MODEL CMOTTK30 CONVECTION MICROWAVE TRIM KIT
INSTALLATION INSTRUCTIONS
Before you begin, read these instructions completely and carefully.
Getting Started
■
Remove packaging
Contents
Tools Required
Part Description
Trim Assembly
Base
Qty
1
1/8” Drill
#2 Phillip Screwdriver
1
Rear Duct
1
Forward Duct
Foam Tape
1
2 ft
2
Mounting Bracket (L/R)
Sheet Metal Screws
14
Before installing trim kit, install the convection duct as follows:
1. Insert the rear section of the duct into the forward section of the duct and install 4 screws supplied
(Fig. 01).
2. Install foam tape on 2 flanges of the rear section of the duct (Fig. 02).
3. Remove and retain the 2 top screws, left and right, located at the rear vertical edges of the Microwave
(Fig. 03).
4. Place the duct on top of the Microwave and reinsert the 2 screws removed in Step 3 (Fig. 04).
4 Screws
Foam Tape
Foam
Tape
Fig. 02
Fig. 01
Fig. 04
Fig. 03
CABINET
REAR
CONVECTION
DUCT
FOAM TAPE ON
THIS FLANGE
HORIZONTAL CLIP
ORIENTATION
ON MOUNTING
BRACKET
FORWARD
CONVECTION
DUCT
25 3/4 +1/16"-0"
"
1/8" HOLE FOR
MOUNTING
SCREW
FOAM TAPE ON
THIS FLANGE
TOP PIN
OF TRIM
SCREW HOLE
FOAM TAPE ON
THIS FLANGE
CENTER
LINE
MOUNTING
BRACKET
SUPPORT
INSERT 4
TRIM KIT
ASSEMBLY
INSERT 1
BASE
CABINET CUT-OUT:
19 13/16" +1/16" -0"
BOTTOM PIN OF TRIM
FLANGE
INSERT 2
TRIANGULAR
CENTERING
NOTCH
TOP SCREW
HORIZONTAL
CLIP ORIENTATION
ON BASE
SCREW HOLE
LOCATE MOUNTING BRACKET
IN BOTTOM CORNERS
OF CUTOUT
INSERT 3
Stainless Steel Care
This Trim Kit is made of stainless steel. Use the mildest cleaning procedure first. Start with hot soapy water,
rinse and dry. If the trim kit has food soil remaining, try a general kitchen cleaner, such as Fantastik®, Simple
Green® or Formula 409®. Apply cleaner with a damp sponge, rinse thoroughly and dry. Always scrub lightly
in the direction of the grain. Do not use a steel wool pad, it will scratch the surface. To touch up noticeable
scratches in the stainless steel, sand very lightly with dry 100 grit emery paper, rubbing in the direction of the
grain. After cleaning use a stainless steel polish, such as Stainless Steel Magic®.
5800 Skylab Road, Huntington Beach, CA 92647
Tel: 714.372.7000 Fax: 714.372.7001
•
Customer Service: 888.281.5698
P/N 241185 Rev. A 10/07
|