INSTALLATION INSTRUCTIONS FOR PART 99-7606
APPLICATIONS
Nissan Titan
(With Dual Zone Climate Controls) 2006-07
Nissan Pathfinder Armada 2006-07
99-7606
KIT FEATURES
• DIN Radio Provision with pocket
• ISO Radio Unit Provision with pocket
• Double DIN Radio Provision
• Stacked ISO Head Units Provision
KIT COMPONENTS
A) Radio Housing • B) ISO Brackets • C) ISO Trim Plate • D) Double DIN Brackets • E) Double DIN Trim Plate
• F) Pocket • G) (6) Panel Clips • H ) Two Sided Tape (Not Shown)
D
C
B
A
E
F
G
TOOLS REQUIRED:
Torx T-10 Driver • Small Flat Blade Screwdriver • Phillips Screwdriver
Or Panel Removal Tool
1-800-221-0932
© COPYRIGHT 2004-2008 METRA ELECTRONICS CORPORATION
Download from Www.Somanuals.com. All Manuals Search And Download.
DASH DISASSEMBLY
99-7606
NISSAN TITAN 2006-07
NISSAN PATHFINDER ARMADA 2006-07
Disconnect the negative battery
terminal to prevent an accidental
short circuit.
1
A
2
3
4
Unclip and remove entire panel
including radio and climate controls.
(Figure A)
Remove (4) Phillips screws to
remove radio from sub-dash.
(Figure B)
B
Unsnap and remove the outer trim
rings around a/c control knobs.
(Figure C)
NOTE: The small round Airbag stick-
er also needs to be removed from
the factory panel and placed onto
the 99-7606 radio housing panel.
(A round piece of double-sided tape
is provided in case the factory stick-
er is not strong enough.) (Figure C)
C
Remove (4) T-10 Torx screws from
the a/c controls to remove from the
factory radio trim panel. (Figure D)
5
Continued on next page.
OFF
1
Download from Www.Somanuals.com. All Manuals Search And Download.
DASH DISASSEMBLY
99-7606
NISSAN TITAN 2006-07
NISSAN PATHFINDER ARMADA 2006-07
Unclip and remove the Hazard Light
switch assembly. (Figure D)
6
7
D
INSIDE VIEW - RADIO TRIM PANEL BACK
Remove (2) T10 Torx screws from
the passenger air bag off light
assembly and remove. (Figure D)
Note: The small round sticker
also needs to be removed from
the factory panel and placed
onto the 99-7606 radio housing.
1
3
4
A/C CONTROL PANEL
Continue to kit assembly.
PASSENGER AIR BAG LIGHT
2
1
2
CLIP
HAZARD SWITCH
T-10 TORX
SCREW
T-10 TORX
SCREW
2
Download from Www.Somanuals.com. All Manuals Search And Download.
PRE-KIT ASSEMBLY
99-7606
NISSAN TITAN 2006-07
NISSAN PATHFINDER ARMADA 2006-07
Attach the a/c control to the 99-7606
1
A
Radio Housing using the factory
hardware removed in the dash dis-
assembly. (Figure A)
Snap the outer trim rings onto the
a/c control knobs. (Figure B)
2
3
0
1
2
3
4
0
R
1
2
3
4
Attach the passenger air bag off light
assembly to the 99-7606 Radio
Housing using the factory hardware
removed in the dash disassembly.
Also, apply to air bag button the
B
small round airbag sticker previously
removed in Step 4 dash disassembly.
(Figure C)
Snap the hazard light switch into the
99-7606 Radio Housing. (Figure D)
4
5
0
1
2
3
4
0
R
1
2
3
4
Attach the (6) panel clips to the 99-
7606 radio housing panel using the
factory radio panel as a reference for
clip positioning.
Continue to kit assembly.
C
D
0
1
0
2
3
4
1
2
3
4
0
R
1
2
3
4
0
R
1
2
3
4
3
Download from Www.Somanuals.com. All Manuals Search And Download.
KIT ASSEMBLY
99-7606
DIN RADIO PROVISION WITH POCKET
Slide the DIN cage into the Radio
1
A
Housing and secure by bending
the metal locking tabs down.
(Figure A)
Slide the aftermarket radio unit
into the cage and secure.
(Figure B)
2
3
Snap the pocket into the radio
housing. (Figure C)
B
Continue to final assembly.
C
4
Download from Www.Somanuals.com. All Manuals Search And Download.
KIT ASSEMBLY
99-7606
ISO RADIO PROVISION WITH POCKET
Mount the ISO Brackets to the
radio with the screws supplied
with the radio. (Figure A)
1
2
A
Slide the radio into the radio
opening until the side clips
engage. (Figure B)
Snap the Trim plate into the Radio
Housing. (Figure C)
3
4
B
Snap the pocket into the radio hous-
ing. (Figure D)
Continue to final assembly.
C
D
5
Download from Www.Somanuals.com. All Manuals Search And Download.
KIT ASSEMBLY
99-7606
DOUBLE DIN RADIO UNIT PROVISION
Cut and remove center divider
from radio housing. (Figure A)
1
2
A
Snap the Double DIN brackets to
the inside edge of the radio hous-
ing. (Figure B)
Slide the Double DIN radio into the
Double DIN bracket/radio housing
assembly and secure the radio to the
kit using the screws supplied with
3
4
the head unit. (Figure C)
B
Snap the Double DIN trim plate
onto the housing/radio assembly.
(Figure C)
Continue to final assembly.
C
6
Download from Www.Somanuals.com. All Manuals Search And Download.
KIT ASSEMBLY
99-7606
STACKED ISO HEAD UNITS PROVISION
Cut and remove center divider
from radio housing. (Figure A)
1
2
A
Snap the Double DIN brackets to
the inside edge of the radio hous-
ing. (Figure B)
Slide the stacked ISO units into the
Double DIN bracket/radio housing
assembly and secure the units to the
kit using the screws supplied with
3
4
the head units. (Figure C)
B
Snap the Double DIN trim-plate onto
the housing/radio assembly.
(Figure C)
Continue to final assembly.
C
7
Download from Www.Somanuals.com. All Manuals Search And Download.
FINAL ASSEMBLY
99-7606
FINAL ASSEMBLY
A
B
A)
B)
C)
D)
Strip wire ends back 1/2"
Twist ends together
Solder
Tape
C
D
Locate the factory wiring harness in the dash. Metra recommends using the
proper mating adapter and making connections as shown. (Isolate and individually
tape off the ends of any unused wires to prevent electrical short circuit.)
1
Re-connect the negative battery terminal and test the unit for proper operation.
Reassemble in reverse order of disassembly.
2
3
FINAL WIRING CONNECTIONS
Make wiring connections using the EIA color code chart shown below and the instructions included with the head
unit. Metra recommends making connections as shown below; Strip, Splice, Solder, Tape. Isolate and individually
tape off ends of any unused wires to prevent electrical short circuit.
METRA / EIA WIRING CODE
12V Ignition / Acc . . . Red
Right Front (+) . . . . . Gray
12V Batt / Memory . . Yellow
Ground . . . . . . . . . . . Black*
Power Antenna . . . . . Blue
Right Front (-). . . . . . Gray/ Black
Left Front (+) . . . . . . White
Left Front (-). . . . . . . White / Black
Right Rear (+). . . . . . Violet
Amp Turn-On . . . . . . Blue / White
Amp Ground . . . . . . . Black / White
Illumination. . . . . . . . Orange
Dimmer . . . . . . . . . . Orange / White
Right Rear (-) . . . . . . Violet / Black
Left Rear (+). . . . . . . Green
Left Rear (-) . . . . . . . Green / Black
*NOTE: When a Black wire is not present, ground radio to vehicle chassis.
All colors may not be present on all leads due to manufacturer’s specifications.
8
Download from Www.Somanuals.com. All Manuals Search And Download.
99-7606
NOTES
9
Download from Www.Somanuals.com. All Manuals Search And Download.
99-7606 INSTRUCTIONS
1-800-221-0932
REV. 02/22/08
© COPYRIGHT 2004-2008 METRA ELECTRONICS CORPORATION
INST99-7606
Download from Www.Somanuals.com. All Manuals Search And Download.
|