OWNER’S MANUAL SUPPLEMENT
2001 PRO X 440
PN 9916166
IMPORTANT: This is a supplement to your owner’s manual. This information should remain with your owner’s manual
at all times.
Capacities and Dimensions
Engine and Cooling
Body Style
Edge
1
Engine Model Number
S44-44-PO-4C
2093
Rider Capacity
Alternator Output
Bore x Stroke (mm)
Displacement
Carburetor/Throttle Body
Carburetor Model
Main Jet
12V 280 W
66 x 64
438
Coolant Capacity (qts)
Chaincase Oil Capacity (oz.)
Dry Weight (Est.)
Fuel Tank capacity (Gallons)
Height (in.)
4
9
485
11.8
44
2 Mikuni
TMX34
350
Length (in.)
111
2.0
42.5
48
Pilot Jet
22.5
Oil Capacity (Quarts)
Ski Center Distance (in.)
Width (in.)
Jet Needle
6GL64-61-3
Q-8
Needle Jet
Cutaway
2.5
Brake Type
Hydraulic Disc
5/8 Piston
Air Screw
1.00
Drive Clutch Center Distance
Clutch Type
11.5
P--85
121
15
Idle RPM +/--200
Cooling
1600
Liquid
2
Track Length
Cylinders
Track Width
Ignition Timing
22_ @ 4500 ¦1.5
with pipe temper-
ature sensor un-
plugged
Drive Chain Length
Reverse Transmission
Sprocket Ratio
74
NA
22:43
Ignition Type
Oil Injection
Spark Plug
Digital CDI
Yes
Suspension
RN57YCC
Champ
Front Type
Edge Pro-X
Alum IFP / res
Edge Pro-X
STD
IFS Shock Type
Rear Type
Features
Electric Fuel Gauge
Electric Start
NA
Front Torque Arm Limiter
Rear Torque Arm Limiter
Front Track Shock
Rear Track Shock
Not Available
Standard
NA
Optional
Low Oil Light
Arvin IFP/Res
Arvin IFP/Res
Parking Brake
Speedometer
Standard (not
installed)
Tachometer
Wear Strips
Hood Color
Standard
Coolers
Indy Red
Download from Www.Somanuals.com. All Manuals Search And Download.
2001 PRO X 440 / XCF SP
SPEEDOMETER KIT INSTALLATION INSTRUCTIONS
-
Remove plenum.
Route through hole in plenum
- Drill 4.5N hole in instrument housing 5.9N fromthe
tachometer center to the center of the new hole.
5.9N
l
-
Relocate tachometer to right side.
-
Install speedometer into left hole, placing the
l
cushion between the speedometer and the hood.
Route Cable through left
hinge hole at this point.
Install “J” retainer (PN 7080963)
using rivet (PN 7621435)
Install three “U” Clips
-
Route speedometer cable through plenum
- Route speedometer cable as illustrated. Tighten cableends.
-
-
Install plenum
Using cable ties provided (3) secure cable in places
illustrated by a l.
-
Lay speedometer cable in the channel of the nosepan.
Attach with three clips as snown. Use the “J” clip and rivet to
secure the wire to the nosepan channel where indicated.
Dark line indicates speedometer cable routing.
PN 9916166 Rev 01 8/00
Printed in U.S.A.
Download from Www.Somanuals.com. All Manuals Search And Download.
Download from Www.Somanuals.com. All Manuals Search And Download.
|