OEM Systems Speaker AP 602 User Manual

For 5-1/4", 6-1/2" & 8" In-Wall  
2-Piece Baffle & Frame  
Congratulations! You have purchased a high quality  
SPEAKER PLACEMENT  
stereo loudspeaker. When matched to comparable  
electronic equipment, expect years of quality high  
fidelity sound. We are constantly striving to provide  
the very best technology has to offer.  
Placement of Wall Mounted Speakers should be  
carefully considered. Ideally, the speakers should  
be located where they will provide the best possible  
sound and ease of installation. It is beyond the  
scope of this publication to discuss all of the various  
aspects of speaker placement. Please contact a  
professional for assistance if you are uncomfortable  
with the planning or installation process.  
The following manual is designed to give you,  
the installer or owner, basic information as to  
the speaker’s installation and operation. It is  
beyond the scope of this manual to go into all the  
details that must be taken into consideration in a  
sophisticated high fidelity system.  
Note: Though these speakers are referred to as “wall  
mount,” they are also suitable for installations in  
ceilings and custom cabinetry.  
If you have any questions regarding this speaker  
which are not answered by this manual, contact your  
local dealer for assistance. For the most current  
information please visit www.oemsystems.com.  
WIRING  
To achieve maximum performance from your new  
speakers we strongly suggest the use of good quality  
stereo cable. There are many good brands available.  
We recommend that the cable be at least 16 gauge  
or larger for runs of over 50 feet and that the wire  
be double insulated. This is often referred to as  
“jacketed” speaker cable. “Zip cord,” which is single  
insulated and is often made with clear insulation,  
should be avoided as it is not as durable. It is  
important when installing the wiring and speakers  
that you adhere to all local codes and regulations.  
We suggest that a professional be consulted in  
order to maximize your system’s performance. The  
following, however, are some useful suggestions.  
GENERAL DESCRIPTION  
These two-way speakers have specially designed  
woofers with linear long throw butyl rubber  
surrounds for long life and superior damping. Dome  
tweeters are utilized for excellent high frequency  
dispersion throughout your entire listening  
environment. Two piece baffle/frame assemblies  
allow for custom painting of the frames and grilles  
without the need to mask the speakers.  
SHIPPING DAMAGE  
Each speaker is thoroughly tested before it leaves  
the factory. However, in shipment, accidents may  
occur. Please inspect your speakers carefully  
when you receive them to make sure there is no  
damage. If there is, please notify your dealer, or  
supplier immediately for assistance. If you received  
your speakers by public transportation, report the  
damage at once to the shipping company.  
Try to keep the wire length to a minimum. However,  
allow about 2½ feet of free wire at the speaker cut-  
out and sufficient length at the electronics to aid in  
the ease of installation. Adding extra wire later is  
tedious and time consuming.  
Avoid bundling speaker cables parallel to electrical  
cables for extended lengths. Though the impedance  
is low and the likelihood of interference low, this  
AMPLIFIER OPERATION  
These speakers will perform well with amplifiers  
from 5 to 125 Watts RMS. However, damage to  
the speakers can be done by amplifiers of nearly  
any power rating if the amplifier is overdriven  
into clipping. “Amplifier clipping” is a phrase  
used to describe a condition when, because of  
the volume demand, an amplifier is being asked  
for more power than it can give. Clipping causes  
distortion of the audio signal. If you should hear  
an unusual amount of distortion at high listening  
levels then consider reducing the volume.  
DAMAGE DONE TO A SPEAKER BY CLIPPING IS  
NOT COVERED UNDER THE WARRANTY.  
Overall (W x H)  
9-1/16" x 12-3/4"  
10-1/2" x 14-1/2"  
Cut-Out (W x H x Depth)  
8" x 11-3/4" x 3-1/4"  
9" x 13" x 3-1/4"  
AP-602  
AP-802  
SE-893KE  
SE-891E  
10-1/2" x 14-1/2"  
10-1/2" x 14-1/2"  
9" x 13" x 3-1/4"  
9" x 13" x 2-15/16"  
PS-602  
9-1/16" x 12-3/4"  
8" x 11-3/4" x 3-1/4"  
Rev. A  
page 1 of 2  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Miele Washer W 5780 User Manual
Milwaukee Drill 1001 1 User Manual
NEC Projection Television GT2000 GT2000R User Manual
NHT Home Theater System HDP 1 User Manual
North Star GPS Receiver GM9571M User Manual
Oki Printer RT322POS User Manual
Optimus Stereo Receiver 31 3042 User Manual
Oregon Scientific Portable Radio WR602 User Manual
Orion Car Audio Car Amplifier HCCA10002 User Manual
Palsonic CRT Television 5169P User Manual