For customers who purchased this product in the
USA
2-319-815-22(1)
Troubleshooting
Please register this product on line at
Proper registration will enable us to send you
periodic mailings about new products, services,
and other important announcements. Registering
your product will also allow us to contact you in
the unlikely event that the product needs
adjustment or modification. Thank you.
IMPORTANT SAFEGUARDS
For your protection, please read these safety instructions completely before operating the appliance,
and keep this manual for future reference.
Should any problem occur with the unit, make the
following simple checks to determine whether or not
servicing is required.
Carefully observe all warnings, precautions and instructions on the appliance and in the operating
instructions, and adhere to them.
If the problem persists, consult your nearest Sony
dealer.
INSTALLATION
The clock flashes “AM 12:00” due to a power
interruption.
Water and Moisture
Do not use powerline operated appliances near water - for example, near a bathtub, washbowl,
kitchen sink, or laundry tub, in a wet basement, or near a swimming pool, etc.
• The battery is low. Replace the battery. Remove the
old battery and install a new one.
Heat
Do not place the appliance near or over a radiator or heat register, or where it is exposed to direct
sunlight.
The radio or buzzer alarm does not sound at
the preset alarm time.
• Has the desired radio or buzzer alarm been
activated? (i.e., Does the ALARM indicator light
up?)
WARNING
Ventilation
To reduce the risk of fire or electric shock, do
not expose this apparatus to rain or moisture.
FM/AM Clock Radio
The slots and openings in the cabinet are provided for necessary ventilation. To ensure reliable
operation of the appliance, and to protect it from overheating, these slots and openings must never be
blocked or covered.
ICF-C218
You are cautioned that any changes or
modifications not expressly approved in this
manual could void your authority to operate this
equipment.
-Never cover the slots and openings with a cloth or other materials.
-Never block the slots and openings by placing the appliance on a bed, sofa, rug or other similar
surface.
The radio alarm is activated but no sound
comes on at the preset alarm time.
• Has VOLUME been adjusted?
-Never place the appliance in a confined space, such as a bookcase, or built-in cabinet, unless proper
ventilation is provided.
Accessories
Do not place the appliance on an unstable cart, stand, tripod, bracket, or table. The appliance may fall,
causing serious injury to a child or an adult, and serious damage to the appliance. Use only a cart,
stand, tripod, bracket, or table recommended by Sony.
Operating Instructions
Precautions
• Operate the unit on the power sources specified in
“Specifications” .
-An appliance and cart combination should be moved with care. Quick stops, excessive force, and
uneven surfaces may cause the appliance and cart combination to overturn.
• To disconnect the power cord (mains lead), pull it
out by the plug, not the cord.
Wall or Ceiling Mounting
If your appliance can be mounted to a wall or ceiling, mount it only as recommended by Sony.
• Do not leave the unit in a location near a heat
source, such as a radiator or airduct, or in a place
subject to direct sunlight, excessive dust,
mechanical vibration, or shock.
• Allow adequate air circulation to prevent internal
heat build-up. Do not place the unit on a surface (a
rug, blanket, etc.) or near materials (a curtain) that
might block the ventilation holes.
• Should any solid object or liquid fall into the unit,
unplug the unit and have it checked by a qualified
personnel before operating it any further.
• To clean the casing, use a soft cloth dampened with
a mild detergent solution.
USE
Power Source
This appliance should be operated only from the type of power source indicated on the marking label.
If you are not sure of the type of electrical power supplied to your home, consult your dealer or local
power company. For those appliances designed to operate from battery power, or other sources, refer
to the operating instructions.
This symbol is intended to alert the
user to the presence of uninsulated
“dangerous voltage” within the
product’s enclosure that may be of
sufficient magnitude to constitute a
risk of electric shock to persons.
Grounding or Polarization
This appliance is equipped with a polarized AC power cord plug (a plug having one blade wider than
the other), or with a three-wire grounding type plug (a plug having a third pin for grounding). Follow
the instructions below:
-For the appliance with a polarized AC power cord plug:
This plug will fit into the power outlet only one way. This is a safety feature. If you are unable to
insert the plug fully into the outlet, try reversing the plug. If the plug should still fail to fit, contact
your electrician to have a suitable outlet installed. Do not defeat the safety purpose of the polarized
plug by forcing it in.
-For the appliance with a three-wire grounding type AC plug:
This plug will only fit into a grounding-type power outlet. This is a safety feature. If you are unable to
insert the plug into the outlet, contact your electrician to have a suitable outlet installed. Do not defeat
the safety purpose of the grounding plug.
Dream Machine is a trademark of Sony Corporation.
This symbol is intended to alert the
user to the presence of important
operating and maintenance (servicing)
instructions in the literature
If you have any questions or problems
concerning your unit, please consult your
nearest Sony dealer.
accompanying the appliance.
∗ The graphical symbols are at the bottom of the
Overloading
unit.
Do not overload wall outlets, extension cords or convenience receptacles beyond their capacity, since
this can result in fire or electric shock.
Specifications
Time display
When not in use
INFORMATION
Unplug the power cord of the appliance from the outlet when left unused for a long period of time.
To disconnect the cord, pull it out by grasping the plug. Never pull the plug out by the cord.
12-hour System
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
Frequency range
Power-Cord Protection
Band
FM
Frequency
Route the power cord so that it is not likely to be walked on or pinched by items placed upon or
against them, paying particular attention to the plugs, receptacles, and the point where the cord exits
from the appliance.
87.5 – 108 MHz
530 – 1 710 kHz
AM
© 2006 Sony Corporation Printed in China
Lightning
For added protection for this appliance during a lightning storm, or when it is left unattended and
unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable
system. This will prevent damage to the appliance due to lightning and powerline surges.
Speaker
Approx. 6.6 cm (2 5/8 inches) dia., 8 Ω
Object and Liquid Entry
Power output
Never push objects of any kind into the appliance through openings as they may touch dangerous
voltage points or short out parts that could result in a fire or electric shock. Never spill liquid of any
kind on the appliance.
150 mW (at 10% harmonic distortion)
Power requirements
Cleaning
120 V AC, 60 Hz
For power backup: 3 V DC, one CR2032 battery
Unplug the appliance from the wall outlet before cleaning or polishing it. Do not use liquid cleaners
or aerosol cleaners. Use a cloth lightly dampened with water for cleaning the exterior of the appliance.
Clean the appliance only as recommended by Sony.
Dimensions
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment
and receiver.
— Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
Attachments
Approx. 155 × 64.5 × 150 mm (w/h/d)
(6 1/8 × 2 5/8 × 6 inches) incl. projecting parts and
controls
Do not use attachments not recommended by Sony, as they may cause hazards.
ANTENNAS
Mass
Outdoor Antenna Grounding
If an outdoor antenna or cable system is installed, follow the precautions below.
Approx. 495.2 g (1 lb 1.5 oz) incl. CR2032
battery
— Consult the dealer or an experienced radio/TV
technician for help.
An outdoor antenna system should not be located in the vicinity of overhead power lines or other
electric light or power circuits, or where it can come in contact with such power lines or circuits.
WHEN INSTALLING AN OUTDOOR ANTENNA SYSTEM, EXTREME CARE SHOULD BE TAKEN
TO KEEP FROM CONTACTING SUCH POWER LINES OR CIRCUITS AS CONTACT WITH THEM
IS ALMOST INVARIABLY FATAL.
Design and specifications are subject to change
without notice.
WARNING
Battery may explode if mistreated.
Do not recharge, disassemble or dispose of in fire.
Be sure the antenna system is grounded so as to provide some protection against voltage surges and
built-up static charges. Section 810 of the National Electrical Code provides information with respect
to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an
antenna discharge unit, size of grounding conductors, location of antenna-discharge unit, connection
to grounding electrodes, and requirements for the grounding electrode.
For the state of california, USA only
Perchlorate Material –special handling may apply, See
Perchlorate Material: Lithium battery contains
perchlorate
Antenna Grounding According to the National
Electrical Code
Antenna Lead-in Wire
Ground
Antenna Discharge Unit
Clamps
Features
(NEC Section 810-20)
• Single alarm FM/AM Clock radio.
Grounding Conductors
(NEC Section 810-20)
Ground Clamps
Electric Service
Equipment
NEC-NATIONAL
• Various types of alarms — radio and buzzer.
• Automatic time set — When you plug the clock in
for the first time, the current time will be shown in
the display.
• Automatic Daylight Saving Time/Summer time
adjustment.
• Date button to display month, day and year.
• Battery backup to keep the clock during a power
interruption with a CR2032 battery installed.
ELECTRICAL CODE
Power Service Grounding Electrode System
(NEC Art 250 Part H)
SERVICE
Damage Requiring Service
Unplug the appliance from the wall outlet and refer servicing to qualified service personnel under the
following conditions:
-When the power cord or plug is damage or frayed.
-If liquid has been spilled or objects have fallen into the appliance.
-If the appliance has been exposed to rain or water.
• Extendable snooze — snooze time can be extended
from 10 to 60 minutes in maximum every time you
use.
-The appliance does not appear to operate normally or exhibits a marked change in performance.
-This indicates a need for service.
-If the appliance does not operate normally when following the operating instructions, adjust only
those controls that are specified in the operating instructions. Improper adjustment of other controls
may result in damage and will often require extensive work
by a qualified technician to restore the appliance to normal operation.
-If the appliance has been subject to excessive shock by being dropped, or the cabinet has been
damaged.
Servicing
Do not attempt to service the appliance yourself as opening or removing covers may expose you to
dangerous voltage or other hazards.
Refer all servicing to qualified service personnel.
Replacement parts
When replacement parts are required, be sure the service technician has used replacement parts
specified by Sony that have the same characteristics as the original parts.
Unauthorized substitutions may result in fire, electric shock, or other hazards.
Safety Check
Upon completion of any service or repairs to the appliance, ask the service technician to perform
routine safety checks (as specified by Sony) to determine that the appliance is in safe operating
condition.
This unit includes a preinstalled Sony Lithium battery (CR2032) as back-up power source for the clock, which is preset
to EST/EDT (Eastern Standard Time/Daylight Time) at the factory. And this battery is considered part of the product.
|