NuTone Patio Heater 9315T User Manual

INSTALLATION INSTRUCTIONS  
READ & SAVE THESE INSTRUCTIONS!  
Wall Heaters  
MODELS: 9315T, 9315XT  
SAFETY INSTRUCTIONS  
Carefully read all instructions and product labels before  
beginning installation. Only mount the heater in a vertical  
position. Mount the heater by setting the unit on the sub-plate  
on the wall. Do not mount the heater over a bathtub or in a  
shower stall enclosure. When mounted, the heater should  
not be closer than 6" to an adjacent wall. Do not block the  
wall heater – i.e., by mounting under a towel rack, behind a  
door, etc.  
MOUNTING GUIDE  
THERMOSTAT  
MOUNTING BRACKET  
ELECTRICAL SPECIFICATIONS  
ELEMENT  
TOTAL  
VOLTS,  
60Hz  
MODEL  
9315T  
WATTS  
WATTS  
750/1500  
750/1500  
800/1550  
800/1550  
120  
240  
9315XT  
NOTE: The heater is wired (shipped from the factory) for  
1500 watts. The wattage may be reduced to 750 watts by  
disconnecting the red wire (on 240 volt unit) or the black  
wire (on 120 volt unit) as illustrated in Figures 4 and 5.  
SUB PLATE  
TYPE WALL  
CONSTRUCTION  
FIGURE 1  
UNIT DIMENSIONS  
Housing: 878" high x 1112" wide x 338" deep.  
Grille: 938" high x 12" wide x 58" deep.  
Wall Cutout: 814" L x 11" W.  
MOUNTING THE HOUSING  
(New Construction)  
Refer to Figure 1  
MOUNTING GUIDE  
1. Choose heater location. Make sure the heater will not be  
mounted closer than 6" from a vertical surface.  
2. Set the mounting guides (2) for desired wall thickness.  
NOTE: Plaster flange must be flush with finished wall.  
Place the mounting guides against the wall stud. When  
the finished wall is installed, the wall surface will fit  
between the mounting guide bracket and the plaster  
flange.  
3. Using nails or screws, mount the feet of the unit to the  
sub-plate stud. The flange must be flush to the finished  
plaster line.  
4. Run wiring from circuit breaker or fuse box to wall switch  
(not provided) then to heater location.  
5. Install box connector into wiring entrance hole in housing's  
junction box.  
6. Pull wiring through entrance hole and secure cable to box  
connector. Allow 6" of wiring to make connections.  
7. Finished wall opening should be 814" high x 11" wide.  
FIGURE 2  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Miller Electric Welder 150STH User Manual
Milwaukee Saw 0719 20 User Manual
Musical Fidelity Computer Hardware V LINK192 User Manual
Navigon GPS Receiver P9611 User Manual
NEC Flat Panel Television P702 User Manual
NEC Home Security System SMB8000 User Manual
NETGEAR Network Router XE103 User Manual
NordicTrack Home Gym NTTL09510 User Manual
Old Town Canoe Co Boating Equipment 0113322406 User Manual
Oregon Scientific Weather Radio BAR636A User Manual