CITRUS PRESS
KS3000M
Please retain these instructions for future use
Thank you for choosing this De’Longhi citrus press.
To get the best results from your new citrus press it is
advisable to read these instructions carefully before using
the appliance.
This is the only way to ensure optimum results and maxi-
mum safety.
Using for the first time
•
Before use, check that the appliance has not been damaged dur-
ing transport.
•
•
Remove all packaging from the citrus press.
Check that the voltage of the electrical socket corresponds to
the voltage indicated on the label on the appliance. Before using
the appliance for the first time, carefully wash and dry the fruit
dome, filter, container and non-drip spout
fig.1
fig.2
Fig.3
Fig.4
Assembling the appliance
Assemble the appliance as follows:
1. Insert the two ends of the juicing lever into the guides (fig. 1).
2. Make sure the juicing lever is mounted correctly by raising and
lowering the lever.
3. Insert the cover into the lever ring and push as far as it will go,
making sure the tab on the ring fits into the hole in the cover
(fig. 2).
At this point, the appliance is ready for juicing.
Before use
Before using the machine for the first time, wash all the acces-
sories (dust cover, fruit dome, top filter, bottom filter, pulp density
selector, internal juice container, non-drip spout) in warm soapy
water and rinse.
Use
•
•
•
Place the container on the motor base.
Fit the bottom filter and top filter.
Place the filter assembly on the motor base , making sure the
pulp density selector is positioned in the hollow in the motor
base (fig. 3).
Fit the fruit dome onto the motor shaft.
Place a glass under the non-drip spout and move the spout
downwards (fig. 4).
•
•
•
•
•
Plug into the mains.
Cut the citrus fruit in half.
Place half a fruit onto the fruit dome and lower the cover by
pushing the juicing lever down and pressing lightly.
The motor is designed to rotate in either direction to optimise
the juicing effect; press the juicing lever intermittently the
motor will reverse its rotational direction.
3
Citrus juicer KS3000
NB: the pulp density selector enables the quantity of pulp in the
juice to be regulated by making the holes in the filter smaller or
larger.
To reduce the amount of pulp, move the juice density selector
left as far as it will go.To increase the quantity of pulp, move the
selector to the opposite side (fig. 5).
Important: never use the appliance continuously for more than
four minutes.
When you have finished juicing, to reduce drips, move the non-
Fig.5
•
drip spout to the raised position (fig. 6).
Cleaning and maintenance
•
This appliance should not require any maintenance. However,
before attempting to clean the appliance, unplug from the mains
socket.
•
Remove the filters, dome and juice container by pulling
upwards.
•
•
Remove all waste and clean the components.
To avoid residues drying on, take the appliance to pieces and
clean the components immediately after use.
Wash the juice container, filters, cone and cover in warm water and
detergent. None of the components can be washed in a dishwasher.
Clean the motor base with a damp cloth.
Fig.6
•
•
NB: to facilitate cleaning, the non-drip spout can be removed
from the container by rotating the spout outwords and pulling
lightly; then replace.
Safety Warnings
Please read these instructions before operating and retain for
future reference.
•
After having removed the appliance from the packaging, make
sure that it has all of its components. If there is any doubt, do
not use the appliance and return it to be checked by qualified
personnel.
•
•
The plastic bag containing the appliance should be kept away
from children as it may represent a suffocation hazard.
In the case that the plug is not compatible with the electrical
outlet being used, have it substituted with a suitable one by
qualified personnel. The use of adapters, multi-way plugs, and/or
extension cords is not recommended. Whenever their use
might become necessary, use simple or multiple adapters and/or
extension cords conforming to the safety laws, taking care to
not exceed the power limits marked on the adapter or the
extension cord.
•
Should the appliance stop working, go to an authorised service
centre.
4
Citrus juicer KS3000
•
The appliance should be destined exclusively to the use for
which it has been created. Any other use is to be considered
inappropriate and therefore dangerous. The manufacturer can-
not be held responsible for any damage caused by improper,
erroneous or irresponsible use and/or by repairs made by
unqualified personnel.
•
•
•
Do not touch the appliance with wet or damp hands.
Do not use the appliance with bare or wet feet.
Do not unplug the appliance by pulling the plug out of the sock-
et by the cord.
•
•
•
Do not the leave the appliance exposed to the atmosphere
(rain, sun, freezing temperatures, etc.)
Children or infirm persons should not be allowed to use this
product unsupervised
Remove the plug from the electrical socket when the appliance
is not in use.
•
•
Do not immerse the appliance in water.
Before beginning any cleaning or maintenance procedures, dis-
connect the plug of the appliance from the electrical outlet.
In case of malfunction and/or breakdown, turn the appliance off.
For repairs, go to a qualified service centre requesting the use
of original parts or accessories.
•
•
•
Keep these instructions for further reference.
If the supply cord is damaged, it must be replaced by the manu-
facturer, its service agent or similarly qualified persons in order
to avoid a hazard.
•
As with any electrical appliance, whilst the instructions aim to
cover as many eventualities as possible caution and common
sense should be applied when operating your appliance, particu-
larly in the vicinity of young children.
The materials and the parts which come into contact with food
products are in full compliance with the regulations of the EEC
Directive 89/109.
Important information for correct disposal of the product
in accordance with EC Directive 2002/96/EC.
At the end of its working life, the product must not be disposed of as
urban waste.It must be taken to a special local authority differentiat-
ed waste collection centre or to a dealer providing this service.
Disposing of a household appliance separately avoids possible
negative consequences for the environment and health deriving
from inappropriate disposal and enables the constituent materials
to be recovered to obtain significant savings in energy and
resources.As a reminder of the need to dispose of household
appliances separately, the product is marked with a crossed-out
wheeled dustbin.
5
Citrus juicer KS3000
Warning
this appliance must be earthed
Electrical Requirements
The flexible mains lead is supplied connected to a B.S. 1363 fused
plug having a fuse of 13 amp capacity.Should this plug not fit the
socket outlets in your home, it should be cut off and replaced with
a suitable plug, following the procedure outlined below.
Note: Such a plug cannot be used for any other appliance and
should therefore be properly disposed of, (having removed the
fuse) and not left where children might find it and plug it into a
supply socket - with the obvious consequent danger.
Green and Yellow to
Earth
13 amp
Fuse
Brown to
Blue to
Live
Neutral
Cord Clamp
If the plug is a moulded-on type the fuse cover must be refitted. If
the fuse cover is lost, the plug must not be used until a replace-
ment cover is obtained.The colour of the correct replacement
fuse cover is that of the coloured insert in the base of the fuse
recess or elsewhere on the plug.Always state this colour when
ordering a replacement fuse cover.
N.B.We recommend the use of good quality plugs and wall sockets
that can be switched off when the machine is not in use.
important: the wires in the mains lead fitted to this appliance are
coloured in accordance with the following code:
GREEN AND YELLOW
EARTH
NEUTRAL
LIVE
BLUE
BROWN
As the colours of the wires in the mains lead of this appliance may
not correspond with the coloured markings identifying the termi-
nals in your plug, proceed as follows:
The wire which is coloured green and yellow must be connect-
ed to the terminal in the plug which is marked with the letter E
or by the earth symbol
low.
or coloured green or green and yel-
The wire which is coloured blue must be connected to the ter-
minal which is marked with the letter N or coloured black.
The wire which is coloured brown must be connected to the ter-
minal which is marked with the letter L or coloured red.
When wiring the plug, ensure that all strands of wire are secure-
ly retained in each terminal. Do not forget to tighten the mains
lead clamp on the plug. If your electricity supply point has only
two pin socket outlets, or if you are in doubt, consult a qualified
electrician.
Should the mains lead ever require replacement, it is essential
that this operation be carried out by a qualified electrician and
should only be replaced with a flexible cord of the same size.
Only 13amp replacement fuses which are ASTA approved to B.S.
1362 should be fitted.
This appliance conforms to the Norms EN 55014 regarding
the suppression of radio interference.
6
Kettle KBX3030
444IDL/06.05
|