| 	
		 If you have any questions regarding our products, call our   
					toll-free consumer customer service line: 800.643.3522   
					
					Tri-Beam® Arc Hammock Stand   
					Congratulations on your purchase of the Tri-Beam® Arc Hammock Stand.   
					We believe that you will find it a product of unsurpassed quality and durability.   
					Parts included to assemble your   
					Tri-Beam Arc Hammock Stand:   
					2 - Foot poles   
					2 - End sections   
					1 - Center section   
					Hardware Included:   
					4 - Bolts - 1/4”   
					4 - Flat Washers   
					2 - 1” Washers   
					4 - Nuts with Nylon Threadlocker - 1/4”   
					2 - “Z” Hooks   
					Tools needed to assemble your Tri-Beam® Arc that are NOT included: Phillips Screwdriver   
					NOTE: Two people may be needed for assembly.   
					ASSEMBLY INSTRUCTIONS:   
					1. Lay all hammock stand pieces on a flat surface.   
					2. Ensure that spring pins are inserted in both small ends of center section. Attach one foot bracket to an end   
					pole. Match welded bracket on the end section to the welded bracket on the foot pole. Place 1/4” bolts   
					through holes on either side of the end section through welded brackets. Assemble washer and add nuts to   
					the bolts. Make sure washer is on nut side of the bolt. Tighten securely.   
					See Figure 1.   
					3. Attach remaining foot bracket to remaining end pole. Match welded   
					bracket on the end pole to the welded bracket on the foot pole. Place   
					1/4” bolts through holes on either side of the end section through welded   
					brackets. Assemble washer and add nuts to the bolts. Make sure washer   
					is on nut side of the bolt. Tighten securely. See Figure 1.   
					4. Attach end poles to center poles by aligning poles and depressing   
					spring pin as you insert small end of center pole into end pole. Make sure   
					the spring pin is fully engaged.   
					5. Place center pole onto end foot assembly by affixing 5 x 1/2” bolt   
					through center of pole and bracket. See Figure 1. Assemble washer and   
					add nut to the bolt. Make sure washer is on nut   
					side of the bolt. Tighten securely.   
					Figure 1.   
					6. Attach “Z” hooks and hang hammock at comfortable height.   
					CAUTIONS:   
					Use caution when lying in your hammock. Position your body in the center of the hammock and lower yourself   
					gently. The hammock ropes will stretch with use and should be checked routinely and hammock lengths taken   
					in as needed.   
					- DO NOT ALLOW CHILDREN TO USE THE HAMMOCK WITHOUT DIRECT ADULT SUPERVISION.   
					- DO NOT EXCEED LOAD LIMIT OF 450 LBS.   
					WARRANTY INFORMATION:   
					Products of The HammockSource are guaranteed to be free of defects in workmanship and materials for up to one year after the purchase date. Prolonged exposure to   
					weather conditions including snow, rain, and humidity are not covered under the warranty nor is damage caused by normal wear, mildew, or improper care including storage,   
					maintenance, and installation. If an item is found to be defective within one year of its purchase, it will be replaced without charge upon the return of the unit accompanied   
					by a sales receipt. If you choose to return an item, you must contact our customer service department at 800.643.3522 to obtain a Return Authorization Number that will   
					allow us to track your unit once it arrives at our warehouse; thereby creating a faster response to your concern.   
					5186   
					T.OJ   
					Download from Www.Somanuals.com. All Manuals Search And Download.   
				 |