Onkyo Home Theater System Y1105 1 User Manual

E
n
5.1ch Home Cinema Package  
HTP-648/SKS-HT648  
Front speaker (SKF-648)  
Center speaker (SKC-648)  
Surround speaker (SKR-648)  
Subwoofer (SKW-501E)  
(Green)  
Speaker cable 3.0 m  
RCA cable 3.0 m  
4 floor pads  
(White)  
Speaker cables 3.5 m  
(Red)  
(Blue)  
(Gray)  
Front speakers  
Surround speakers  
Speaker cables 8.0 m  
Center speaker  
Subwoofer  
Front  
12 rubber stoppers* (For Front/Surround speakers)  
STANDBY/ON indicator  
Red: Subwoofer in standby mode  
4 rubber stoppers*  
Blue: Subwoofer on  
*
Configuration of the rubber stoppers may be different from the figure, such as being 2 sheets instead of 1 sheet, but the total number will be same.  
With the Auto Standby function, the SKW-501E  
automatically turns on when an input signal is  
detected in Standby mode. When there’s no input  
signal for a while, the SKW-501E automatically  
enters Standby mode.  
Rear  
POWER switch  
Press this switch to the ON position to turn on the  
power. Press it to the OFF position to turn off the  
power.  
SKF-648  
SKR-648  
SKC-648  
Speaker terminals  
Speaker terminals  
OUTPUT LEVEL control  
This control is used to adjust the volume of the  
subwoofer.  
Using the Rubber Stoppers for a More Stable Platform  
LINE INPUT  
We recommend using the supplied rubber stoppers to achieve  
To AC outlet  
Rubber stoppers  
This RCA input should be connected to the  
subwoofer pre out on your AV receiver with  
supplied RCA cable.  
the best possible sound from your speakers.  
The rubber stoppers prevent the speakers from moving,  
providing a more stable platform.  
Rubber stoppers  
Bottom of the  
SKF-648  
SKR-648  
Note  
• The Auto Standby function turns the subwoofer on when the input signal exceeds a  
certain level. If the Auto Standby function does not work reliably, try slightly increasing  
or decreasing the subwoofer output level on your receiver.  
• If the Standby/On indicator lights (both red and blue LEDs) several seconds or minutes  
after the sound output stopped, this means that the amp protection circuit has been acti-  
vated. In this case, set the OUTPUT LEVEL control to the center position, and discon-  
nect the power cord from the AC outlet. Wait at least 10 seconds, and then reconnect the  
power cord. If that doesn’t solve the issue, contact your Onkyo dealer.  
Bottom of the  
SKC-648  
Attaching and detaching the speaker grilles  
Setting the Subwoofer Level  
The front, center and surround speakers have detachable grilles.  
See the right illustrations to attach or detach them.  
Removal  
Replacement  
To set the level of the subwoofer, use the OUTPUT LEVEL control.  
Set it so that bass sounds are evenly balanced with the treble sounds  
from the other speakers. Because our ears are less sensitive to very  
low bass sounds, there’s a temptation to set the level of the  
subwoofer too high. As a rule of thumb, set the subwoofer level to  
what you think is the optimal level, and then back it off slightly.  
Using the Floor Pads for Subwoofer  
If the subwoofer is placed on a hard floor  
(wood, vinyl, tile, etc.) and playback is very  
loud, the subwoofer’s feet may damage the  
flooring. To prevent this, place the supplied  
pads underneath the subwoofer’s feet. The pads  
also provide a stable base for the subwoofer.  
Pad  
Enjoying Home Cinema  
Specifications  
Powered Subwoofer (SKW-501E)  
Center Speaker (SKC-648)  
The Home Cinema means that you can enjoy surround sound with a real sense of movement in your own home — just like being in  
a movie theater or concert hall.  
Type  
Bass-Reflex  
Type  
2 Way Closed Box  
Input sensitivity/impedance 410 mV / 20 k  
Impedance  
6 Ω  
Rated output Power (IEC)  
80 watts minimum continuous power,  
Maximum input power  
Sensitivity  
Frequency response  
Crossover frequency  
Cabinet capacity  
Dimensions (W × H × D)  
130 W  
Front left and right speakers (SKF-648)  
4 ohms, driven at 100 Hz with a  
maximum total harmonic distortion of  
1 %  
82 dB/W/m  
70 Hz to 50 kHz  
7 kHz  
They should be positioned facing the listener at about ear level,  
and equally spaced from the TV. Angle them inward slightly so as  
to create a triangle, with the listener at the apex.  
Surround left and right speakers (SKR-648)  
Position them at the sides of the listener, or  
slightly behind, about 60 to 100 cm above ear  
level. Ideally they should be equally spaced  
from the listener.  
Frequency response  
Cabinet capacity  
Dimensions (W × H × D)  
27 Hz to 150 Hz  
24.5 L  
1.3 L  
277 mm × 110 mm × 110 mm  
(incl. grille and projection)  
230 mm × 425 mm × 412 mm  
(incl. grille and projection)  
Center speaker (SKC-648)  
Weight  
Drivers unit  
1.7 kg  
Position it close to your TV (prefer-  
ably on top) facing forward at about  
ear level, or at the same height as the  
front left and right speakers.  
Weight  
Drivers unit  
Power supply  
9.1 kg  
8 cm Cone Woofer × 2  
20 cm Cone Woofer × 1  
(HTP-648) AC 230V, 50Hz  
(SKS-HT648) AC 220-240V, 50/60 Hz  
105 W  
2.5 cm Balanced Dome Tweeter × 1  
Spring type color coded  
Detachable  
Terminal  
Grille  
Insert nut  
Other  
Power consumption  
Other  
Available  
Auto Standby function  
Non-magnetic shielding  
Magnetic shielding  
Surround Speakers (SKR-648)  
Front Speakers (SKF-648)  
Type  
Full Range Closed Box  
Type  
2 Way Closed Box  
Impedance  
Maximum input power  
Sensitivity  
Frequency response  
Cabinet capacity  
Dimensions (W × H × D)  
6 Ω  
130 W  
Impedance  
Maximum input power  
Sensitivity  
Frequency response  
Crossover frequency  
Cabinet capacity  
Dimensions (W × H × D)  
6 Ω  
130 W  
80 dB/W/m  
80 Hz to 20 kHz  
0.9 L  
79 dB/W/m  
70 Hz to 50 kHz  
7 kHz  
Corner  
position  
Subwoofer (SKW-501E)  
102 mm × 170 mm × 105 mm  
(incl. grille and projection)  
0.9 L  
The subwoofer handles the bass sounds of the LFE (Low-Frequency Effects)  
channel and bass from the satellite speakers when a crossover is specified.  
The volume and quality of the bass output from your subwoofer will depend  
on its position, the shape of your listening room, and your listening position.  
In general, a good bass sound can be obtained by installing the subwoofer in  
a front corner, or at one-third the way along the front wall, as shown.  
102 mm × 170 mm × 105 mm  
(incl. grille and projection)  
1/3 of wall  
position  
Weight  
0.9 kg  
Drivers unit  
Terminal  
Grille  
Insert nut  
Other  
8 cm Cone × 1  
Spring type color coded  
Detachable  
Weight  
Drivers unit  
1.0 kg  
8 cm Cone Woofer × 1  
2.5 cm Balanced Dome Tweeter × 1  
Terminal  
Grille  
Spring type color coded  
Detachable  
Available  
Magnetic shielding  
Insert nut  
Other  
Available  
Connecting the Speakers  
Specifications and appearance are subject to change without  
prior notice.  
Magnetic shielding  
Note  
Front right  
speaker  
Front left  
speaker  
Powered  
subwoofer  
For non-magnetic shielded speakers:  
Try moving the speakers away from your TV or monitor. If discoloration should occur, turn off your TV or monitor, wait 15 to 30  
minutes, and then turn it back on again. This normally activates the degaussing function, which neutralizes the magnetic field,  
thereby removing any discoloration effects.  
Center speaker  
Red  
White  
Green  
2-1, Nisshin-cho, Neyagawa-shi, OSAKA 572-8540, JAPAN  
Tel: 072-831-8023 Fax: 072-831-8163  
Speaker Connection  
Precautions  
Read the following before connecting your  
speakers:  
18 Park Way, Upper Saddle River, N.J. 07458, U.S.A.  
Tel: 800-229-1687, 201-785-2600 Fax: 201-785-2650  
• Turn off your receiver before making any  
connections.  
• Pay close attention to speaker  
wiring polarity. Connect  
Liegnitzerstrasse 6, 82194 Groebenzell, GERMANY  
Tel: +49-8142-4401-0 Fax: +49-8142-4401-555  
*
Using the supplied RCA cable,  
connect the subwoofer’s LINE  
INPUT to your AV receiver’s  
SUBWOOFER PRE OUT jack.  
Blue  
Gray  
positive (+) terminals to only  
positive (+) terminals, and  
negative (–) terminals to only negative (–)  
terminals. If the speakers are wired  
incorrectly, the sound will be out of phase  
and will sound unnatural.  
• Be careful not to short the positive and  
negative wires. Doing so may damage  
your amp.  
The Coach House 81A High Street, Marlow, Buckinghamshire, SL7 1AB, UK  
Tel: +44-(0)1628-473-350 Fax: +44-(0)1628-401-700  
Unit 1 & 12, 9/F, Ever Gain Plaza Tower 1, 88, Container Port Road, Kwai Chung,  
N.T., Hong Kong. Tel: 852-2429-3118 Fax: 852-2428-9039  
Y1105-1  
Surround right  
speaker  
Surround left  
speaker  
1301, 555 Tower, No.555 West NanJin Road, Jin an, Shanghai,  
China 200041, Tel: 86-21-52131366 Fax: 86-21-52130396  
SN 29400781  
(C) Copyright 2011 ONKYO SOUND & VISION CORPORATION Japan. All rights reserved.  
* 2 9 4 0 0 7 8 1 *  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Miele Refrigerator KDN 12623 S 1 User Manual
Milwaukee Recording Equipment M18 User Manual
Multiplex Technology DVR 4CH User Manual
Nilfisk ALTO Vacuum Cleaner ATTIX 30 PC XC User Manual
NuTone Vacuum Cleaner CI395V User Manual
Nuvo Stereo Amplifier NV E6DMS User Manual
Oster Kitchen Grill 4766 User Manual
Palsonic Microwave Oven PMO 755 User Manual
Panasonic Flat Panel Television BUS4803 User Manual
Panasonic Network Card 2SC6036 User Manual