| 	
		 6 
					BombA 27 V1 User Manual   
					Congratulations on choosing Focal automobile speakers.   
					To gain the best results from your speakers, please ensure you follow these recommendations,   
					and keek carefully this user manual so that you can consult it later. If not followed correctly any fault   
					observed may not be covered by the guarantee.   
					Precautions   
					For the subwoofer to perform at its best, we recommend to use it in a location where temperature   
					doesn’t go below 5°C.   
					• The location must also be dry and offer adequate ventilation.   
					• The supply voltage requirement is 12VDC (13.8VDC) with the negative connection grounded.   
					Please make sure that the characteristics of your vehicle correspond with this requirement before   
					connecting the equipment.   
					• For safe driving, we recommend that you operate your sound equipment at a listening level that does   
					not conceal traffic noise.   
					Warning!   
					The performance of the Focal BombA 27 V1 allows high sound pressure levels to be generated.   
					We remind you that sustained listening beyond 110dB SPL can permanently and irreversibly damage   
					your hearing. We recommend that you adjust the level of your equipment correspondingly.   
					For safety reasons, it is essential that you securely fix the subwoofer enclosure in the boot (make sure   
					you do not drill through the petrol tank if you fix it with screws).   
					Mounting kit included:   
					- 2 x nylon straps   
					- 4 x metal roll bar   
					- 8 x fixing screws   
					- 1 x template   
					The Focal guarantee only applies if page 11 is   
					returned to us within 10 days of purchase.   
				8 
					BombA 27 V1 User Manual   
					ᕇ 
					Phase inverter   
					It allows you to phase the subwoofer (generally advised) or unphase it.   
					The right setting is determined by listening and finding the one (matching with the front system)   
					that provides the most bass.   
					ᕈ 
					Adjustable cut-off frequency   
					An electronic crossover removes medium and high frequencies beyond a point set by the user. The ideal   
					is to extend the bass frequencies in an even and continuous manner from where the front system rolls   
					off. In general, a cut-off frequency located between 80 and 100Hz should be suitable for most systems.   
					This setting becomes more critical when the BombA is used within a high-end hi-fi system.   
					The idea cut-off frequency will only be found after extensive listening to a wide range of musical.   
					Warning! Very few recordings possess real bass frequencies. Bass notes such as those found in Rock,   
					Techno, Ragga music etc. are rarely located within the extreme bass area, but more likely in the high   
					bass band.   
					As a consequence, it is recommended to select a cut-off frequency between 100 and 120Hz for these   
					styles of music. However, you may prefer a lower cut-off frequency for classical music.   
					It is possible to set the cut-off frequency anywhere between 40 and 160Hz   
					This adjustment should be made in reference to the listening position and with your preferred type of   
					music.   
					For a more precise adjustment, your retailer may use an analyzer (RTA).   
					Dimensions :   
					A = 12-3/16” - 310mm   
					B = 14-5/8” - 371mm   
					C = 6-11/16” - 170mm   
					L = 18-1/3” - 466mm   
				9 
					BombA 27 V1 User Manual   
					Amplifier setting and connections   
					SPL   
					+ +   
					Extreme Bass   
					Quality …   
					+ 
					High level imputs   
					for compatibility   
					with all types of installation   
					Low level inputs   
					(4V compatible)   
					ᕄ 
					ᕆ 
					ᕃ 
					ᕅ 
					3 bass-boost settings   
					- Classical   
					- Techno   
					- Pop   
					Adjustable level   
					Adjustable cut-off   
					40 - 160Hz   
					at 18dB/oct   
					ᕈ 
					ᕉ 
					Phase settings   
					(o°/180°)   
					Power   
					Protection fuse   
					ᕇ 
					Integrated Subsonic Filter 24dB/oct   
					guide   
					Issue   
					Cause   
					Solution   
					Can’t switch on the   
					BombA   
					No +12V on the supply   
					Ground not properly connected   
					Fuse broken   
					Check connections to battery   
					Check connection   
					Change fuse   
					The BombA is on,   
					but no signal   
					No signal   
					Check signal cable   
					No remote   
					Check power on the remote   
					Turn up the volume on the source.   
					Level control ineffective   
					Output distorted   
					Fuses blown   
					Source level too high   
					Gain of the amplifier too high   
					Turn down the source level   
					Turn down the gain of the amplifier   
					Output levels too high   
					Turn the volume down   
				10   
					BombA 27 V1 User Manual   
					Tecnical specifications   
					BombA 27 V1   
					27cm (11")   
					Subwoofer   
					310mm (12-3/16")   
					371mm (14-5/8")   
					466mm (18-1/3")   
					150 Wrms / 300W max.   
					36Hz-160Hz   
					Height   
					Base width   
					Lenght   
					Built-in amplifier   
					Frequency response   
					Guarantee   
					All Focal loudspeakers are covered by guarantee drawn up by the official Focal distributor   
					in your country.   
					Your distributor can provide all details concerning the conditions of guarantee. Guarantee cover extends   
					at least to that granted by the legal guarantee in force in the country where the original purchase invoice   
					was issued.   
					® 
					Focal is a trademark of Focal-JMlab   
					® 
					
					Tél. 00 33 4 77 43 57 00 - Fax 00 33 04 77 37 65 87   
					Due to constant technological advances, Focal reserves its right to modify specifications without notice. Images may not conform exactly to specific product. ©Focal-JMlab   
				 |