Model: 308-1410gr
Instruction Manual
DC: 072915
WIRELESS THERMOMETER
FRONT
VIEW
SENSOR
TX-141-Bv2
LED
TX
Sensor
Sensor Battery
Battery Cover
Compartment
2 “AA”
Buttons
BACK VIEW
Battery
Compartment
Battery
Cover
2 “AA”
GET STARTED
Step 1: Insert 2 new AA batteries (not included) into the station.
Observe the correct polarity.
Step 2: Insert 2 new AA batteries (not included) into the TX141-BV2 sensor. Observe the
correct polarity. The red LED will flash when transmitting.
Step 3: After 15 minutes place the sensor outside in a shaded location.
Note: If the outdoor temperature is not displayed after 3 minutes, hold the MIN/MAX/+
button for 3 seconds to search for the sensor. Press the TX button on the sensor to send a
signal.
Page | 1
Download from Www.Somanuals.com. All Manuals Search And Download.
SPECIFICATIONS
+32°F to +122°F (0°C to 50°C)
Indoor:
Temperature Range:
Interval:
About every 30 seconds
Outdoor:
Temperature Range:
Alkaline Batteries:
Lithium Batteries:
-40°F to 140°F (-40°C to 60°C)
-20°F to 140°F (-28.8°C to 60°C)
-40°F to 140°F (-40°C to 60°C)
Temperatures below - 20°F (-28.8°C)
require Lithium batteries in the outdoor
sensor.
NOTE:
Over 300 ft. (91 meters)
RF 433MHz (open air)
Distance:
Interval:
About every 50 seconds
Power:
Wireless Thermometer
TX141-BV2 Sensor:
Battery Life:
2-AA, IEC, LR6 batteries (not included)
2-AA, IEC, LR6 batteries (not included)
Battery life is over 24 months when
using reputable battery brands for both
Alkaline and Lithium batteries
Wireless Thermometer
Battery life is over 24 months when
using reputable battery brands for both
Alkaline and Lithium batteries
TX141-BV2 Sensor:
Dimensions:
3”L x 1.36”W x 4.17”H
(76 x 34 x 106 mm)
1.57" x 0.79" x 5.12"
(40 x 20 x 130mm)
Wireless Thermometer:
TX141-BV2 Sensor:
CARE AND MAINTENANCE
Do not mix old and new batteries
Do not mix Alkaline, Standard, Lithium or Rechargeable Batteries
Always purchase the correct size and grade of battery most suitable for the
intended use.
Replace all batteries of a set at the same time.
Clean the battery contacts and also those of the device prior to battery
installation.
Ensure the batteries are installed correctly with regard to polarity (+and -).
Remove batteries from equipment with is not to be used for an extended
period of time.
Remove used batteries promptly.
Page | 3
Download from Www.Somanuals.com. All Manuals Search And Download.
WARRANTY AND SUPPORT INFORMATION
La Crosse Technology, Ltd. provides a 1-year limited time warranty (from date of purchase) on
this product relating to manufacturing defects in materials & workmanship.
View full warranty details online at:
For warranty work, technical support or other information contact:
La Crosse Technology, Ltd
2830 South 26th St
La Crosse, WI 54601
Contact Support:
Online Product Support:
1-608-782-1610
Product Registration:
Protected under U.S. Patents:
5,978,738 | 6,076,044 | RE43903
FCC STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
This device must not be co-located or operating in conjunction with any other antenna or
transmitter.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
Caution!
The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications could void the user
authority to operate the equipment.
All rights reserved. This manual may not be reproduced in any form, even in part, or
duplicated or processed using electronic, mechanical or chemical process without the
written permission of the publisher.
This booklet may contain errors or misprints. The information it contains is regularly
checked and corrections are included in subsequent editions. We disclaim any
responsibility for any technical error or printing error, or their consequences.
All trademarks and patents are recognized.
Page | 4
Download from Www.Somanuals.com. All Manuals Search And Download.
|