USER / INSTALLATION MANUAL
MS-BX3020
2 WAY FULL RANGE CABIN SPEAKERS
FUSION Electronics New Zealand
FUSION Electronics Australia
FUSION Electronics Europe
FUSION Electronics USA
09 369 2900
1300 736 012
+31 76 5723 632
623 580 9000
FUSION Electronics Pacific
+64 9 369 2900
WWW.FUSIONELECTRONICS.COM
WWW.FUSIONELECTRONICS.COM
Download from Www.Somanuals.com. All Manuals Search And Download.
CONTENTS OF THE BOX:
2 x Speakers
2 x Fully tinned speaker wires
2 x Mounting Brackets
4 x Mounting knobs and washers
4 x Stainless Steel Mounting Screws
Manual
Warranty Card
SPECIFICATIONS
Woofer Size:
3”
Cone Material:
Tweeter Type:
Box Type:
Waterproof paper
Fabric Dome
Sealed, ABS
100
Peak Power (watts):
Efficiency (1W/1M):
85 db
Frequency Response: 200 Hz – 20 kHz
Impedance:
4 ohms
DIMENSIONS
Length 164mm
Width 90mm
Depth 112mm
6-15/32”
3-17/32”
4-13/32”
6
3
Download from Www.Somanuals.com. All Manuals Search And Download.
INSTALLATION GUIDE
INSTALLATION TIPS
1.
Check mounting position for adequate space (see caution)
Any speaker will only perform to its best capabilities, when correctly
placed in the listening area. FUSION Engineers recognise that unlike a
home or motor vehicle installation, there are an extremely wide range of
marine environments where speakers may be placed.
2.
Place the mounting bracket in position, then mark and drill
mounting holes.
3.
4.
Place the mounting bracket and affix with supplied screws.
FUSION MS-BX3020 full range marine speakers are optimised and
tuned to work perfectly with the MS-AB1060R Active Subwoofer with a 2
channel speaker amplifier which not only powers the speakers but also
adds impressive low end to the audio experience, a little thought and care
with placement of the speakers will result in better sound.
Connect the wires from the source unit to the cabin speaker
ensuring the correct polarity is observed.
5.
6.
Attach the cabin speaker to the bracket using the washers and
mounting knobs supplied.
• High frequencies are directional. Placing the speakers low down in the
boat will lose some of its information.
Adjust the angle of the speaker to the preferred position before
tightening the mounting knobs.
• Speakers should be placed to simulate a “sound stage”, by being
placed where you are able to hear both speakers in a stereo situation.
CAUTION: For speaker mounting restrictions related to Magnetic
interference, please refer to the manufacturers recommendations for any
navigational equipment.
TROUBLESHOOTING
Before you contact your FUSION dealer or service centre, FUSION
requires that you do some simple troubleshooting to help diagnose or
resolve the problem.
PROBLEM
SOLUTION
No Sound
Check all connections from the source unit
amplifier to the speaker terminals are
connected correctly.
System lacks in bass
Check the connections from the source
unit/amplifier to the speaker. Check Polarity.
System lacks in
high frequencies:
Check Polarity
Check the bass / treble control settings on the
source unit.
Distorted sound
Check all wiring
Check that it is not the surrounding panels of
the craft rattling. Check connections from the
source to the speaker.
4
5
Download from Www.Somanuals.com. All Manuals Search And Download.
|