| 	
		 EIR203 1308qsg-1/2   
					© 2008 by B&B Electronics. All rights reserved.   
					EIR203 Series Quick Start   
					Guide   
					1. Slide and hold the DIN clip toward the bottom of the   
					switch. Angle the top portion of the DIN mount over the   
					top of DIN Rail.   
					2. Move the switch so that it is parallel with the DIN Rail.   
					3. Let go of the DIN Clip. The spring should return it to its   
					original position.   
					Package Contents   
					• EIR203 Series Industrial, Unmanaged, Ethernet Switch   
					• Quick Start Guide (One per shipment)   
					• Power Terminal Block (installed)   
					Attach Power Leads   
					• Fiber Optic Dust Covers (installed on fiber optic models)   
					External Supply Required   
					If any item is missing or damaged, contact B&B Electronics   
					for a replacement   
					Warning: Work Safe – Equipment   
					damage or electrical shock hazard   
					exists. DO NOT ATTACH OR REMOVE   
					LEADS WITH THE POWER SUPPLY   
					ENERGIZED!   
					Front Panel   
					EIR203 (1 Fiber, 2 RJ-45)   
					EIR203 (3 Fiber)   
					1. Loosen the screw to open the terminal block lead clamp.   
					2. Insert the power lead. TB will accept 12-28 AWG wire.   
					3. Tighten the screw to close the terminal block lead clamp.   
					Ensure the clamp holds the lead securely. However, do not   
					over tighten.   
					1 
					2 
					3 
					3 
					4 
					5 
					6 
					Power Terminal Block   
					PWR LED   
					Fiber Optic SPD LED   
					Fiber Optic LINK LED   
					Fiber Ports   
					2 Position, Removable   
					ON When Power Applied   
					Normally OFF (100BaseFx)   
					ON When Fiber Port Linked   
					Number and type depends on Model   
					Number depends on model   
					On when RJ45 Port Linked   
					Flashes When Data Transmitted   
					On if 100 mbps   
					NOTE: For replacement Terminal Block order Part # 7444.   
					RJ45 Ports   
					RJ45 LINK LED   
					Attach RJ45 Cable   
					6 
					RJ45 SPD LED   
					MDI Cable Pinout   
					DIN Rail Mounting   
					Pin   
					Signal   
					1 
					Tx+   
					2 
					Tx-   
					Female RJ45   
					3 
					6 
					Rx+   
					Rx-   
					1. Auto MDI/MDI-x is   
					supported. A straight   
					through or cross-over   
					cable may be used.   
					2. 10/100BaseT auto   
					negotiation and full/half-   
					duplex are supported.   
					MDI-X Cable Pinout   
					Pin   
					1 
					2 
					Signal   
					Rx+   
					Rx-   
					3 
					Tx+   
					6 
					Tx-   
					International Headquarters: 707 Dayton Road PO Box 1040 Ottawa, IL 61350 USA   
					
					European Headquarters: Westlink Commercial Park Oranmore Co. Galway Ireland   
					
					+353 91 792444 Fax +353 91 792445   
					Download from Www.Somanuals.com. All Manuals Search And Download.   
				 |