FELIX STORCH, INC.
SUMMIT APPLIANCE DIVISION®
INSTRUCTION MANUAL FOR MODEL(S):
S-23
S-23L
SW-23
CSW-34
Thank you for your trust and for buying this appliance. We hope it will successfully
serve its purpose for many years.
COMPACT REFRIGERATOR
Download from Www.Somanuals.com. All Manuals Search And Download.
Before Putting Into Use
Instructions for Use
These instructions for use are intended for the user. They describe the appliance and
the correct and safe way to use it. The instructions were prepared for various
types/models of refrigerators therefore you may find in it descriptions of some
accessories and functions that your appliance may not have.
• Before connecting the appliance to the power supply, leave it standing for
about 2 hours, which will reduce a possibility of malfunctions in the cooling
system due to transport handling.
• Clean the appliance thoroughly; especially in the interior (See Cleaning and
Maintenance).
• Use a 120 volt, 60HZ outlet. Do not use an extension cord.
• Use a 3 prong grounded wall outlet.
Mounting Instructions
Integrated appliances are equipped with instructions for mounting the appliance into
the kitchen unit.
The appliance should be mounted by qualified technicians and instructions are for
their use only.
We Care for the Environment
• Our appliances are distributed in packaging made of environmental
friendly material which could safely be recycled, disposed of or destroyed
without any effects on the environment whatsoever.
• Our instruction manuals are printed either on recycled paper or chlorine
free bleached paper.
Tips for Energy Savings
• Try not to open the door too often, especially when the weather is hot and
humid. Once you open the door try to close it as soon as possible.
• Every now and then check if the appliance is sufficiently ventilated
(adequate air circulation behind the appliance).
• Set thermostat from higher to lower settings as soon as possible
(depending on how full the appliance is, ambient temperature etc...).
• The coils on the rear of the refrigerator should be cleaned and free of dust
or any other impurities.
• Ice and frost layer increase energy consumption, so clean the appliance as
soon as the layer is 1/8” thick.
• Always consider instructions stated in sections Energy Saving Tips,
otherwise the energy consumption is substantially higher.
Instructions for Use
Download from Www.Somanuals.com. All Manuals Search And Download.
Important
To reduce the risk of fire, electrical shock,
or injury when using your appliance,
follow these basic precautions:
Warning!
• Read all instructions before using the appliance.
• If you bought this appliance to replace an old one equipped with a lock
that cannot be opened from inside (lock, bolt), make sure that the lock
is broken. This will make it impossible for children to lock themselves
inside the appliance and suffocate.
• The appliance must be correctly connected to the power supply.
• If the food has a strange smell or color throw it away because it is very
likely that it is spoiled and therefore dangerous to eat.
• Disconnect the appliance from the power supply before repairing and
cleaning it (only a qualified technician should repair it).
•
For the sake of environmental protection be careful not to damage the
rear wall of the appliance (the condenser unit or the tubes when
moving the refrigerator) or any part of the refrigerating system inside
the appliance. Use only enclosed tools or tools recommended by the
manufacturer.
• The refrigerating system of the appliance is filled with refrigerant and
oil, so when the appliance is damaged handle it with care and dispose
of it in compliance with the environmental protection precautions.
• Before throwing away your old refrigerator please remove the doors
and leave the shelves in place so that children may not easily climb
inside.
• DANGER: Risk of child entrapment.
• The rating plate is inside the appliance or outside on the rear wall.
Disposing of the Worn Out Appliance
• When your appliance finally wears out, dispose of it. If the appliance
has a lock, break it to prevent eventual accidents (danger of children
getting locked inside the appliance).
• The refrigerating system of the appliance is filled with refrigerant and
insulating substances which should be separately treated and
processed, you should call your nearest authorized service agent or
specialized servicing center if they cannot be contacted call your local
authorities or your distributor to remove the refrigerator. Be careful
not to damage the tubes on the rear wall of the appliance (danger of
pollution).
Instructions for Use
Download from Www.Somanuals.com. All Manuals Search And Download.
Placing and Installation
Choosing the Right Place
Place the appliance in a dry and regularly ventilated room. Allowed ambient
temperature depends on the model (class) of the appliance. It is located on the
rating plate of the appliance. Make sure the appliance is on a leveled floor that is
strong enough to support the appliance when it is fully loaded.
Class
SN (sub-normal)
N (normal)
ST (sub-tropical)
T (tropical)
Ambient Temperature
from + 56°F to + 90°F
from + 62°F to + 90°F
from + 64°F to +100°F
from + 64°F to +120°F
The appliance may be exposed to lower or higher temperatures but only for
shorter period of time and the temperature should never be lower than 41°F.
Never place the appliance near heat emitting devices (e.g. cooker, radiator, water
heater or similar devices) and do not expose it to direct sunlight. The appliance
should be positioned 3cm from the electric or gas cooker. Behind the appliance
there should be at least 200 cm² wide and above the appliance at least 5 cm away
from the appliance in order to assure adequate ventilation of the condenser unit.
Placing the Self-Standing Appliance
• It is important to make sure the appliance is leveled evenly to prevent
falling.
• Do not place the appliance in direct sunlight and sources of heat
(stove, heater, radiator, etc.). Direct sunlight may affect the acrylic
coating and heat sources may increase electrical consumption.
• The appliance with the ventilation grid may be placed close to the
wall. The grid enables sufficient air circulation that is required for
adequate ventilation of the rear wall.
Connection to Power Supply
Connect the appliance with the cable and plug to the power supply socket outlet
with a ground terminal (safety socket).
“DO NOT USE AN EXTENSION CORD.”
Required nominal voltage and frequency are indicated on the rating plate.
The connection to the power supply and grounding has to be made according to
current standards and regulations. The appliance resists temporary voltage
tolerance up to -15 to 10%.
Instructions for Use
Download from Www.Somanuals.com. All Manuals Search And Download.
Description of the Appliance
NOTE:
• The appliance can be equipped with various accessories, depending on the
model of the appliance.
• Door handles are in various shapes, depending on the model.
• Various accessories (additional shelves) can be purchased at authorized
centers.
Freezing Compartment
Used for making ice cubes.
Drip Tray
Catches melted water when defrosting.
Control Knob
It rotates to adjust the refrigerator temperature.
Slide Out Shelf
Odor resistant, rustproof and plastic coated steel shelf.
Bottle Rack
The bottle rack is intended for storing bottles.
Instructions for Use
Download from Www.Somanuals.com. All Manuals Search And Download.
Operation Control
The refrigerator can be adjusted from colder to warmer by turning the
Temperature Control knob. Colder temperature can be achieved by turning the
control knob clockwise towards the “max” position. Warmer Temperatures can be
reached by turning the control knob counterclockwise towards the “min” position.
Temperature Selection
Higher settings on the knob (max) mean colder temperatures in all
compartments of the appliance. The temperature in the interior of the
appliance may even drop below 35°F. Use the higher thermostat setting
only when required or recommended. We recommend that you set your
thermostat in the middle for standard temperature.
Changing the thermostat will affect the temperature inside of the
appliance; therefore choose your temperature wisely.
When the thermostat is on the OFF position the appliance does not
operate.
Temperature in the refrigerator also depends on how often you open the
door.
Changing the Direction of Opening the Door
If you find the direction of opening the door on your appliance inconvenient, you
can change it. Holes on the opposite side have already been prepared at the
factory.
Some screws are covered with caps. Remove the caps before undoing the
screws.
Take off the upper hinge cap and unscrew the upper and lower hinges.
Remove the kick plate and place it in its new position.
Unplug the holes covering the holes on the opposite side of the appliance
door.
Undo the fastener of the upper hinge and fix it to the opposite side of the
appliance.
Put the door on the upper hinge fastener.
Fix the upper hinge and cover it.
Unscrew the handle and replace it to the opposite side (not for handles
mounted horizontally).
Plug the remaining holes with decorative caps.
Check the gasket, it should not be creased and should seal well.
Instructions for Use
Download from Www.Somanuals.com. All Manuals Search And Download.
Maintenance and Cleaning
Automatic Defrosting of the Refrigerator
There is no need to defrost the refrigerator, because the ice depositing on the inner
back wall is defrosted automatically.
Ice is depositing on the inner back wall during the compressor operation; later on,
when the compressor is not operating, ice is defrosting and water drops, collects
and drains through the outlet in the inner back wall into the drain pan situated
above the compressor where it evaporates.
Cleaning the Appliance
Disconnect the power supply before cleaning the appliance. Do not use coarse or
Aggressive cleaning agents as you can damage the surface.
Clean the exterior with water and detergent. Varnished surfaces are
cleaned with soft cloth and an alcohol based cleaning agent (for example
glass cleaners). You may also use alcohol (ethanol or isopropyl alcohol).
The application of abrasive and especially aggressive cleaners, such as
stainless steel cleaners, is not appropriate for the cleaning of plastic and
coated parts.
Remove the detachable accessories in the interior of the appliance and
clean it with water and liquid detergent. Plastic parts cannot be washed in
a washing machine.
Wash the interior of the appliance with lukewarm water, in which you add
one or two spoonfuls of vinegar.
Every now and then wipe the condenser on the rear wall. Use a soft non-
metal brush or vacuum cleaner.
Do not forget to clean the defrost water receptacle above the refrigerators
compressor (do not remove the receptacle). After cleaning, connect the
appliance to the power supply and reload the packages.
Switch Off the Appliance When Not in Use
If you do not intend to use the appliance for an extensive period of time set the
thermostat knob to the OFF (0) position and disconnect the power supply. Then
take out the foods and clean the appliance. Leave the door slightly open.
Instructions for Use
Download from Www.Somanuals.com. All Manuals Search And Download.
Trouble-Shooting Guide
During the service of your appliance, you can come across some troubles that in
most cases result from improper handling of the appliance that can easily be
eliminated.
The Appliance Fails to Operate After Connecting to the Power Supply
Check the supply in the outlet socket and make sure the appliance is
switched on (thermostat in the operating position).
Continuous Operation of the Refrigerating System
The door was frequently opened or it was left open too long.
The door is not properly closed (the door may sag; the gasket may be
polluted or damaged).
Perhaps you have overloaded the appliance with fresh foods.
The reason may be inadequate ventilation of the compressor and
condenser (assures adequate air circulation and wipe off the condenser).
Ice Formation on the Inner Rear Wall
As long as the defrost water runs to the channel and through the opening to the
drain pan on the compressor, automatic defrosting of the appliance is assured. In
case the ice formation on the inner back wall is increased (1/8”), ice should be
manually defrosted.
Set the thermostat knob to OFF (0) position and leave the door open. Never use
electric devices for defrosting and do not scrape the ice or frost layer with sharp
objects. After completed defrosting, turn the knob to desired position and close
the refrigerator door.
The cause of increased ice formation may be one of the following reasons:
-
The door does not seal well (clean the gasket if it is contaminated,
or replace it if it is damaged).
-
-
-
The door was frequently opened or it was left opened for too long.
The food stored in the refrigerator was warm.
The food or dish is touching the inner back wall.
Water is Leaking from the Refrigerator
In case the discharged water outlet is clogged, or the defrost water drips over the
channel, or water leaks from the refrigerator just clean the clogged opening with a
plastic straw. Manually defrost the increased ice layer. See “Ice Formation on the
Inner Back Wall”.
Instructions for Use
Download from Www.Somanuals.com. All Manuals Search And Download.
Noise
Cooling in refrigerating-freezing appliances is enabled by the refrigerating system
with the compressor, this produces noise. How noisy the appliance is depends on
where it is placed, how it’s used and how old the appliance is.
During the operation of the compressor, a liquid noise is heard and when
the compressor is not operating a refrigerant flow is heard. This is a
normal condition and it has no influence whatsoever on the lifetime of the
appliance.
After starting the appliance, the operation of the compressor and the
refrigerant flow may be louder and this does not mean something is wrong
with the appliance. The noise will reduce gradually, this will not affect
the lifetime of the appliance.
Sometimes unusual and strong noises occur which is rather unusual for the
appliance. This noise is often a consequence of inadequate placing. To
avoid the noise make sure the appliance is placed and leveled firmly on a
solid base. Make sure the appliance is not touching the wall or kitchen
units standing next to it. And always make sure you check the accessories
in the interior of the appliance; they should be placed correctly in their
positions. Check the bottles, tins and other vessels that might touch each
other and rattle.
Before Calling for Service
Check the plug and fuse.
Test the outlet with a lamp.
Be sure the control is not set to OFF.
Read the manual, especially the items under the Use and Care sections.
You may find the answer to your questions.
If you don’t find the answer to your questions in this manual, find the
unit model number (on the upper back of the refrigerator) and contact
your Summit Appliance Dealer.
Specifications are Subject to Change Without
Notice.
Instructions for Use
Download from Www.Somanuals.com. All Manuals Search And Download.
|