REMOTE CONTROL BASICS BATTERY REPLACEMENT:
1.Remove the battery holder as the direction indicated by the arrow.
2.Replace the battery Set a new battery property with (+)side up as illustrated.
3.Insert the battery holder. Push in the holder to the original position.
MODEL: CDR83MP
NOTE ON BATTERIES:
Old batteries must immediately be removed and disposed.
INSTRUCTION MANUAL
BATTERY INFORMATION:
Designated Battery: UM-4"AAA"/R05
Battery Life: 6 months with normal use (in normal room temper atur)
CAUTION:
Improper use of batteries may cause overheating, explosion or ignition. Resulting in
jury or fire .Battery leakage may cause damage to the unit.
Do not disassemble or short the batteries. Do not throw the batteries into the fire.
To avoid the risk of accident, keep the batteries out of reach of children.
MO/ST BUTTON: Press it to select MONO or STEREO
sound mode.
TUNE/SEEK OR TRACK/SKIP AND TIME ADJUST BUTTONS:
Same as the UP and DN buttons in front panel.
ANTI-THEFT FLIP DOWN DETACHABLE PANEL
AUTO-LOADING CD/MP3 PLAYER
SCAN BUTTON: Press it to scan up by one channel step with
station detection. If a valid signal has detected, the
current frequency is blinked within 5 seconds, then press
it again to stop scan and remain the current frequency;
otherwise, the unit continue to scan up by one channel
step with station detection 5 seconds later.
AM/FM STEREO WITH DIGITAL TUNING RADIO
WITH REMOTE CONTROLLER
IMO-5199A
11
Download from Www.Somanuals.com. All Manuals Search And Download.
INSTALLATION
SPEAKER CONNECTION
ANTENNA PLUG
YELLOW
12P
AUX LINE IN
RED R
MEMORY B+
FUSED
FILTER
BOX
0.5A &7A
FUSES
WHITE L
RED R
WHITE L
FRONT
BLACK(GND)
RED (B+)
RCA LINE OUT
1 A
BLUE AUTO ANT
+
FUSE
+
GRAY
WHITE
FRONT
RIGHT
SP
WHITE/BLACK
GREEN
GRAY/BLACK
VIOLET
LEFT
SP
+
+
REAR
REAR
GREEN/BLACK
VIOLET/BLACK
NOTE:
1. In spite of having any kinds of speaker system, must use 4 ohms
impedance of speaker to reduce the distortion during high volume level.
2. Prohibit to make the conductors of auto antenna and ground
touch with each other.
USA
EUROPE
IMPORTANT:
This radio is set to USA frequency by factory, if European
frequency is required please flip the frequency step switch on
the side of the unit.
After the switchover of the frequency switch, the frequency convert
function will not be valid until the RESET button has been pressed.
(The RESET button is in the rear facet of the front panel)
If you want to take CHASSIS out of the SLIDE BRACKET HOUSING,
remove the PLASTIC OUTLINE away, then insert the two KEY PLATE
into left and right side of chassis as the above illustration.
2
9
Download from Www.Somanuals.com. All Manuals Search And Download.
LOCATION AND FUNCTION OF CONTROLS
SPECIFICATION
GENERAL
Power requirement...............................................................................................DC 13.8V.
Current consumption..............................................................................................7A MAX.
POWER OUTPUT....................................................................................................4 X 40W.
FM SECTION
Frequency range....................................................................87.5MHz -108.0MHz(EUROPE)
Frequency range..........................................................................87.5MHz -107.9MHz(USA)
Usable sensitivity..........................................................................................................3uV.
I.F Frequency........................................................................................................10.7MHz.
AM SECTION
Frequency range.......................................................................522KHz - 1620KHz(EUROPE)
Frequency range.............................................................................530KHz - 1710KHz(USA)
I.F Frequency..........................................................................................................450KHz
Usable Sensitivity........................................................................................................29dB
1. LOC BUTTON
Press it for distance reception when you are located at the stronger signal
location. Depress it for weak signal.
LINE - OUT [OPTION]
Output................................................................................300mV @ FM 10% THD POWER.
2. OPEN BUTTON
Press it to flip down the front panel then insert disc into disc slot or press
EJECT button to eject out disc or take away the front panel.
CD PLAYER
System........................................................................................compact disc audio system.
3.4. SEL( AUDIO MODE SELECT)/VOLUME +/- BUTTONS
Press SEL button to change the mode in the sequence of
Usable disc.......................................................................................compact disc/mp3 disc
No of quantization bits 1bit.
BAS
TRE
BAL
FAD
VOL
Signal format.............................................................................sampling frequency 44.1KHz.
Frequency characteristics...............................................................................5-40Hz < 5dB
10K-20KHz < 5dB.
1) The volume level can be adjusted at any time by pressing the audio level+ or
Button as select mode has been initially defaulted at volume mode.
2) The volume level is also obtained by stepping through the SEL button until
the function VOL is displayed and then press + or - button to adjust the
sound level.
Signal to noise radio..........................................................................................70dB [1KHz]
Number of channels..............................................................................................2 STEREO.
Chassis dimensions.......................................................................178[W] X 50[H] X 150[D].
3) Press and hold the + or - button to adjust the sound level.
BASS CONTROL
1) Press the SEL button to select the bass mode until BAS appears on the display.
2) Press + or - to adjust the bass effect.
TREBLE CONTROL
1) Press the SEL button to select the treble mode until TRE appears on the display.
2) Press + or - to adjust the treble effect.
BALANCE CONTROL
1) Press the SEL button to select the balance mode until BAL appears on the display.
8
3
Download from Www.Somanuals.com. All Manuals Search And Download.
2) Press the + button or - button to increase or decrease the sound level of
left or right speaker.
TROUBLE SHOOTING
FADER CONTROL
Go through the check list if you are in trouble during operation. If any
problem persist after going though the check list, consult your nearest
service dealer.
1) Press the SEL button to select the fader mode until FAD appears on the display.
2) Press the + button or - button to increase or decrease the sound level of
front or rear speaker.
5. LCD ( LIQUID CRYSTAL DISPLAY)
Symptom
No power
Cause
Solution
The car ignition is not on.
If the power supply is properly
connected to the car accessory
switch the ignition key to " ACC "
6. MUTE BUTTON
Press it to eliminate the sound immediately.
7. TUNE SEEK UP/DOWN, TRACK UP/DOWN BUTTONS
The fuse is blown
Replace the fuse
During RADIO mode, press UP or DN button to seek up or down for the
desired station. Press UP or DN button hold for more than 2 seconds to
scan up or down for the stronger station.
During CD mode, Press the UP or DN button to allow you to track forward
or backward. Press UP or DN button hold to skip forward or backward.
Presence of CD disc inside
the player
Remove the disc in the player
then put a new upward
Disc cannot
be loaded or
ejected
Inserting the disc in upside
down
Insert the compact disc with
the label facing upward
Compact disc is extremely
dirty or defective
Clean the disc or try to play a
new one
8. POWER BUTTON
Press the button to turn on or off the unit.
Temperature inside the
car is too high
Cool off until the ambient
temperature returns to normal
9. BAND/LOUD BUTTON
Press it to select your desired radio band and word which band is selected
will be displayed on LCD.
Condensation
Leave the player off for an
hour or so, then try again
Volume is in minimum
Adjust volume to a desired level
No sound
Press it hold for more than 2 seconds to enhance the bass sound effect.
Wiring is not properly
connected
Check wiring connection
10.CLOCK ADJUSTMENT BUTTON
The operation
keys do not
work
The built-in microcomputer
is not operating properly
due to noise
Press the RESET button
front panel is not properly
fix into its place
During frequency display, press it to change to clock display function.
Press the button for more than 2 seconds, until time flashes, then press
UP or DN button to adjust hour or minute.
The installation angle
is more than 30 degrees
Adjust the installation angle
to less than 30 degrees
Sound skips
11.MODE BUTTON
Press it repeatedly to select CDP, AUX and RADIO mode in sequence and
circulation.
The disc is extremely
dirty or defective
Clean the compact disc/try to
play a new one
12.DSP BUTTON
Press it to switch between 4 preset equalizer curves: FLAT, CLASSIC, POP
and ROCK, and the sound quality will be changed.
The radio does
not work
the radio
Insert the antenna cable firmly
select a station manually
The antenna cable is not
connected
the signals are too weak
station
13.PRESET STATION [ 1-6 ] /1PUS, 2SCN, 3RPT, 4SHF.
A]. To memorize the current frequency, press any one of the six preset
buttons hold for more than 2 seconds.
automatic
selection does
not work
B]. To recall the preset memory, press one of the preset button [1-6].
C). In CDP mode, press 1PUS button to pause CDP playing, press it again to
resume CDP playing.
4
7
Download from Www.Somanuals.com. All Manuals Search And Download.
D).In CDP mode, press 2SCN button to play the first 10 seconds part of
each song, press it again to stop scanning and retain playing the song
currently selected.
**KEY Assigned IN Searching mode
AS/PS
BAND
M1
Mode select
Enter
A, B, C, 1
E).In CDP mode, press 3RPT button to play the current track repeatedly.
Press it again or eject the disc to cancel this mode.
F).In CDP mode, press 4SHF button to play the track in random order.
M2
M3
M4
M5
D, E, F, 2
G, H, I, 3
J, K, L, 4
M, N, O, 5/10 TRACK DOWN
P, Q, R, 6
/10 TRACK UP
Press it again or
eject the disc to cancel this mode.
14. AS/PS BUTTON
In radio mode:
M6
DSP(SOUND)
MUTE
CLOCK
MODE
VOL SEL
VOL UP/DOWN
V, W, X, 8
When short pressing, the radio searches for each preset station.
When the field strength level is more than the threshold level of
stop level, the radio is holding at that preset number for few
secretary with releasing mute, and than searches again. In FM
band, FM 1,FM 2 and FM 3 is checked one at a time.
Y, Z, SPACE, 9
_, -, +, 0
S, T, U, 7
CHAR. SHIFT
CHAR. SEL(A, B~ 8,9,0)
When long pressing (more than 1 second), the radio searches from
the current frequency and checks the signal strength level until 1
cycle search is finished. And then 6 strongest stations are preset
to the corresponding preset number. The AS operation is
implemented in the each band of selected band. When the AS
operation is finished, the radio executes the preset scan.
M5 and M6 is assigned as 10 TRACK when normal play and
Searching File or directory
15.INFRARED REMOTE RECEIVING WINDOW
In CD mode,when pressed, it is activated as selecting each mode of
Digital Audio.
"Searching track directly"=>"Searching File or directory"
=>"Searching File Name"
1)."Searching track directly" in Digital Audio CD and Normal CD.
The unit searches the track selected by following key.
M1~M6,/RADIO SCAN1/DSP(SOUND)/MUTE /CLOCK(or MODE).
2)."Searching File or directory" by file directory structure in Digital
Audio CD.
The unit searches file or directory" in file directory structure by
"SEEK UP/DN" key.
The selected file can be played by pushing "BAND(ENTER)key.
3)."Searching File Name" in Digital Audio CD.
The unit searches files and directories which have the same character
which is inputted by the user. The unit shows these sorted files and
directories by "SEEK UP/DN" key.
The selected file can be played by pushing "BAND(ENTER) key.
5
6
Download from Www.Somanuals.com. All Manuals Search And Download.
|