™
Monogram.
ZICS360NM – GE Monogram 36" Built-In Stainless Steel Bottom Freezer
Refrigerator with Automatic Icemaker
The Installation Space
The finished cabinet width must be 35-1/2".
Water and Electrical Locations
Electrical and water supply must be located as shown.
35-1/2"
Finished Width
The cutout depth must be 24"
Designed for industry standard flush installation. The refrigerator will project
forward, slightly beyond adjacent cabinetry, depending on your installation.
Wall View
2-5/16"
Cutout depth beneath a soffit
When installed beneath a soffit, the soffit cannot exceed the 24" installation
depth shown.The top case trim overlaps the bottom of the soffit.
7"
10"
Electrical
Area
Frameless Cabinets
The case trim overlaps cabinets at the top and sides. Therefore, frameless
cabinets may require filter strips to prevent interference with cabinet door
swing. The opening must allow for filter strips.
74-1/2" From
Floor to Bottom
of Electrical
84-1/2" max
83-1/2" min
Finished
24" Cutout Depth
5"
Opening
Additional Specifications
5"
3 1/2"
• A 115 volt 60Hz., 15 or 20 amp power supply is required. An individual
properly grounded branch circuit or circuit breaker is recommended.
Install a properly grounded 3-prong electrical receptacle recessed into
the back wall. Electrical must be located on rear wall as shown.
Note: GFI (grounded fault interrupter) is not recommended.
• Water line can enter the opening through the floor or back wall. The water
line should be 1/4" O.D. copper tubing between the cold water line and
water connection location, long enough to extend to the front of the
refrigerator. Installation of an easily accessible shut off valve in the
water line is recommended.
Water Supply
3 1/2"
Dimensions and Clearances
35"
Case Width
* Shipping height. The refrigerator
can be adjusted to fit into a
cutout that is 83-1/2" min. to
84-1/2" max. height. Note that
the top case trim at the front
is 1/2" higher and will overlap
upper cabinetry or soffit. Use
leveling legs and wheels for
height adjustment.
Optional Custom Trim Kits:
• ZUGSS2: Unified Stainless Steel Grille Kit
*84" From
*83-1/2"
at
Rear
Floor to
Product Clearances
Top Frame
These refrigerators are equipped with a 2 position door stop. The factory set
130° door swing can be adjusted to 90° if clearance to adjacent cabinets or
walls is restricted.
Allow 25" minimum clearance for a full 130° door swing. Allow 15" for pan removal.
4" minimum clearance is required when door swing is adjusted to 90°. If the
90° door stop position is used, pan access is maintained, but pan removal
is restricted.
36"
Frame to Frame
Width
90° Door Swing
130° Door Swing
25"
Minimum
to Wall
23-7/8"
Behind
Frame
Listed by
Underwriters
Laboratories
36-3/4"
R
90°
130°
For answers to your Monogram, GE Profile™ or
®
4" Minimum
to Wall
GE appliance questions, visit our website at
GEAppliances.com or call
GE Answer Center® service, 800.626.2000.
Specification Revised 8/02
Download from Www.Somanuals.com. All Manuals Search And Download.
™
Monogram.
ZICS360NM – GE Monogram 36" Built-In Stainless Steel Bottom Freezer
Refrigerator with Automatic Icemaker
Features and Benefits
• 20.6 Cu. Ft. Capacity (Fresh Food
14.5 Cu. Ft./Freezer 6.1 Cu. Ft.)
• Equipped with Factory Installed Automatic
Icemaker with Removable Ice Storage Bin
• Upfront Dual Electronic Controls
• Multi-Shelf Air Management Tower
• 2 Sealed, Adjustable Humidity
Produce Pans with Easy Access Lids
and Full Extension Slides
• 2 Sealed Slide-Out Deli Pans
• Adjustable Spill-Proof Glass Shelves
• 6 Adj. Fresh Food Door Bins
• Gallon Door Storage
• 2 Sealed Dairy Compartments with
Glass-Covered Butter Dish
• Egg Bin
• Wine Caddy
• Freezer Drawer on Full Extension Slides
• Independent Utility Basket on
Full Extension Slides
• GE SmartWater Filtration System
• Model ZICS360NMRH – Right-handed
door swing (Stainless steel wrap)
• Model ZICS360NMLH – Left-handed
door swing (Stainless steel wrap)
Specification Revised 8/02
Download from Www.Somanuals.com. All Manuals Search And Download.
|