Beverage Cooler
Model: BC-80E/110E
User's Manual
Download from Www.Somanuals.com. All Manuals Search And Download.
Please save these instructions.
Danger!
Risk of child entrapment. Before you discard your old cabinet, take off the
doors so that children may not easily climb inside.
Thank you for using our product. This
Model number
Serial number
Date of purchase
manual will guide you in getting the
best use of your cabinet.
Remember to record the model and se-
rial number. They are on a label in
back of the cabinet.
Staple your receipt to your manual. You will need it to obtain war-
ranty service.
2
Download from Www.Somanuals.com. All Manuals Search And Download.
Table of contents
Safety precautions
Parts
1
4
Installation
5
Unpacking
5
Leveling
5
Proper air circulation
Electrical requirements
Features and use
Initial set up
6
6
7
7
Temperature adjustment
Shelving
7
8
Interior light
8
Normal operating sounds
Proper care and cleaning
Cleaning and maintenance
Power interruptions
Vacation and moving care
Lamp replacement
Troubleshooting
8
9
9
10
10
11
12
3
Download from Www.Somanuals.com. All Manuals Search And Download.
Parts
2
3
1
4
6
5
1. Lamp shade
2. Thermostat knob
3. Light switch
4. Handle
5. Leveling bolt
6. Shelf
4
Download from Www.Somanuals.com. All Manuals Search And Download.
Installation
Unpacking
1. Remove all packaging material, including the foam base
and all adhesive tape holding the cabinet accessories
inside and outside. Slide out and remove plastic or foam
guard used to secure the compressor from shipping dam-
age due to vibration and shock.
2. Inspect and remove any remains of packing, tape or
printed materials before powering on the cabinet.
Leveling
Your cabinet has 4 leveling bolts located in the front
and rear corners of your cabinet. After properly placing
your cabinet in its final position, you can level your
cabinet.
Leveling bolts can be adjusted by turning clockwise to
raise or counterclockwise to lower your cabinet. The
cabinet door will close more easily when the leveling
bolts are extended.
5
Download from Www.Somanuals.com. All Manuals Search And Download.
Proper air circulation
To assure your cabinet works at the maximum efficiency it was
designed for, you should install it in a location where there is
proper air circulation, plumbing and electrical connections.
The following are recommended clearances around the cabinet:
Sides: 2" (50mm)
Top: 2" (50mm)
Back: 2" (50mm)
Do not over fill your cabinet for proper internal air circulation.
Electrical requirements
Make sure there is a suitable power outlet (115V, 60Hz) with
proper grounding to power the cabinet.
Avoid using 3 plug adapters or cutting off the third grounding in
order to accommodate a 2 plug outlet. This is a dangerous prac-
tice since it provides no effective grounding for the cabinet and
may result in shock hazard.
Install limitations
Do not install your cabinet in any location not properly insu-
lated or heated. Your cabinet is not designed to operate in tem-
perature settings below 53.6°F.
Locate the cabinet on a hard and flat surface away from direct
sunlight or heat source, e.g. radiators, baseboard heaters, cook-
ing appliances etc. Any floor unevenness should be corrected
by leveling legs located on the front and rear bottom corners of
the cabinet.
Your cabinet is designed for free-standing installation only, not
for built-in application.
6
Download from Www.Somanuals.com. All Manuals Search And Download.
Features and use
Temperature adjustments
The temperature in the cabinet is controlled by the ther-
mostat according to the ambient temperature and con-
dition of the food in storage. The thermostat knob can
be rotated clockwise or counter-clockwise between the
scale of "0" and "6" (The numerals do not represent
temperature degree, but temperature changes. With the
value decreasing or increasing, the temperature in the
refrigerator will go up or down, respectively. If scale
"0" is selected, the appliance will cease operation), It is
recommended that the thermostat be set to position "3"
or "4" typical climate conditions, then closer to "0" in
summer and to "6" in winter.
Verify that the thermostat is properly set before setup
and should not be adjusted unless necessary.
7
Download from Www.Somanuals.com. All Manuals Search And Download.
Shelf
The shelves are designed for both aesthetics and cleaning
efficiency. The shelves can be removed and relocated. Especially,
these shelves prevent bottles from contacting the evaporator.
Light
For the sake of decoration and practical operation, a mild light
bulb is installed in the cabinet. The light is controlled by the
switch on the fan shield.
Normal operating sounds
Boiling water, gurgling sounds or slight vibrations that are the
result of the refrigerant circulating through the cooling coils.
The thermostat control will click when it cycles on and off.
8
Download from Www.Somanuals.com. All Manuals Search And Download.
Proper care and cleaning
Cleaning and maintenance
Warning:
Caution:
To avoid electric shock, always unplug your
cabinet before cleaning. Ignoring this warning
may result in fatal or serious injuries.
Before using cleaning products, always read
and follow manufacturer's instructions and
warnings to avoid personal injury or product
damage.
General:
Prepare a cleaning solution of 3-4 table-
spoons of baking soda mixed with warm
water. Use sponge or soft cloth dampened
with the cleaning solution to wipe your
cabinet.
Rinse with clean arm water and dry with a
soft cloth.
Do not use harsh chemicals, abrasives,
ammonia, chlorine bleach, concentrated
detergents, solvents or metal scouring pads.
Some of these chemicals may dissolve, dam-
age and/or discolor your cabinet.
9
Download from Www.Somanuals.com. All Manuals Search And Download.
Door gasket:
Clean the door gasket once every three months to keep it clean
and pliable for proper seal.
Power interruptions
When occasionally power supply is interrupted due to thunder-
storms or other causes, remove the power cord from the outlet.
When power has been restored, plug the power cord to the outlet.
Vacation and moving care
For long vacations or absences, unplug the cabinet and clean the
cabinet and door gaskets according to "General cleaning" section.
The cabinet is always moved vertically to avoid possible dam-
age to the sealed system.
Attention should be paid to avoid damage of the cooling tubes
and refrigerant leaks. Connect the appliance to the power source
24 hours later.
10
Download from Www.Somanuals.com. All Manuals Search And Download.
Lamp replacement
Lug
Holder
step 2
step 3
Lamp holder
Lamp tube
Lamp cover
step 1
step 4
1. Loosen the lug slightly and remove the lampshade. (Step 1)
2. Remove the U lamp tube from the holder. (Step 2)
3. Place a new lamp tube to the holder. (Step 3)
4. Replace the lampshade. (Step 4)
11
Download from Www.Somanuals.com. All Manuals Search And Download.
Troubleshooting
Cabinet does not operate.
Verify if the cabinet is properly plugged in.
Verify if the power is supplied.
Inside temperature appears too high.
Frequent door openings.
Short storage period
Verify if the gaskets is in good condition
The condenser coils need cleaning.
Verify if the thermostat is properly adjusted.
Cabinet temperature is too cold.
Verify if temperature control setting is too cold.
Cabinet runs too frequently.
This may be normal to maintain constant temperature during
high temperature and humid days.
Doors may have been opened frequently or for an extended pe-
riod of time.
Clean condenser coils.
Check gasket for proper seal.
Check to see if doors are completely closed.
12
Download from Www.Somanuals.com. All Manuals Search And Download.
Moisture buildup on interior or exterior of
the door.
This is normal during high humidity periods.
Prolonged or frequent door openings.
Check door gaskets for proper seal.
Cabinet door does not shut properly.
Level the cabinet.
Check for blockages e.g. beverage bottles, shelves.
13
Download from Www.Somanuals.com. All Manuals Search And Download.
Download from Www.Somanuals.com. All Manuals Search And Download.
|