| W-28 CEILING FAN/ LIGHT CONTROL   DIAGRAM   Owner’s Manual   For an up-to-date list of selected models that will accept this control, ask your Casablanca   showroom salesperson or contact Casablanca Fan Company at: 1-888-227-2178   IMPORTANT NOTE: The fan must be supplied with three independent   120V AC supply wires to provide power for the fan, the light, and neutral.   INSTALLATION OF WALL CONTROL   The fan must be supplied wit h t hree   5. Wiring preparation, if required:   CAUTION! To avoid overheating and possible   damage to other equipment, do not install to   control receptacle, fluorescent lighting fixture,   motor-operated appliance, or transformer-   supplied appliance.   independent 120V AC supply wires to provide   power for the fan, the light, and neutral.   Installation is to be in accordance with all   National Electrical Code and local codes   Strip wires:   • 3/ 8” for 14 guage   • 1/ 2” for 16 and 18 guage   NOTE: The wire connectors provided are suitable   for copper wire only. Use to join the following   wire combinations: One No. 14 guage with one   No. 16 or 18 guage   3/ 8” or 1/ 2”   • • The fan may be turned ON and OFF by the   W-28 wall control.   The lights may be turned ON and OFF by the   W-28 and the intensity adjusted from low to   high.   CAUTION! Failure to set the pull-chain speed   to HIGH can result in faulty operation of the   fan and damage to the W-28 wall control. To   confirm fan is set to HIGH: Turn W-28 control   to 'HI' - use pull-chain to find fastest speed.   NOTE: W-28 is used to describe either Almond (-A) or   White (-W) finish.   The W-28 is designed to replace a standard wall   switch and will fit wall boxes (metal or plastic)   with a depth of 2” or greater.   Not for use with fans that use one pull-   chain switch to control both fan and light.   6. Connect black lead of control to 120V AC hot   wire. Connect the red lead to the light circuit   controlled by slider on right side of unit. Connect   yellow lead to fan motor(s) wire. The fan speed   will be controlled by the left slider on the unit.   If unit is used to control only one light circuit,   place wire connector on unused lead. Secure these   connections with the wire connectors.   7. If a ground wire is provided in your electrical   box, attach it to the ground screw near the   bottom of the mounting plate.   8. Install the W-28 in the wall box with the two   long screws provided.   • • Set the FAN pull chain switch to the HIGH speed   setting.   Turn the lights ON at the fan.   OPERATION   CAUTION: Ensure power is turned OFF   at the breaker or fuse panel before   starting installation.   1. Raise the fan slider to increase fan speed, lower to decrease.   2. For the fan, four speeds are available: Low 1, Low 2, Medium, and High.   The bottom position is OFF.   3. The light slider is a dimmer, the bottom is OFF, raise to increase intensity of the light.   4. The toggle switch is a separate preset control—turns both the fan and light off or on to the   current setting.   1. Remove the screws and switch plate from the   existing switch box.   2. Remove the screws holding the switch in the   switch box.   3. Pull the existing switch from the switch box to   expose the wire connections.   4. Remove the three wires from the switch.   ONE YEAR WARRANTY   This product is warranted to the original purchaser by Casablanca Fan Company against defects in material and workmanship   for one (1) year from date of purchase. During the warranty period, we will repair or, at our option, replace a defective   product at no charge. For information on how to obtain service, contact Casablanca's Service Department by calling our   toll-free number, 888-227-2178. Damage to the product caused by mishandling, improper installation or modification is   not covered by this warranty. This warranty is given in lieu of all other warranties expressed or implied. Some states do   not allow limitations of time on an implied warranty, therefore the above limitations may not apply in every case. This   warranty states specific legal rights which may vary from state to state.   CAUTION: Be sure no wires are pinched!   9. Install the wall plate with the two color matched   screws.   10.Turn on power to test the controller.   Download from Www.Somanuals.com. All Manuals Search And Download.   ©Copyright 2000 Casablanca Fan Company   P/ N 1943990 Rev.B   P/ D JUL00PDG   |