it with two M8 x ¾”
Hex Bolts (#37) and two Ø 5/8” Washers (#26).
E.) Insert the Arm Curl Stand into the opening on Front Post and use the Lock Knob (#39)
to obtain desired height for Arm Curl exercise.
DIAGRAM 3
7
Download from Www.Somanuals.com. All Manuals Search And Download.
STEP 4 (See Diagram 4)
A.) Attach the side-holes on the two Backrest Supports (#7) to the pivot on the Main
Seat Support (#3). Place the other end of the Backrest Supports against the
Backrest Adjustment Bar (#11).
B.) Attach the Backrest Board (#8) to the Backrest Supports. Secure it with four M6 x 1
5/8” Hex Bolts (#23) and Ø ½” Washers (#25).
C.)Place the Seat Pad (#9) onto the Main Seat Support. Secure it with four M6 x 5/8”
Hex Bolts (#22) and Ø ½” Washers (#25).
DIAGRAM 4
8
Download from Www.Somanuals.com. All Manuals Search And Download.
9
Download from Www.Somanuals.com. All Manuals Search And Download.
PARTS LIST
KEY NO.
DESCRIPTION
Q’ty
1
2
3
4
5
6
7
8
Upright Beam
Cross Brace
2
1
1
1
1
1
2
1
1
3
1
4
2
4
6
1
1
4
2
4
1
4
4
10
8
13
1
1
1
2
1
2
2
2
3
1
2
1
1
1
Main Seat Support
Diagonal Support
Front Support
Leg Developer
Backrest Support
Backrest Board
Seat Pad
Bracket
Backrest Adjustment Bar
Foam Roll
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
Foam Tube
Ø ¾” End Cap
Ø 1” End Cap
Arm Curl Pad
Arm Curl Stand
M8 x 2 3/8” Hex Bolt
1” Square End Cap
M8 x 2 ½” Hex Bolt
M10 x 2 3/8” Hex Bolt
M6 x 5/8” Hex Bolt
M6 x 1 5/8” Hex Bolt
M8 Aircraft Nut
½” Washer
5/8” Washer
M10 Aircraft Nut
M8 x 1 5/8” Carriage Bolt
M8 x 1 ¾” Carriage Bolt
1 ½” Square End Cap
Ø ¾” Washer
Weight Plate 25#
Weight Plate 15#
Weight Plate 10#
Spring Clip
Weight Bar
M8 x ¾” Hex Bolt
M8 x 3/8” Hex Bolt
Lock Knob
Sleeve
10
Download from Www.Somanuals.com. All Manuals Search And Download.
IMPEX® INC.
LIMITED WARRANTY
IMPEX Inc. ("IMPEX®") warrants this product to be free from defects in workmanship and material, under
normal use and service conditions, for a period of two years on the Frame from the date of purchase. This
warranty extends only to the original purchaser.
replacing or repairing, at IMPEX's option.
IMPEX's obligation under this Warranty is limited to
All returns must be pre-authorized by IMPEX. Pre-authorization may be obtained by calling IMPEX Customer
Service Department at 1-800-999-8899. The customer must prepay all freights on products returned to
IMPEX. This warranty does not extend to any product or damage to a product caused by or attributable to
freight damage, abuse, misuse, improper or abnormal usage. No other warranty beyond that specifically set
forth above is authorized by IMPEX.
IMPEX is not responsible or liable for indirect, special or consequential damages arising out of or in
connection with the use or performance of the product or other damages with respect to any economic loss,
loss of property, loss of revenues or profits, loss of enjoyments or use, costs of removal, installation or other
consequential damages or whatsoever natures. Some states do not allow the exclusion or limitation of
incidental or consequential damages. Accordingly, the above limitation may not apply to you.
The warranty extended hereunder is in lieu of any and all other warranties and any implied warranties of
merchantability or fitness for a particular purpose is limited in its scope and duration to the terms set forth
herein. Some states do not allow limitations on how long an implied warranty lasts. Accordingly, the above
limitation may not apply to you.
This warranty gives you specific legal right. You may also have other rights, which vary from state to state.
IMPEX® INC.
2801 S. Towne Ave.
Pomona, CA 91766
ORDERING REPLACEMENT PARTS
Replacement parts can be ordered by calling our Customer Service Department toll-free at 1-800-999-8899
during our regular business hours: Monday through Friday, 9 am until 5 pm Pacific standard time.
When ordering replacement parts, always give the following information.
1.
2.
3.
4.
Model
Description of Parts
Part Number
Date of Purchase
11
Download from Www.Somanuals.com. All Manuals Search And Download.
|