MEDIA CONVERTER TECHNICAL SPECIFICATIONS
Standards
IEEE 802.3
Minneapolis, MN 55344 USA
100BASE-TX/100BASE-FX Media Converters
E-100BTX-FRL-01, E-100BTX-FRL-01(SC), E-100BTX-FRL-01(SM)
Case dimensions
Environment
3.9" x 3.0" x 1.0"
(99mm x 76mm x 25mm)
Temperature:
Humidity
Altitude
0-40°C (32° to 104° F )
10-90%, non condensing
0-10,000 feet
USER’S GUIDE
Warranty
Five years
The TRANSITION Networks Ethernet™ 100BASE-TX to 100BASE-FX media
converters connect 100BASE-TX unshielded twisted pair cable to 100BASE-FX
multimode or singlemode fiber-optic cable. Media converter models are selected
according to the fiber mode and fiber connector required at the site. Multimode
fiber-optic cable can use either an ST connector (E-100BTX-FRL-01) or an SC
connector (E-100BTX-FRL-01(SC)). Singlemode fiber (E-100BTX-FRL-01(SM)) uses
only an SC connector. All media converters function in half-duplex mode or, when
connected to devices capable of full-duplex connectivity, in full-duplex mode.
Power Supply Requirements Replace power supply with only the equivalent input
rating (see below) and output rating (regulated 9VDC at 0.5 A).
TN PN
3517
3516
3518
3514
3515
Requirement
Location
United Kingdom
Europe
USA/Canada/Mexico
Japan
Australia
240 volts, 50 hertz
230 volts, 50 hertz
120 volts, 60 hertz
100 volts, 50-60 hertz
240 volts, 50 hertz
E-100BTX-FRL-01
UTP
Provides an RJ-45 unshielded twisted
pair 100BASE-TX connector and a set
of RX (receive) and TX (transmit) ST
CAUTION: RJ connectors are NOT INTENDED FOR CONNECTION TO THE
PUBLIC TELEPHONE NETWORK. Failure to observe this caution could result in
damage to the public telephone network.
100BASE-FX connectors to multimode
Multimode Fiber
fiber-optic cable.
E-100BTX-FRL-01
Der Anschluss dieses Gerätes an ein öffentlickes Telekommunikationsnetz in den EG-Mitgliedstaaten
verstösst gegen die jeweligen einzelstaatlichen Gesetze zur Anwendung der Richtlinie 91/263/EWG zur
Angleichung der Rechtsvorschriften der Mitgliedstaaten über Telekommunikationsendeinrichtungen
einschliesslich der gegenseitigen Anerkennung ihrer Konformität.
E-100BTX-FRL-01(SC)
UTP
Provides an RJ-45 unshielded twisted
pair 100BASE-TX connector and an
RX (receive) and TX (transmit) SC
Compliance Information
UL Listed
C-UL Listed (Canada)
CISPR/EN55022 Class A
100BASE-FX connector to multimode
Multimode Fiber
fiber-optic cable.
E-100BTX-FRL-01(SC)
FCC Regulations
This equipment has been tested and found to comply with the limits for a class A digital device, pursuant
to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference, in which case the user will be
required to correct the interference at the user’s own expense.
E-100BTX-FRL-01(SM)
UTP
Provides an RJ-45 unshielded twisted
pair 100BASE-TX connector and an
RX (receive) and TX (transmit) SC
100BASE-FX connector to singlemode
Singlemode Fiber
fiber-optic cable.
Canadian Regulations
E-100BTX-FRL-01(SM)
This digital apparatus does not exceed the Class A limits for radio noise for digital apparatus set out on
the radio interference regulations of the Canadian Department of Communications.
Link
Status LEDs on the connector side of the media
converters provide the following information:
Pwr (Power) Illuminated green LED
European Regulations
Warning
ST Connectors
RX
TX
RX
Link
Link
This is a Class A product. In a domestic environment this product may cause radio interference in which
case the user may be required to take adequate measures.
Pwr
indicates connection to external
AC power.
RX
RX
RJ-45 Connector
10BASE-T
10BASE-FL
TX
RX
Link
Link
Pwr
RJ-45 Connector
Copyright Restrictions
© 1996, 1997 TRANSITION Networks.
All rights reserved. No part of this work may be reproduced or used in any form or by any means –
graphic, electronic, or mechanical – without written permission from TRANSITION Networks.
RX
(Receive) Flashing green LED
indicates port is receiving
RX
RX
10BASE-T
10BASE-FL
Link
RX
SC Connectors
data.
Pwr
Link Steady green LED indicates port is
Download from Www.Somanuals.com. All Manuals Search And Download.
Trademark Notice
receiving link signal.
All registered trademarks and trademarks are the property of their respective owners.
33009.C
|