Installation Type 1:
Installation Type 2a:
Introduction
Vehicles supporting multiple CD changers
and equipped with a CD changer
• Audi A4/S4/RS4/A5/A6/S6/RS6/A8/Q7
with MMI-2 High (colour)
Gateway 500 emulates a CD changer and uses CD changer controls to access
offboard audio sources including iPod, USB devices and Dension Gateway
accessories. If your car is not already equipped with a CD changer, it may be
necessary to have the car programmed by your dealer in order to use the
GW500 with it.
Vehicles with an existing CD changer
These vehicles allow selection of Gateway audio sources and
the original CD changer by switching the mode between CD
Changer and Gateway mode.
These vehicles allow selection of Gateway audio sources
and the original CD changer through the existing car audio
controls.
Programming the car for GW500
INSTALL GUIDE
Audi
No programming required
BMW non iDrive-4
If original CD changer fitted and MP3 capability is available: no programming
is required.
ice4Link Gateway 500 MOST
Set the DIP switches to the following
position and install the Gateway
500 as illustrated below:
If original CD changer fitted and no MP3 capability is available:
a) Retrofit “KMP3”option with service computer
b) Used in non text capable BMW mode
CDC side
Car side
1a.
If original CD changer not fitted or E60 M-ASK used: install GW500 and retrofit
“IPOD”option with service computer
CDC
BMW with iDrive-4
If original CD changer fitted: no programming is required
If original CD changer not fitted: install an original BMW CD changer and
retrofit “CD Changer”temporarily option with service computer
Remove the blue locking clip from the
middle of the fibre optic housing.
Mercedes
Generally no programming is required but in some cases (e.g. no device was
connected onto the optical ring) it is needed to enable a CD changer with the
service computer.
1b.
Porsche
Generally it is needed to enable a CD changer with the service computer but
in rare cases the PCM accept the GW500 without this enabling process.
Strain the hook carefully with a
sharp tool, while pulling out the
optical fibre from the housing.
Saab 9-3
It is needed to enable a CD changer with the service computer using an
original CD changer.
Audi (MMI-2 Basic Monochrome)
1c.
Package Content & Electrical Installation
Text capable BMW E87, E90, E91, E92, E93,
E60/61, E63/E64, E65/E66 (03/2005-), E70
and Mini (non iDrive-4)
DIP switch
Car side
Non text capable BMW E65/E66 (-03/2005)
(non iDrive-4)
State of the art car integration
for media players, USB and
Bluetooth devices
3.
Car side
BMW E90, E91, E92, E93 with iDrive-4
3
CDC side
1
Mercedes (NTG1-, NTG2- Audio 20/50 and
Comand)
2
4
Power
Porsche (CDR 23/24 and PCM I/II/2.1)
for longer CDC and car side cable use
harness
GW5-9210-8
CDR
PCM
FOA1PO1
Power harness:
-red wire
(+12V non switched)
-black (GND)
Saab 9-3 (Rear CDC)
2
3
1
Download from Www.Somanuals.com. All Manuals Search And Download.
|